Back to search

Institutional Repository of Vilnius University

5 GHz dažnio planarinių antenų modeliavimas ir tyrimas /

Abstract

dc:description

Nowadays people cannot imagine their life without a fast wireless internet. Back in 1997 when IEEE 802.11 protocol was available for a bigger section of people, the stream data rate was approximately 2 Mbit/s. Back in those days, wireless local area network (WLAN) worked only on 2.4 GHz frequency range, but many other electronic devices used the same frequency range, so there was a problem of wave interference. Since 2009, 5 GHz frequency range was included in IEEE 802.11 standard and nowadays most routers have both 2.4 GHz and 5 GHz frequencies. Antennas play a major role in wireless local area network (Wi-Fi) systems. Antennas are installed in our routers, which send signals to nearby devices that receive them, because of installed small antennas. The aim of this paper is to design 5 GHz Wi-Fi planar antennas with one and four patches. Then by using designed models create real antennas and test their fundamental parameters (standing wave ratio, S11 parameter, gain and pattern) in Vilnius University Faculty of Physics Anechoic chamber. In this paper author designed two antenna models with “HFSS” software and performed simulations. Then using UV lithography and milling technologies four antenna samples were made to find out whether or not manufacturing technology has an impact in antenna’s fundamental parameters. In the final stage, we measured standing wave ratio and S11 parameter with R&S-ZVA40 vector network analyzer, gain and pattern was measured in anechoic chamber. Measured data was compared with theoretical data, which was calculated with “HFSS” software. Results and conclusions 1. It is very important to match impedance between paths and radiating patches. One method is to use inset feeding. S11 parameter has improved from -5,48 dB to -26,75 dB. 2. Common problem of planar antennas – low gain level. This problem was fixed by increasing the number of patches on antennas. In this paper, we compared gain between one and four patch planar antennas, gain has increased from 4,58 dBi to 8,45 dBi. 3. Compared data between theoretically calculated with “HFSS” software and measured in anechoic chamber has shown that difference in gain is approximately ~0,37 dBi. Measured standing wave ratio and S11 parameter has a bigger mismatch with theoretical data, because of its instability during measurements and dependence to material’s thickness and relative permittivity errors (0,1 mm thickness inaccuracy can change S11 parameter by 6,11 dB). 4. Different manufacturing technologies (UV lithography and milling) did not have a big impact to our antennas’ parameter results (S11 parameter differed ~1,05 dB and gain ~0,4 dBi). In this work due to time saving and smaller errors in antenna’s patches and impedance paths it is better to send designed models to companies that have milling looms.

Degree

thesis:*
Grantor dc:publisher
Institutional Repository of Vilnius University
Year dc:date
2019

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Solovjovas, Arnoldas,

Rights

dc:rights
Statement dc:rights
  • info:eu-repo/semantics/openAccess
Language dc:language
lit

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
Vilnius University
Base URL
epublications.vu.lt/oai
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Solovjovas, Arnoldas,. 5 GHz dažnio planarinių antenų modeliavimas ir tyrimas /. Institutional Repository of Vilnius University, 2019. https://repository.vu.lt/VU:ELABAETD193352634&prefLang=en_US