North Texas State University
Design and Construction of Auxiliary Equipment Used to Convert a Standard Woodworking Shaper for Use as a Finger-Jointing Machine
Abstract
dc:descriptionThe problem was to design and construct the necessary equipment to cut and fasten short stock end to end using finger-joints. The study was divided into five chapters: I contained the introduction to the problem; II was concerned with the design and construction of the equipment; III detailed the operation of the equipment; IV contained the presentation of the data; and V covered the summary and findings. The study concluded that the equipment could be constructed inexpensively, and would perform a useful service. Also, a student using waste wood salvaged through use of this equipment could expect a smaller bill for materials than if he purchased new wood.
Degree
thesis:*- Grantor dc:publisher
- North Texas State University
- Year dc:date
- 1976
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Kuenstler, David R.
- Contributors dc:contributor
-
- Koonce, Tommy R.
- Cox, Kenneth
Subjects
dc:subject × 6Rights
dc:rights- Statement dc:rights
-
- Public
- Kuenstler, David R.
- Copyright
- Copyright is held by the author, unless otherwise noted. All rights reserved.
- Language dc:language
- English
Identifiers
dc:identifier.*- Identifier
-
local-cont-no: 1002773050-Kuenstler
call-no: 379 N81 no. 5225
untcat: b1136677
oclc: 2678647
ark: ark:/67531/metadc504312