A single-stage high-power-factor electronic ballast is designed for fluorescent lamps with dimming capability. The circuit configuration is originated from the integration of the half-bridge resonant inverter and the buck-boost converter. The buck-boost converter is designed to operate in discontinuous conduction mode (DCM) to provide nearly unit power factor at a fixed switching frequency. With asymmetrical pulse-width-modulation (APWM), the lamp power can be effectively regulated. The power switches of the inverter exhibit either zero-voltage-switching (ZVS) or zero-current-switching (ZCS) over the whole dimming range. Design equations are derived and computer analyses are performed based on a power-dependent lamp model and fundamental approximation. Design guidelines for determining circuit parameters are provided. A prototype circuit for a T8-36W fluorescent lamp is built and tested to verify the analytical predictions.

To minimize the size of the electronic ballast, a half-bridge load- resonant inverter with a cascading Rosen-type piezoelectric transformer (PT) is designed for cold cathode fluorescent lamps (CCFLs). The electrical characteristics of the PT are investigated to obtain a higher voltage gain by adapting the load impedance to the interposed network. The circuit parameters are selected under the considerations of (1) the minimum inductor size, (2) the higher circuit efficiency, (3) the rated current of the PT, and (4) the stable lamp operation. The electronic ballasts are designed for operating the lamp at the rated lamp power and with dimming control by asymmetrical pulse-width-modulation (APWM),respectively. Laboratory circuits are assembled and, experimental tests are carried out to validate the theoretical analyse

Three novel single-stage electronic ballasts with the advantages of high-power-factor, low current harmonic, high efficiency, and low cost are proposed for rapid-start fluorescent lamps. Included are (1) single-stage high-power-factor electronic ballast with asymmetrical topology, (2) single-stage high- power-factor electronic ballast with symmetrical topology, and (3) single-stage single-switch high-power-factor electronic ballast. The circuit configurations are obtained by integrating the buck-boost power-factor-correction converter into the Class D or the Class E resonant inverter. With simple circuit configuration and less component count, desired circuit performances of high-power-factor and high efficiency are realized. The control methods of pulse-width-modulation (PWM) with asymmetrical and symmetrical approaches are utilized for the three presented ballasts. The buck-boost conversion stage is operated at discontinuous current mode (DCM) to achieve nearly unity power factor at a fixed switching frequency. With carefully designed circuit parameters, the power switches can exhibit either zero-voltage switching-on (ZVS) or zero-current switching-on (ZCS). As a result, high circuit efficiency can be ensured. Design equations are derived and computer analyses are performed based on the lamp¡¦s equivalent resistance model and fundamental approximation. Accordingly, design guidelines for determining circuit parameters are provided. Prototypes of the three proposed circuits designed for a T8-36W lamp, two series-connected T9-40W lamps and a PL-27W lamp are built and tested to verify the computer simulations and analytical predictions.