Back to search

Institutional Repository of Vilnius University

Quality enhancement of cut glass using co2 laser /

Abstract

dc:description

Glass-cutting technologies are applicable in a variety of industries ranging from architectural designs to optical and electronic devices. Laser glass cutting provides accurate cuts at high processing speeds. However, laser cutting is a thermal process that could form cracks and other defects in the glass, reducing the quality and the flexural strength of the cut pieces. Fortunately, the CO2 laser in peeling and polishing processes can be used to maintain high cut quality. Therefore, the aim of this work was to investigate the impact of laser polishing and peeling technologies on fused silica and soda-lime glasses’ flexural strengths, respectively. In this work soda-lime and fused silica glass samples were cut using a 1030 nm wavelength picosecond laser in a biburst regime to utilize the full laser glass cutting potential. However, while this regime is efficient in processing speed, the quality of the glass is reduced. To combat that for the soda-lime glass laser peeling was used. The quality of the fused silica samples was increased by utilizing laser polishing technique. After conducting quality enhancement experiments, an experimentally generated map of soda-lime glass peeling showed that successful peeling can be achieved in a narrow laser energy dose window from 11.56 ± 1.37 to 17.92 ± 3.22 J/cm2. Furthermore, due to removal of the defect layer peeling process increased the cut glass strip strength by up to 2.4 times, making it 183.9 ± 28.88 MPa and 181.37 ± 20.58 MPa for front and back sides of the glass strip accordingly. Moreover, by remelting the defective layer of fused silica with laser polishing, the strength of the samples increased by up to 2.6 times reaching 125.45 ± 8.33 MPa and 134.27 ± 14.25 MPa for front and back surfaces respectively. Finally, increasing the average laser power in the polishing process resulted in deeper surface remelting, consequently removing wider defects and resulting in around 1.6 times higher flexural strength of the sample. Here, increased average laser power from 53.1 to 71.8 W reduced surface roughness Ra from 1.25 ± 0.38 to 0.030 ± 0.015 µm and mean widest defect width from 185.26 ± 15.31 to 18.99 ± 1.78 µm.

Degree

thesis:*
Grantor dc:publisher
Institutional Repository of Vilnius University
Year dc:date
2025

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Šleiniūtė, Patricija,

Subjects

dc:subject × 1

Rights

dc:rights
Statement dc:rights
  • info:eu-repo/semantics/openAccess
Language dc:language
eng

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
Vilnius University
Base URL
epublications.vu.lt/oai
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Šleiniūtė, Patricija,. Quality enhancement of cut glass using co2 laser /. Institutional Repository of Vilnius University, 2025. https://repository.vu.lt/VU:ELABAETD229557972&prefLang=en_US