ITC/USA 2009 Conference Proceedings / The Forty-Fifth Annual International Telemetering Conference and Technical Exhibition / October 26-29, 2009 / Riviera Hotel & Convention Center, Las Vegas, Nevada / Multi-h Continuous Phase Modulation (CPM) is a promising waveform for aeronautical telemetry because it is a compact spectrally efficient constant amplitude modulation. It has been selected as the Advanced Range Telemetry (ARTM) tier II waveform owing to these qualities. However, it is also a complicated waveform that has the reputation of suffering from complex demodulation processing and high sensitivity to transmission impairments and in particular synchronization aspects. In this paper we review a set of complexity reduction techniques that intend to bring this waveform into the domain of operational telemetry waveform, by allowing low complexity hardware implementation without sacrificing performance or robustness. Most techniques are adjustments of recent literature results, concerning both demodulation and synchronization. Computer simulation of a receiver implementing theses techniques shows negligible performance loss compared to optimal coherent demodulation with perfect synchronization. Hardware implementation confirms that nearly optimal performance can be achieved with hardware resource currently available in middle range FPGAs.

ITC/USA 2011 Conference Proceedings / The Forty-Seventh Annual International Telemetering Conference and Technical Exhibition / October 24-27, 2011 / Bally's Las Vegas, Las Vegas, Nevada / Multi-H Continuous Phase Modulation is a highly bandwidth efficient constant amplitude modulation scheme. Because of these qualities it was selected as the Advanced Range Telemetry (ARTM) tier II waveform. In the past, two demodulation techniques have widely been proposed, coherent detection and non-coherent detection. This paper presents a receiver design that implements a hybrid, partially coherent detection scheme that takes advantage of the positive aspects of both coherent and non-coherent detection. Because complete phase recovery is not required, the hybrid receiver performs better in environments with fast fading, strong phase noise, and multi path when compared to the traditional coherent receiver. The hybrid receiver can also acquire and reacquire signals much faster than conventional coherent receivers. The hybrid receiver design implements a partial carrier detection scheme that utilizes phase information that performs much better in AWGN environments than typical non-coherent receivers. Simulation results show that the hybrid receiver has low implementation loss compared to the optimal Maximum Likelihood Sequence Estimation (MLSE) receiver.

ITC/USA 2013 Conference Proceedings / The Forty-Ninth Annual International Telemetering Conference and Technical Exhibition / October 21-24, 2013 / Bally's Hotel & Convention Center, Las Vegas, NV / Since the waveform was first developed by the Advanced Range Telemetry Program (ARTM) and adopted by the Range Commanders Council Telemetry Group (RCC/TG), receiver/demodulators for the ARTM Continuous Phase Modulation (CPM) waveform have undergone continued development by several hardware vendors to boost performance in terms of phase noise, detection performance, and resynchronization time. These same results were initially presented at the International Telemetry Conference (ITC) 2003 when hardware first became available supporting this waveform, at the time called ARTM Tier II. This paper reexamines the current state of the art performance of ARTM CPM receiver/demodulators available in the marketplace today.