Back to search

Virginia Polytechnic Institute and State University

The performance estimation of an axial-flow compressor stage using theoretically derived blade element characteristics with experimental comparison

Abstract

dc:description.abstract

A method is developed for the calculation of steady, quasi-three-dimensional, subsonic, compressible flow through a two-dimensional cascade of blades which includes the effects of viscosity. The flow field is divided into two regions; a steady, irrotational core flow modeled by the compressible stream function equation and blade surface boundary layers modeled by the momentum and energy integral equations. The quasi-three-dimensional nature of the flow is introduced through streamtube contractions. The two regions are not solved in the typical iterative fashion however, but simultaneously, which allows solutions that include regions of separated flow. The exit flow angle is fixed by specifying equal velocities on the suction and pressure surface of the blade at the trailing edge plane. Total-pressure-loss coefficients for the fully mixed wake region are calculated from a control volume analysis of the exit flow using calculated boundary-layer parameters in the trailing edge plane. Thus the prediction technique allows the calculation of the typical blade element characteristics of deviation angle and total-pressure-loss coefficient for a wide range of incidence angles. The spanwise performance of an axial-flow compressor stage is estimated by integrating the radial component of the momentum equation at the inlet guide vane exit/rotor entrance and rotor exit stations. Axial variations in radial velocity are neglected but radial entropy variations at both stations and energy addition along a streamline through the rotor are considered. As a first approximation, the flow at both stations is calculated assuming no losses. The resulting flow distribution provides information on the spanwise variation of rotor inlet conditions and streamtube contraction. Blade element data are then calculated and used to re-evaluate the stage performance. While such a procedure may require multiple iterations in a low hub/tip ratio compressor before a converged solution is obtained, only one cycle is employed here. A three stage axial-flow compressor with a design speed and mass flow rate of 17,000 RPM and 24.5 lbm/sec (11.1 kg/s), respectively, and a nominal pressure ratio of 1.2 per stage is used to evaluate the prediction technique. At a test point of approximately 7300 RPM and 9 lbm/sec (4 kg/s), traverses were made behind the first stage rotor. A five hole prism probe was used to measure total and dynamic pressures and yaw and pitch angles. Total temperature measurements were made with a shielded iron-constantan thermocouple.

Degree

thesis:*
Name thesis:degree_name
Ph. D
Level thesis:degree_level
doctoral
Discipline thesis:degree_discipline
Mechanical Engineering
Department dc:contributor.department
Mechanical Engineering
Grantor dc:publisher
Virginia Polytechnic Institute and State University
Year dc:date.issued
1979

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Jones, Ralph Raymond
Chair dc:contributor.committeechair
  • Moses, H. L.
Committee members dc:contributor.committeemember
  • O'Brien, Walter F. Jr.
  • Pierce, F. J.
  • Telionis, T. P.
  • Wood, H. L.

Subjects

dc:subject × 3

Rights

dc:rights
Statement dc:rights
  • In Copyright
Language dc:language.iso
en

Identifiers

dc:identifier.*
Handle dc:identifier.uri
https://hdl.handle.net/10919/138645

Chain of custody

source
Harvested from
Virginia Tech
Base URL
vtechworks.lib.vt.edu/oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Jones, Ralph Raymond. The performance estimation of an axial-flow compressor stage using theoretically derived blade element characteristics with experimental comparison. doctoral thesis, Virginia Polytechnic Institute and State University, 1979. https://hdl.handle.net/10919/138645