ITC/USA 2014 Conference Proceedings / The Fiftieth Annual International Telemetering Conference and Technical Exhibition / October 20-23, 2014 / Town and Country Resort & Convention Center, San Diego, CA / In this paper, we propose a novel technique using a single antenna for direction of arrival (DOA) estimation of broadband microwave signals. We designed and fabricated a microstrip-leaky-wave receiving antenna, which has good matching and reasonable radiation efficiency in the frequency range of interest: 2 - 3.5 GHz. Because the frequency response of the antenna is strongly incident-angle dependent, by using the spectral information at the antenna, we are able to estimate the DOA of a broadband microwave signal with a high degree of accuracy. Simulations and experiments show that the proposed technique enables good DOA estimation performance within a 90˚ range.

This dissertation presents the investigation of antennas with improved performances at microwave frequencies. It covers the following three topics: the study of the metamaterial with near-zero index of refraction and its application in directive antenna design, the design technique of a wideband circularly polarized patch antenna for 60GHz wireless application and the investigation of a novel direction of arrival (DOA) estimation technique inspired by human auditory system. First, the metamaterial composed of two-dimensional (2-D) metallic wire arrays is investigated as an effective medium with an effective index of refraction less than unity (n(eff) < 1). The effective medium parameters (permittivity ε(eff), permeability μ(eff) and n(eff)) of a wire array are extracted from the finite-element simulated scattering parameters and verified through a 2-D electromagnetic band gap (EBG) structure case study. A simple design methodology for directive monopole antennas is introduced by embedding a monopole within a metallic wire array with n(eff) < 1 at the antenna operating frequencies. The narrow beam effect of the monopole antenna is demonstrated in both simulation and experiment at X-band (8 – 12 GHz). The measured antenna properties including return loss and radiation patterns are in good agreement with simulation results. Parametric studies of the antenna system are performed. The physical principles and interpretations of the directive monopole antenna embedded in the wire array medium are also discussed. Second, a fully packaged wideband circularly polarized patch antenna is designed for 60GHz wireless communication. The patch antenna incorporates a diagonal slot at the center and features a superstrate and an air cavity backing to achieve desired performances including wide bandwidth, high efficiency and low axial ratio. The detailed design procedure of the circularly polarized antenna, including the design of the microstrip-fed patch antenna and the comparison of the performances of the antenna with different feeding interfaces, is described. The experimental results of the final packaged antenna agree reasonably with the simulation results. Third, an improved two-antenna direction of arrival (DOA) estimation technique is explored, which is inspired by the human auditory system. The idea of this work is to utilize a lossy scatter, which emulates the low-pass filtering function of the human head at high frequency, to achieve more accurate DOA estimation. A simple 2-monopole example is studied and the multiple signal classification (MUSIC) algorithm is applied to calculate the DOA. The improved estimation accuracy is demonstrated in both simulation and experiment. Furthermore, inspired by the sound localization capability of human using just a single ear, a novel direction of arrival estimation technique using a single UWB antenna is proposed and studied. The DOA estimation accuracies of the single UWB antenna are studied in the x-y, x-z and y-z planes with different Signal to Noise Ratios (SNR). The proposed single antenna DOA technique is demonstrated in both simulation and experiment, although with reduced accuracy comparing with the case of two antennas with a scatter in between. At the end, the conclusions of this dissertation are drawn and possible future works are discussed.

ITC/USA 2011 Conference Proceedings / The Forty-Seventh Annual International Telemetering Conference and Technical Exhibition / October 24-27, 2011 / Bally's Las Vegas, Las Vegas, Nevada / Inspired by human auditory system, an improved direction of arrival (DOA) technique using only two antennas with a scatterer in between them to achieve additional magnitude cues is proposed. By exploiting the incident-angle-dependent magnitude and phase differences between the two monopole antennas and applying 2-D / 3-D multiple signal classification algorithms (MUSIC), the DOA of an incident microwave signal can be estimated. Genetic algorithm is applied to optimize the scatterer geometry for the 3-D DOA estimation. The simulated results of both the azimuth and three-dimensional DOA estimation have shown an encouraging accuracy and sensitivity by incorporating a lossy scatterer.

The growing traffic and global bandwidth shortage for broadband cellular communi-cation networks has motivated to explore the underutilized millimeter wave frequencyspectrum for future communications. Fifth generation (5G) is the key to empow-ering new services and use cases for people, businesses, and society at large. Withunprecedented speed and flexibility, 5G carries more data with greater reliability andresponsiveness than ever before. As 5G new radio (NR) begins to take full advantageof the high-band spectrum, i.e, the millimeter wave frequencies, new challenges arecreated. While millimeter waves offer broader bandwidth and high spatial resolution,the drawback is that the millimeter waves experience higher attenuation due to pathloss and are more prone to absorption, interference and weather conditions, thereforelimiting cell coverage.This thesis is an attempt to increase the 5G cell coverage by implementing ananalogue beamforming router in a cell. Beamforming router acts like a relay, whichextends the range of the 5G cell whenever needed, according to the position of theUser Equipment (UE) based on the information received from the gNodeB (gNB,logical 5G radio node). This thesis is investigating the downlink Signal-to-Noise Ratio(SNR) gain and thus possible increase in the data rate. Simulation and validation ofthe overall performance is done using MATLAB. The outcome of this study may beused to increase the 5G cell coverage if it is implemented in a real.

No / In this research work the improvement of AOA estimation accuracy by applying a decoupling matrix derived using the receiving mode approach has been investigated using data measured in an anechoic chamber. The receiver was a 4-element uniform circular array with quarter wavelength inter-element spacing deployed on a square metal plate. The performance of the angle of arrival estimation error has been observed for two groups of direction finding algorithms, namely phase comparison-based (interferometry) and covariance-based algorithms. Mutual coupling compensation on AOA was found to improve accuracy by approximately 50%.

The objective of this thesis is to design, build and evaluate a direction-of-arrival measurement system using an antenna array operating at 2050 MHz. The first phase of the project is an extensive study of various high resolution DOA estimation algorithms. The algorithms studied include subspace-based techniques such as the MUSIC (MUltiple Signal Classification) and ESPRIT (Estimation of Signal Parameters via Rotational Invariance) algorithm, and the integrated approaches which combine property restoral-based techniques such as the Iterative Least Squares Projection-based Constant Modulus Algorithm (lLSP-CMA) with subspace-based techniques. All these algorithms were simulated in MATLAB and their performance under different conditions were tested and compared. In the second phase of the project a six element uniformly spaced linear array receiver was built. Three Ariel DSP-96 boards based on the Motorola DSP96002 are used to simultaneously sample, collect, and store data from each of the array elements. The data collected by the DSP boards are processed off-line to estimate the directions of arrival. Several experiments are conducted to test the functioning of the system under various conditions, and demonstrate the performance of different algorithms. Results of these experiments are also presented in this thesis. / Master of Science

A direction of arrival (DoA) estimation technique for broadband microwave signals is proposed using a single ultrawideband antenna. It is inspired by the sound source localization ability of a human auditory system using just one ear (monaural localization). By exploiting the incident angle-dependent frequency response of a wideband antenna, the DoA of a broadband microwave signal can be estimated. The DoA estimation accuracies are evaluated for two antenna configurations and microwave signals with different signal-to-noise ratios. Encouraging the DoA estimation performance of the proposed technique is demonstrated in both simulation and experiment.

This dissertation presents the investigation of biologically inspired direction finding (DF) and localization systems, 3D printing solution for RF components and systems, and fundamental aspects of antennas regarding bandwidth and power efficiency. Biologically inspired direction finding and localization systems are explored first. Inspired by the human binaural auditory system, an improved direction of arrival (DoA) estimation technique using two antennas with a lossy scatterer in between them to achieve additional magnitude cues is proposed. By exploiting the incident-angle- dependent magnitude and phase differences between the two antennas with specially designed scatterer, the DoA of an incident signal from two-dimensional (2-D) / three- dimensional (3-D) space can be estimated. Besides, compact DF systems with enhanced directional sensitivity using a scatterer of high permittivity in between adjacent closely spaced electrically-small antennas are examined. Inspired by the human monaural auditory system, a novel single-antenna DF technique is also proposed by exploiting the incident-angle-dependent spectra for a broadband RF signal only. In addition, a wideband superior DF system utilizing Luneburg lens and uniformly placed detectors on the equator of the lens is evaluated. The DoA is estimated using the amplitude distribution of the received signals at the detectors. Moreover, A portable inventory localization system utilizing hybrid RF (for direction, using previously introduced DF techniques) and ultrasound (for distance) signals is proposed and experimentally demonstrated. Next, a multilayer phased array system is designed and individual parts are printed to demonstrate the applicability of hybrid thermal wire-mesh embedding (for conductors) and thermoplastic extrusion (for dielectrics) techniques for additively manufacturing RF17integrated systems. Finally, fundamental aspects of antennas in terms of bandwidth limit for reactive matching and power efficiency for non-Foster matching are analyzed.

This master’s thesis covers the design and implementation of a monopulse directionof arrival (DOA) estimation algorithm on an FPGA. The goal is to implement a complete system that is capable of estimating the bearing of an incident signal. In order to determine the estimate quality both a theoretical and practical noise analysis of the signal chain is performed. Special focus is placed on the statistical properties of the transformation from I/Q-demodulated signals with correlated noise to a polar representation. The pros and cons for three different methods of calculating received signal phasors are also covered.The system is limited to two receiving channels which constrains this report to a 2D analysis. In addition the used hardware is limited to C-band signals. We show that an FPGA implementation of monopulse techniques is definitely viable and that an SNR higher than ten dB allows for a gaussian approximation of the polar representationof an I/Q signal.

In certain applications involving direction of arrival (DOA) estimation the operator may have a-priori information on some of the DOAs. This information could refer to a target known to be present at a certain position or to a reflection. In this study, the authors investigate a methodology for array processing that exploits the information on the known DOAs for estimating the unknown DOAs as accurately as possible. Algorithms are presented that can efficiently handle the case of both correlated and uncorrelated sources when the receiver is a uniform linear array. The authors find a major improvement in estimator accuracy in feasible scenarios, and they compare the estimator performance to the corresponding theoretical stochastic Cramer-Rao bounds as well as to the performance of other methods capable of exploiting such prior knowledge. In addition, real data from an ultra-sound array is applied to the investigated estimators. / <p>QC 20130107</p>