Institutional Repository of Vilnius University
Biologiškai suderinamų skaidrių plastikų graviravimas ir poliravimas femtosekundiniais impulsais /
Abstract
dc:descriptionThe subject of this study is plastic – hidrophilic acrylic, which is commonly used in the manufacturing of intraocular lenses. Nowadays all intraocular lenses are manufacured by mechnaical means. Even though they are suitable for mass production, but in terms of custom lenses these technologies lack in efficiency. Mechanical tools eventually wear down, slow porcess, a need for huge equipment pool and high production cost makes this technology unattractive in 21 centuary. As an alternative to mechanical lathe, it would be possible to performe the whole lens manufacturing process using only one laser system. Thus, the main aim of this study is to evaluate the results of plastic - hydrophilic acrylic engraving and polishing using femtosecond laser pulses. Goals to reach this aim are: review the literature in terms of intraocular lens manufacturing and polishing, analyze the results of conducted experiment and compare them with works of other scientists, make suggestions on how to improve the experiment. While machining plastic, in the beginning our samples were engraved 0,5 mm deep using femtosecond laser pulses. After analyzing results, conclusion was made, that using average laser power – 30 W, it is possible to achieve 0,84 〖mm〗^3/s material removal rate while engraving plastic hidrophilic acrylic. Later engraved surface was polised using bursts of femtosecond laser pulses. It was seen that using bursts of femtosecond laser pulses it is possible to achive smooth (Sa = 88nm) and transparent surfaces. Using this regime it is possible to enhance the surface roughness by a factor of 10 compared with conventional femtosecond pulses. After comparing our results with the works of other scientists some ideas to seek better results in the future were drawn. It would be of a huge interest to try using shorter wavelength laser radiaton for engraving as well as for polishing, also it would be interesting to try using less power during polishing while increasing the number of scans for each procedure. Eventaully, we compared polishing capabilities of intraocular lenses using laser and mechanical means. Mechanically polished lenses still excel at surface roughness (mech. - Ra = 1,5 nm, laser - Ra = 80 nm), but the process takes much longer than using laser system (mech. from 24 to 48 hours, laser – 10 s).
Degree
thesis:*- Grantor dc:publisher
- Institutional Repository of Vilnius University
- Year dc:date
- 2020
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Kažukauskas, Evaldas,
- Contributors dc:contributor
-
- Sirutkaitis, Valdas
Rights
dc:rights- Statement dc:rights
-
- info:eu-repo/semantics/openAccess
- Language dc:language
- lit
Identifiers
dc:identifier.*- Repository record dc:identifier
- https://repository.vu.lt/VU:ELABAETD107237538&prefLang=en_US