Institutional Repository of Vilnius University
Radijo dažnių signalų erdvinio vizualizavimo įrangos vystymas /
Abstract
dc:descriptionThis thesis investigates the main causes of poor signal reception at frequencies between 4 GHz and 6 GHz in ,,HackRF One" clone devices. These frequencies are crucial for the operation of FPV Drone Radio Detection and Localization system. In this work, a comparison was made between an original ,,HackRF One" device and three identical clones. It was found that the clone sensitivity to radio signals is lower across the entire spectrum, dropping sharply at higher frequencies (4–6 GHz). To identify the causes of this poor performance in the SDR clone devices, a detailed analysis of the front-end circuitry was conducted. It was discovered that the clone devices utilized different low-noise amplifiers with distinct power delivery circuitry. The clone devices also incorporated protection limiters to safeguard the local circuitry from high voltage. These findings clarified the architectural differences between the original and clone devices. Furthermore, the sensitivity of a clone device was measured by varying the signal's path length to the RFFC5072 Synthesizer & Mixer. It was determined that the RFFC5072 component exhibited poor frequency-sensitivity characteristics. To isolate signal power losses even further, the power transmission ratio (S21 parameter) was measured. It was found that the signal passing through the SMA port, protection limiter elements, and amplifier incurred losses close to 30 dB. Additionally, the high-pass filter was found to contribute another 30 dB of loss. Concluding this study, it was determined that repairing a clone device is not viable for several key reasons: it would be a challenging task to desolder the RFFC5072 component from the board without damaging the board itself or affecting nearby components, replacing every component with better characteristics would add additional costs, thus mitigating the benefits of using a clone in the first place. And finally, even after all these modifications, reliable operation of such a modified device would not be guaranteed, as the circuit design quality and the manufacturing of the board itself may be inherently flawed. The ,,HackRF One" clone platform is therefore deemed unsuitable for FPV drone locator development, and it is recommended to use original devices or seek alternative SDR platforms.
Degree
thesis:*- Grantor dc:publisher
- Institutional Repository of Vilnius University
- Year dc:date
- 2026
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Rimkevičius, Paulius,
Rights
dc:rights- Statement dc:rights
-
- info:eu-repo/semantics/openAccess
- Language dc:language
- lit
Identifiers
dc:identifier.*- Repository record dc:identifier
- https://repository.vu.lt/VU:ELABAETD308117299&prefLang=en_US