University of Leeds
An Investigation into Vacuum Drying of Spent AGR Fuel through Failed Cladding
Abstract
dc:description.abstractIn the United Kingdom the spent nuclear fuel produced by the Advanced Gas-cooled Reactors (AGR) is stored underwater at Sellafield awaiting a decision on the final disposal. Currently it is considered best practice to continue with the wet storage of the spent fuel however dry storage is being researched as an alternative should it be deemed necessary. There is also an acknowledgement that prior to the disposal of spent fuel in any future Geological Disposal Facility (GDF) will likely require the spent fuel to be dried. The preferred approach for conducting this drying process is called vacuum drying. The vast majority of the spent fuel is expected to remain intact and not pose an impediment in the transition from wet interim storage to dry interim storage or disposal. However, under reactor conditions, the cladding can be rendered more vulnerable to corrosion. If the cladding was to corrode and fail then water from the pond can ingress into the fuel pin and become trapped. With the failure of the cladding providing a route for the water to enter the pin, it was suggested that this should also be a route by which the water could be removed. It is important to remove this water as the radiation from the spent fuel can cause the trapped water to undergo radiolysis which can produce hydrogen gas, hydrogen peroxide and other species which are a detriment to the safe, long-term storage or disposal of the spent fuel. This thesis presents the results of an investigation into the vacuum drying process and the production of a model which can be used to provide insight into the conditions required for the drying. To achieve this representative cracks were required for the water and water vapour to pass through during the vacuum drying tests. An adapted form of the drop evaporation technique was used to produce these cracks in stainless steel. In addition to this work, the flow of air through various defects (pinholes, slits and cracks) was studied using the fluid flow set up with the results from these experiments presented in this thesis. Additionally a method to determine the dimensions (length and average width) of a defect is presented and the data acquired from this process used to validate the vacuum drying model.
Degree
thesis:*- Name dc:type.qualificationname
- M.Phil
- Level dc:type.qualificationlevel
- masters
- Grantor dc:publisher.institution
- University of Leeds
- Year dc:date.issued
- 2024
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Bainbridge, Thomas Oliver
- Advisors dc:contributor.advisor
-
- Hanson, Bruce
- Hondow, Nicole
- de la Fontaine, Carlos
Rights
- Language dc:language.dcterms_iso639_2
- eng