Virginia Tech
Power Allocation and Detection Tradeoffs in Covert Underwater Acoustic Communication
Abstract
dc:description.abstractThe field of underwater acoustic communications has recently witnessed a growing interest in techniques that achieve improved throughput, resiliency, and/or covertness in communications. Prior work has focused primarily on waveform design, with careful attention given to managing or mitigating the harsh effects of the underwater acoustic channel. However, research on utilizing the uniqueness of this channel to improve the tradeoff between reliability and detection probability is underexplored. This thesis presents a waveform-level simulation-based analysis of uniform and non-uniform power allocation strategies across the 10-60 kHz acoustic frequency spectrum using a multiband OFDM waveform. The problem is first posed as a convex optimization problem whose objective is to maximize channel capacity subject to a covertness constraint and total power constraint, and the optimal transmit spectrum is investigated in scenarios in which the power constraint is both inactive and active over distances of 2-8 km. The results demonstrate that higher transmit frequencies are preferred when transmit power is in surplus, while the spectral distribution shifts toward lower frequencies with less absorption when power must be conserved. The optimized transmit distribution is then simulated at various transmission distances in which the power constraint is inactive. Covertness is measured in the simulation using two variations of energy detection. Transmission distances from 100 m to 1300 m are considered in 400 m increments. At close receiver range and moderate warden distance, the highest frequency band resulted in the best bit error rate and lowest probability of detection; when both the receiver and warden are approximately 1 km from the transmitter, we demonstrate a tradeoff between the receiver reliability achieved at lower frequency bands and the warden probability of detection that is reduced by using the highest bands. Following this analysis, we consider the design of wake-up tone signals for low-power underwater acoustic modems that utilize a sleep state to conserve energy. The receiver is modeled as a narrowband energy detector with prior knowledge of the wake-up tone frequency band. Single-tone and dual-tone wake-up signals are evaluated in a simulated underwater acoustic channel, and the ideal frequency for maximizing the margin between probability of detection and probability of receiver wake-up is reported for various distances of the receiver and warden. Dual-tone wake-up signals performed approximately equal to or marginally worse than the single-tone counterparts. Finally, progress towards the development of a low-cost underwater acoustic software-defined modem is presented that uses the Raspberry Pi and GNU Radio. Initial results explore the challenges of streaming analog signal samples to and from the device.
Degree
thesis:*- Name thesis:degree_name
- Master of Science
- Level thesis:degree_level
- masters
- Discipline thesis:degree_discipline
- Electrical Engineering
- Department dc:contributor.department
- Electrical Engineering
- Grantor dc:publisher
- Virginia Tech
- Year dc:date.issued
- 2026
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Roberts, Austin
- Chairs dc:contributor.committeechair
-
- Buehrer, R. Michael
- Jakubisin, Daniel
- Committee member dc:contributor.committeemember
-
- Dhillon, Harpreet Singh
Subjects
dc:subject × 3Rights
dc:rights- Statement dc:rights
-
- In Copyright
- Licence dc:rights.uri
- Language dc:language.iso
- en
Identifiers
dc:identifier.*- Dc Identifier Other
- vt_gsexam:47078