Back to search

Institutional Repository of Vilnius University

Safyro tūrinio femtosekundinio lazerinio mikroapdirbimo tyrimas /

Abstract

dc:description

This study investigates the potential of fabricating photonic crystals in sapphire—the success of the fabrication method under different fabrication parameters and the dependence of the filtering effect on these parameters. This was achieved by performing fabrication at different wavelengths—1030, 343, and 257 nm—on M- and C-plane sapphire, using various powers and beam polarizations, and fabricating structures with different numbers of layers. The fabrication of photonic crystals in M-plane sapphire using 1030 nm radiation across a wide range of power values was tested. In all cases, the result was a cracked structure. To investigate the moment of cracking, the fabrication process using different wavelengths was recorded. It was found that cracks were avoided during fabrication only in the case of 257 nm radiation. The fabrication of arrays in M-plane sapphire was repeated using 257 nm radiation. All structures were fabricated successfully. Spatial filtering measurements were then performed. Spatial filtering yielded identical results for both polarizations of the characterization beam. It was found that the transmittance drops sharply as the number of layers increases, until it reaches a threshold value, after which it begins to rise. This threshold number of layers was found to be different for different powers and beam polarization angles—for higher powers and polarization angles more perpendicular to the lines, it is reached at a lower number of layers. The fabrication process was tested on C-plane sapphire using 1030 nm radiation at low power values. Although catastrophic sample breakage was avoided, the fabricated structures exhibited significant, damage-induced losses. Arrays of structures were fabricated using 257 nm radiation at different fabrication polarizations. Their filtering characteristics differed from one another and from those obtained in the case of the M-plane. Although the structures fabricated with 257 nm pulses did not exhibit significant losses, their filtering performance was weaker than of structures fabricated on the M-plane. Fabrication at various scanning speeds was tested, and the maximum system-limited scanning speed was determined to be 0.6 mm/s, with which fabricated structure lines remain high quality.

Degree

thesis:*
Grantor dc:publisher
Institutional Repository of Vilnius University
Year dc:date
2026

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Bručas, Lukas,

Rights

dc:rights
Statement dc:rights
  • info:eu-repo/semantics/openAccess
Language dc:language
lit

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
Vilnius University
Base URL
epublications.vu.lt/oai
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
related terms
citation

Bručas, Lukas,. Safyro tūrinio femtosekundinio lazerinio mikroapdirbimo tyrimas /. Institutional Repository of Vilnius University, 2026. https://repository.vu.lt/VU:ELABAETD308118712&prefLang=en_US