No description available.

No description available.

A modular structural design methodology for composite blades is developed. This design method can be used to design composite rotor blades with sophisticate geometric cross-sections. This design method hierarchically decomposed the highly-coupled interdisciplinary rotor analysis into global and local levels. In the global level, aeroelastic response analysis and rotor trim are conduced based on multi-body dynamic models. In the local level, variational asymptotic beam sectional analysis methods are used for the equivalent one-dimensional beam properties. Compared with traditional design methodology, the proposed method is more efficient and accurate. Then, the proposed method is used to study three different design problems that have not been investigated before. The first is to add manufacturing constraints into design optimization. The introduction of manufacturing constraints complicates the optimization process. However, the design with manufacturing constraints benefits the manufacturing process and reduces the risk of violating major performance constraints. Next, a new design procedure for structural design against fatigue failure is proposed. This procedure combines the fatigue analysis with the optimization process. The durability or fatigue analysis employs a strength-based model. The design is subject to stiffness, frequency, and durability constraints. Finally, the manufacturing uncertainty impacts on rotor blade aeroelastic behavior are investigated, and a probabilistic design method is proposed to control the impacts of uncertainty on blade structural performance. The uncertainty factors include dimensions, shapes, material properties, and service loads.

In 1967 the US Air Force solicited proposals for ``low-disc-loading [Vertical Takeoff and Landing] configurations suitable for high speed flight.' Bell Helicopter elected to respond with a proposal after initial analysis on configurations including a stopped edgewise disc and a trail rotor. They concluded that a folding proprotor design would best meet the requirements laid forth. Initial analysis work began on this folding proprotor (stop-fold) design in the same year and concluded in 1972 with a full scale 25 foot diameter pylon and rotor assembly wind tunnel test at the NASA-Ames Large Scale Wind Tunnel. The project was concluded at this point and never resulted in a production or research aircraft. The original proposed stop-fold tiltrotor design by Bell Helicopter allowed for vertical takeoff and landing, a transition sequence rotating the pylon rotor assembly from helicopter to airplane mode, a conversion sequence during which the rotor stopped and blades folded along the pylon, and a transition from prop thrust to auxiliary jet engine power while the rotor was being stopped. This configuration effectively removes the high-speed restraints typical of a prop-driven aircraft and instead opens a flight envelope comparable to a fixed-wing jet. This project entails both the simulation and basic analysis of the stop-fold concept with special attention to frequency responses and potential coupling between modes.

Zugl.: Darmstadt, Techn. Univ., Diss., 2007

Zugl.: Erlangen, Nürnberg, Universiẗat, Diss., 2007.

Zugl.: Darmstadt, Techn. Univ., Diss., 2007

Zugl.: Braunschweig, Techn. Univ., Diss., 2008

Zugl.: Clausthal, Techn. Univ., Diss., 2007

Zugl.: Kaiserslautern, Techn. Univ., Diss., 2008