Institutional Repository of Vilnius University
Submikrometrinių difrakcinių gardelių tiesioginis formavimas naudojant skirtingo bangos ilgio femtosekundinę lazerio spinduliuotę /
Abstract
dc:descriptionDiffraction gratings are important optical elements widely used in spectroscopy, laser systems, sensors and other applications where precise control of light propagation direction and spectral distribution is required. Their performance is determined not only by the grating period, groove width and depth, but also by the surface quality. Increased surface roughness and defects formed during laser ablation can enhance light scattering and reduce diffraction efficiency. Therefore, the fabrication of small-period diffraction gratings with good surface quality in transparent dielectric materials, such as fused silica, remains an important task in laser micromachining. The aim of this work was to evaluate the possibility of forming small-period diffraction gratings on the surface of fused silica using femtosecond laser radiation of different wavelengths, and to investigate the improvement of the surface quality of the fabricated structures by CO2 laser polishing. Experiments were performed using a Light Conversion "Pharos" femtosecond laser. Line matrices were fabricated using the fundamental harmonic (1030 nm) with NA = 0,4 and NA = 0,9 objectives, and the third harmonic (343 nm) with an NA = 0,42 objective. During the experiments, the laser fluence was varied. In addition, the pulse repetition rate was changed for the fundamental harmonic, while the scanning speed was varied for the third harmonic. The fabricated grooves were evaluated according to their width, depth and surface roughness parameters Ra and Rz. The obtained results showed that the shorter-wavelength third harmonic radiation enables the formation of narrower and higher-quality grooves compared with the fundamental harmonic under similar numerical aperture objectives. Using the selected third harmonic processing regime (v = 10 mm/s, f_rep = 50 kHz, F = 4,1 J/cm^2, N = 1), a periodic diffraction grating was fabricated with a period of approximately 1,612 um and a groove depth of about h = 0,217 um. Although a submicrometer-period grating was not achieved in this work, the results demonstrate that shorter-wavelength femtosecond radiation is more suitable for the fabrication of smaller-scale structures on the surface of fused silica. The effect of CO2 laser polishing on the diffraction grating fabricated using the third harmonic was also investigated. It was found that too low scanning speeds caused excessive thermal exposure and destroyed the grating relief, whereas too high scanning speeds did not sufficiently modify the surface. The most suitable polishing regime was obtained at a scanning speed of v = 2,75 mm/s: the surface roughness parameters Ra and Rz were reduced by almost a factor of two, while the periodic structure was preserved. These results show that CO2 laser polishing can be used to improve the surface quality of diffraction gratings fabricated by femtosecond laser direct writing; however, the polishing parameters must be selected as a balance between reducing surface roughness and preserving the periodic relief.
Degree
thesis:*- Grantor dc:publisher
- Institutional Repository of Vilnius University
- Year dc:date
- 2026
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Bereišis, Kasparas,
Rights
dc:rights- Statement dc:rights
-
- info:eu-repo/semantics/openAccess
- Language dc:language
- lit
Identifiers
dc:identifier.*- Repository record dc:identifier
- https://repository.vu.lt/VU:ELABAETD308117473&prefLang=en_US