Back to search

Institutional Repository of Vilnius University

Elektroverpto poliuretano mikroapdirbimas ir perforavimas femtosekundiniu lazeriu /

Abstract

dc:description

In this paper I describe analysis of micromachining and perforation of electrospun polyurethane scaffold using a femtosecond laser. All ablation experiments were done using a 257 nm femtosecond laser working at 10 kHz repetition rate. A polyurethane scaffold was percussively drilled to investigate the relationships between ablated volume, crater diameter, depth, and pulse energy density or pulse count. Ablation efficiency peaked at 16 - 50 shots and continued to climb beyond the maximum test energy density. The ablation threshold was shown to decrease 3 to 4 times with increasing shot number, consistent with accumulation effects. Despite this, the total accumulated energy density required for single fiber damage remained constant across a wide range of shot counts at 7,72 J/cm^2. Percussion drilling was evaluated using both a 100 mm focal length lens and a ThorLabs LMU-5X-UVB objective accross a range of pulse energy densities and shot counts. The hole diameters and taper angles were evaluated via an optical microscope. Percussion drilling proved acceptable only for smaller holes (50 - 60 um) - larger holes exhibited unacceptable taper angles and surface charring at high powers. Defocusing the beam increased the hole diameter but was deemed suboptimal because of the increase in taper angles. Four alternative drilling methods were tested to address these limitations: circular cutting, circular cutting with central percussion drilling, concentric circles with percussion drilling (two and three circle configurations), and a fourth method combining concentric circles, percussion drilling and an additional pass with the objective lowered 200 um to ablate the lower portion of the hole. Out of these the fourth method proved to be the best at creating a hole with a negligible taper angle and complete material removal across a wide range of tested diameters (70 - 240 um) and fluences. It's notable, that no charring was observed for any method or parameter combination. Finally, the effect of perforation on material elasticity was assessed by tensile testing. Laser perforation increased the Young's modulus relative to unperforated samples (increase in value from 517 MPa to 786 MPa for 80 um holes and 676 MPa for 140 um holes). The stiffness could be attributed to fiber fusion at hole perimeters due to thermal effects induced by laser ablation. Scaffolds with larger diameter holes were less stiff due to larger volume of removed material. These results provide a practical framework for optimising femtosecond laser micromachining and perforation of electrospun polyurethane, especially for biomedical applications.

Degree

thesis:*
Grantor dc:publisher
Institutional Repository of Vilnius University
Year dc:date
2026

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Vasiliauskas, Jonas,

Rights

dc:rights
Statement dc:rights
  • info:eu-repo/semantics/openAccess
Language dc:language
lit

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
Vilnius University
Base URL
epublications.vu.lt/oai
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Vasiliauskas, Jonas,. Elektroverpto poliuretano mikroapdirbimas ir perforavimas femtosekundiniu lazeriu /. Institutional Repository of Vilnius University, 2026. https://repository.vu.lt/VU:ELABAETD308118073&prefLang=en_US