The aim of master’s thesis was to put forward calculation methodology of wastegate turbocharger bypass channel discharge coefficient. Designed methodology was based on discharge coefficient analysis conducted utilizing CFD simulations of turbocharger turbine-side parametric model. It was achieved to propose a calculation, which differentiates relatively in average 1,4% from CFD data. New methodology improves the accuracy bypass channel design and helps to choose appropriate wastegate valve actuator.

Orifices are essential devices for measurement and control of flow. It is important to define the flow field and understand the flow characteristics behind an orifice for the sake of reliability measures in many hydraulic engineering applications. Since analytical and experimental solutions are restricted, a numerical solution is obtained using volume of fluid (VOF) method with the CFD solver, FLUENT, for sharp crested orifices, orifice tubes and slots. The results are compared to the available data in the literature / also a large spectrum of data collection has been achieved.

The master´s thesis focuses on design of intake manifold with swirl flap for diesel engine. In addition to the design of sub-components of the intake manifold are also investigated the influence of new solutions on engine parameters. The influence of the new solution is compared to the original version and a reference model simulating intake manifold used by competitors. After simulation of thermodynamics and fluid flow are evaluated each variants.

No / Model based control of automotive engines for fuel economy and pollution minimization depends on accuracy of models used. A number of mathematical models of automotive engine processes are available for this purpose but critical model parameters are difficult to obtain and generalize. This paper presents a novel method of online estimation of discharge coefficient of throttle body at the intake manifold of gasoline engines. The discharge coefficient is taken to be a varying parameter. Air mass flow across the throttle body is a critical variable in maintaining a closer to stoichiometric air fuel ratio; which is necessary to minimize the pollution contents in exhaust gases. The estimation method is based on sliding mode technique. A classical first Sliding mode observer is designed to estimate intake manifold pressure and the model uncertainty arising from the uncertain and time varying discharge coefficient is compensated by the discontinuity/switching signal of sliding mode observer. This discontinuity is used to compute coefficient of discharge as a time varying signal. The discharge coefficient is used to tune/correct the intake manifold model to engine measurements. The resulting model shows a very good agreement with engine measurements in steady as wells transient state. The stability of the observer is shown by Lyapunov direct method and the validity of the online estimation is successfully demonstrated by experimental results. OBD-II (On Board Diagnostic revision II) based sensor data acquisition from the ECU (Electronic Control Unit) of a production model vehicle is used. The devised algorithm is simple enough to be designed and implemented in a production environment. The online estimation of parameter can also be used for engine fault diagnosis work. (c) 2012 Elsevier B.V. All rights reserved.