Back to search

University of Leeds

Direct Injection of Liquid Nitrogen into Water for a Cryogenic Engine

Abstract

dc:description.abstract

The cryogenic engine was developed as a non-combustion zero emission engine that converts thermal energy to work by the vaporisation of liquid nitrogen using ambient heat. Its output is dependent on the heat transfer rate between liquid nitrogen and the ambient, where the efficiencies of previous designs were operated in an indirect process and heavily reliant on the performance of air heat exchangers used. The direct injection process was recently introduced to improve the heat transfer rate by directly injecting liquid nitrogen into a warmer fluid. The large temperature difference between two fluids in contact is expected to lead to rapid vaporization of liquid nitrogen, hence improving the performance of a liquid nitrogen engine. However, the feasibility of direct injection is challenged by the lack of an adequate valve system to control the delivery of the cryogen, along with a deep understanding of the heat transfer mechanism involved. To address these challenges, a fundamental study of the direct injection of liquid nitrogen into water at ambient temperature is conducted in this thesis. A static rig is designed to allow for the control of the injection process in order to investigate the influence of the injection parameters on the pressurisation rate. The injection timing and valve movement are controlled by a hydraulic actuator, which allows for synchronized injections at the desired pressure and temperature. Over 400 injections of nitrogen at different thermodynamic conditions were conducted and maximum pressurisation rates of up to 5156 bar/s were recorded for a clearance volume of 5 ml, which is 10 times greater than those found in the literature as a result of the increased injection pressure. Based on the pressurization curve, a two-stage boiling mechanism of liquid nitrogen is inferred that occurs inside the vessel, that is, film boiling and breakup of liquid nitrogen jet into small droplets, and subsequent boiling of liquid nitrogen droplets. To further increase our understanding of these complicated processes involved, a numerical study using CFD software Fluent is conducted to simulate the jetting and boiling of a liquid nitrogen droplet in water. A heat transfer and thermodynamic analysis is conducted and the implications of the results to the engine performance and its development are discussed.

Degree

thesis:*
Name dc:type.qualificationname
Ph.D
Level dc:type.qualificationlevel
doctoral
Grantor dc:publisher.institution
University of Leeds
Year dc:date.issued
2019

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Mutumba, Angela
Advisors dc:contributor.advisor
  • Wen, Dongsheng
  • Clarke, Henry

Rights

Language dc:language.dcterms_iso639_2
eng

Identifiers

dc:identifier.*
Identifier
uk.bl.ethos.778719

Chain of custody

source
Harvested from
White Rose University Consortium
Base URL
etheses.whiterose.ac.uk/cgi/oai2
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
related terms
citation

Mutumba, Angela. Direct Injection of Liquid Nitrogen into Water for a Cryogenic Engine. doctoral thesis, University of Leeds, 2019.