Spelling suggestions: "subject:"alloptical egeneration"" "subject:"alloptical 4egeneration""
1 |
Wavelength-Preserving Polarization-Insensitive All-Optical 3R Regenerator Based on Self- and Cross-Phase Modulation and Offset Filtering Utilizing Raman AmplificationCHUNG, SUNG HAN 19 October 2009 (has links)
Optical regeneration has the potential to significantly increase the reach of long-haul transmission systems. In this thesis, wavelength-preserving polarization-insensitive all-optical 3R regeneration is investigated and demonstrated for 10 and 40 Gb/s signals. The all-optical regenerator utilizes a self-pulsating laser for clock recovery, cross-phase modulation (XPM) based spectral broadening in a highly nonlinear fiber (HNLF) and offset filtering for retiming, and self-phase modulation based spectral broadening in a HNLF and offset filtering for reshaping. Raman amplification is used to increase the XPM-based spectral broadening and thus allow a design that meets the tradeoffs involved in simultaneously achieving good retiming and reshaping performance. The regenerator is shown to reduce amplitude noise and timing jitter while not causing a BER penalty. To fully validate the regeneration scheme, the cascadability is demonstrated using a recirculating loop. For a 10 Gb/s signal, with a regenerator spacing of 240 km, a return-to-zero, on-off-keyed (RZ-OOK) signal was transmitted over 18,000 km (75 loops) with a power penalty of 1.6 dB at a BER of 1E-9 compared to the back-to-back case. For a 40 Gb/s signal, with a regenerator spacing of 80 km, a RZ-OOK signal was transmitted over 8,000 km (100 loops) with a power penalty of 1.2 dB. In addition, all-optical 3R regeneration is demonstrated using a multimode quantum-dot Fabry Petot laser with ultra-low timing jitter. / Thesis (Ph.D, Electrical & Computer Engineering) -- Queen's University, 2009-10-19 14:11:53.826
|
2 |
All-Optical Clock Recovery, Photonic Balancing, and Saturated Asymmetric Filtering For Fiber Optic Communication SystemsParsons, Earl Ryan January 2010 (has links)
In this dissertation I investigated a multi-channel and multi-bit rate all-optical clock recovery device. This device, a birefringent Fabry-Perot resonator, had previously been demonstrated to simultaneously recover the clock signal from 10 wavelength channels operating at 10 Gb/s and one channel at 40 Gb/s. Similar to clock signals recovered from a conventional Fabry-Perot resonator, the clock signal from the birefringent resonator suffers from a bit pattern effect. I investigated this bit pattern effect for birefringent resonators numerically and experimentally and found that the bit pattern effect is less prominent than for clock signals from a conventional Fabry-Perot resonator.I also demonstrated photonic balancing which is an all-optical alternative to electrical balanced detection for phase shift keyed signals. An RZ-DPSK data signal was demodulated using a delay interferometer. The two logically opposite outputs from the delay interferometer then counter-propagated in a saturated SOA. This process created a differential signal which used all the signal power present in two consecutive symbols. I showed that this scheme could provide an optical alternative to electrical balanced detection by reducing the required OSNR by 3 dB.I also show how this method can provide amplitude regeneration to a signal after modulation format conversion. In this case an RZ-DPSK signal was converted to an amplitude modulation signal by the delay interferometer. The resulting amplitude modulated signal is degraded by both the amplitude noise and the phase noise of the original signal. The two logically opposite outputs from the delay interferometer again counter-propagated in a saturated SOA. Through limiting amplification and noise modulation this scheme provided amplitude regeneration and improved the Q-factor of the demodulated signal by 3.5 dB.Finally I investigated how SPM provided by the SOA can provide a method to reduce the in-band noise of a communication signal. The marks, which represented data, experienced a spectral shift due to SPM while the spaces, which consisted of noise, did not. A bandpass filter placed after the SOA then selected the signal and filtered out what was originally in-band noise. The receiver sensitivity was improved by 3 dB.
|
3 |
All-optical Regeneration For Phase-shift Keyed Optical Communication SystemsCroussore, Kevin 01 January 2007 (has links)
All-optical signal processing techniques for phase-shift keyed (PSK) systems were developed theoretically and demonstrated experimentally. Nonlinear optical effects in fibers, in particular four-wave mixing (FWM) that occurs via the ultra-fast Kerr nonlinearity, offer a flexible framework within which numerous signal processing functions can be accomplished. This research has focused on the regenerative capabilities of various FWM configurations in the context of processing PSK signals. Phase-preserving amplitude regeneration, phase regeneration, and phase-regenerative wavelength conversion are analyzed and demonstrated experimentally. The single-pump phase-conjugation process was used to regenerate RZ-DPSK pulse amplitudes with different input noise distributions, and the impact on output phase characteristics was studied. Experiments revealed a limited range over which amplitude noise could effectively be suppressed without introduction of phase noise, particularly for signals with intensity pattern effects. Phase regeneration requires use of phase-sensitive amplification (PSA), which occurs in nonlinear interferometers when the pump and signal frequencies are degenerate (NI-PSA), or in fiber directly through single-stage (degenerate) or cascaded (non-degenerate) FWM processes. A PSA based on a Sagnac interferometer provided the first experimental demonstration of DPSK phase and amplitude regeneration. The phase-regenerative capabilities of the NI-PSA are limited in practice by intrinsic noise conversion (amplitude to phase noise) and to a lesser extent by the requirement to modulate the pump wave to suppress stimulated Brillouin scattering (SBS). These limitations are relaxed in novel materials with higher SBS thresholds and nonlinearities. Degenerate FWM provides PSA in a traveling-wave configuration that intrinsically suppresses the noise conversion affecting the NI-PSA, while providing stronger phase-matched gain. Experiments confirmed superior phase-regenerative behavior to the NI-PSA with simultaneous reduction of amplitude noise for NRZ-DPSK signals. Phase-regenerative wavelength conversion (PR-WC) provides the regenerative properties of PSA at a new wavelength, and was proposed and demonstrated for the first time in this research. The parallel implementation of two FWM processes, phase-conjugation and frequency conversion, provides two idlers which exhibit interesting and useful regenerative properties. These were investigated theoretically and experimentally. Ideal phase-regenerative behavior is predicted when the contributing FWM processes are equally phase-matched, which can be maintained over any interaction length or wavelength shift provided the pump powers are properly adjusted. Depleted-pump regime PR-WC provides simultaneous phase and amplitude regeneration. Experiments confirmed regenerative behavior for wavelength shifts of the idlers up to 5 nm. Two techniques for phase regeneration of 4-level PSK signals were developed and evaluated. The first is based on parallel operation of PSAs suitable for processing 2-level PSK signals, where phase projection and regeneration are combined to recover the input data. Analysis of this scheme outlined the conditions required for effective phase regeneration and for practical implementation using known PSAs. A novel process based on FWM (parallel phase-conjugation followed by PSA) was developed and analyzed, and demonstrated using numerical simulations. These studies provide a basis for further work in this area.
|
4 |
Theoretical and experimental study of optical solutions for analog-to-digital conversion of high bit-rate signals / Étude théorique et expérimentale de techniques optiques pour la conversion analogique-numérique de signaux de communication à très haut débitNguyen, Trung-Hiên 19 November 2015 (has links)
Les formats de modulation bidimensionnels (i.e. basés sur l’amplitude et la phase de l’onde porteuse) ont gagné depuis peu le domaine des transmissions par fibre optique grâce aux progrès conjoints de l’électronique rapide et du traitement du signal, indispensables pour réaliser les récepteurs opto-électroniques utilisant la détection cohérente des signaux optiques. Pour pallier les limites actuelles en rapidité de commutation des circuits intégrés électroniques, une voie de recherche a été ouverte il y a quelques années, consistant à utiliser des technologies optiques pour faciliter la parallélisation du traitement du signal, notamment dans l’étape d’échantillonnage ultra-rapide du signal rendu possible par des horloges optiques très performantes. Le thème principal de cette thèse concerne l’étude théorique et expérimentale de la fonction de conversion analogique-numérique (ADC) de signaux optiques par un récepteur opto-électronique cohérent, associant les étapes d’échantillonnage optique linéaire, de conversion analogique-numérique et de traitement du signal. Un prototype, utilisant une solution originale pour la source d’échantillonnage, est modélisé, réalisé et caractérisé, permettant la reconstruction temporelle de signaux optiques modulés selon divers formats : NRZ, QPSK, 16-QAM. Les limitations optiques et électroniques du système sont analysées, notamment l’impact sur la reconstruction des signaux de divers paramètres : le taux d’extinction de la source optique, les paramètres de l’ADC (bande passante BW, temps d’intégration et nombre effectif de bits ENOB). Par ailleurs, de nouveaux algorithmes de traitement du signal sont proposés dans le cadre de la transmission optique cohérente à haut débit utilisant des formats de modulation bidimensionnels (amplitude et phase) : deux solutions sont proposées pour la compensation du déséquilibre de quadrature IQ dans les transmissions mono-porteuses: une méthode originale de l’estimation du maximum du rapport signal sur bruit ainsi qu’une nouvelle structure de compensation et d’égalisation conjointes; ces deux méthodes sont validées expérimentalement et numériquement avec un signal 16-QAM. Par ailleurs, une solution améliorée de récupération de porteuse (décalage de fréquence et estimation de la phase), basée sur une décomposition harmonique circulaire de la fonction de maximum de vraisemblance logarithmique, est validée numériquement pour la première fois dans le contexte des transmissions optiques (jusqu’à une modulation de 128-QAM). Enfin les outils développés dans ce travail ont finalement permis la démonstration d’une transmission sur 100 km d’un signal QPSK à 10 Gbaud fortement limité par un bruit de phase non linéaire et régénéré optiquement à l’aide d’un limiteur de puissance préservant la phase basé sur une nanocavité de cristal photonique. / Bi-dimensional modulation formats based on amplitude and phase signal modulation, are now commonly used in optical communications thanks to breakthroughs in the field of electronic and digital signal processing (DSP) required in coherent optical receivers. Photonic solutions could compensate for nowadays limitations of electrical circuits bandwidth by facilitating the signal processing parallelization. Photonic is particularly interesting for signal sampling thanks to available stable optical clocks. The heart of the present work concerns analog-to-digital conversion (ADC) as a key element in coherent detection. A prototype of linear optical sampling using an original solution for the optical sampling source, is built and validated with the successful equivalent time reconstruction of NRZ, QPSK and 16-QAM signals. Some optical and electrical limitations of the system are experimentally and numerically analyzed, notably the extinction ratio of the optical source or the ADC parameters (bandwidth, integration time, effective number of bits ENOB). Moreover, some new DSPs tools are developed for optical transmission using bi-dimensional modulation formats (amplitude and phase). Two solutions are proposed for IQ quadrature imbalance compensation in single carrier optical coherent transmission: an original method of maximum signal-to-noise ratio estimation (MSEM) and a new structure for joint compensation and equalization; these methods are experimentally and numerically validated with 16-QAM signals. Moreover, an improved solution for carrier recovery (frequency offset and phase estimation) based on a circular harmonic expansion of a maximum loglikelihood function is studied for the first time in the context of optical telecommunications. This solution which can operate with any kind of bi-dimensional modulation format signal is numerically validated up to 128-QAM. All the DSP tools developed in this work are finally used in a demonstration of a 10 Gbaud QPSK 100 km transmission experiment, featuring a strong non-linear phase noise limitation and regenerated using a phase preserving and power limiting function based on a photonic crystal nanocavity.
|
Page generated in 0.1275 seconds