Back to search

Virginia Tech

Multi-Axis Material Extrusion Additive Manufacturing of Continuous Carbon Fiber Composites

Abstract

dc:description.abstract

The applications of material extrusion additive manufacturing have historically been limited to prototypes, models, and low load-bearing parts due to poor inter-layer and intra-layer adhesion and difficulty processing high-strength polymers, which tend to shrink during solidification. However, with multi-axis material extrusion to align the deposition paths in full 3D and continuous carbon fiber reinforcement to improve the mechanical, thermal, and chemical properties of the polymer, both of these challenges could be overcome. This work aims to develop and validate a software control system and deposition tool capable of multi-axis continuous carbon fiber reinforcement. The tool is required to have fiber cutting capability (a necessity for performing travel movements with continuous carbon fiber), in-situ control over fiber volume fraction, and a slender collision volume suited for collision-free multi-axis toolpaths. In this work, these tasks were successfully accomplished and demonstrated on a 6 degree-of-freedom robotic arm. The findings revealed the use of continuous carbon fiber significantly reduced inter-layer and intra-layer adhesion, but substantially increased the properties of the part when the fibers were aligned with the load. To validate the multi-axis capability of the system, a toolpath was generated for a curved tensile bar. The results showed that the continuous carbon fiber-reinforced multi-axis toolpath resisted a load 820.57% higher than that of an XY-planar sliced part printed with traditional filament, confirming the effectiveness of the presented approach. Multi-axis deposition can also be used to eliminate the necessity for support material in the material extrusion process. Supports enable large overhanging features to be printed, but result in longer build times, additional post processing steps, material waste, and poor surface finishes. Methods of minimizing support material have been explored extensively for traditional 3-axis material extrusion through toolpath, topology, and process parameter optimization. However, none of these methods have demonstrated the ability to eliminate supports entirely. With multi-axis material extrusion, the tool orientation can be selected such that material is always extruded onto a well-supported surface. However, there is currently a lack of research characterizing the range of overhangs that can be achieved at each tool orientation. In this work, a 6 degree-of-freedom robot arm equipped for material extrusion was used to characterize this relationship. A set of test pieces were printed with increasing overhang angles at a range of build directions between 0° and 60° with respect to gravity. The results showed that there was no statistically significant difference in surface quality of the test pieces as the tool angle and build direction were changed. This indicates that the same overhang limitations experienced in traditional XY printing rotate with the tool when printing multi-axially and are generally unaffected by gravitational forces.

Degree

thesis:*
Name thesis:degree_name
Master of Science
Level thesis:degree_level
masters
Discipline thesis:degree_discipline
Mechanical Engineering
Department dc:contributor.department
Mechanical Engineering
Grantor dc:publisher
Virginia Tech
Year dc:date.issued
2023

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Beaumont, Kieran Deane
Chair dc:contributor.committeechair
  • Williams, Christopher Bryant
Committee members dc:contributor.committeemember
  • Bortner, Michael J.
  • Raeymaekers, Bart
  • Komendera, Erik

Subjects

dc:subject × 5

Rights

dc:rights
Statement dc:rights
  • Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International
Language dc:language.iso
en

Identifiers

dc:identifier.*
Dc Identifier Other
vt_gsexam:37971

Chain of custody

source
Harvested from
Virginia Tech
Base URL
vtechworks.lib.vt.edu/oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Beaumont, Kieran Deane. Multi-Axis Material Extrusion Additive Manufacturing of Continuous Carbon Fiber Composites. masters thesis, Virginia Tech, 2023. http://hdl.handle.net/10919/115677