Microgrids are local power systems of different sizes located inside the distribution systems. Each microgrid contains a group of interconnected loads and distributed energy resources that acts as a single controllable entity with respect to the grid. Their islanding operation capabilities during emergencies improve the resiliency and reliability of the electric energy supply. Due to its low kinetic energy storage capacity, maintaining microgrid stability is challenging under system contingencies and unpredictable power generation from renewable resources. This dissertation highlights the potential benefits of flexibly utilizing the battery energy storage systems to enhance the stability of microgrids. The main contribution of this research consists in the development of a storage converter controller with an additional stability margin that enables it to improve microgrid frequency and voltage regulation as well as its induction motor post-fault speed recovery. This new autonomous control technique is implemented by adaptively setting the converter controller parameters based on its estimated phase-locked loop frequency deviation and terminal voltage magnitude measurement. This work also assists in the microgrid design process by determining the normalized minimum storage converter sizing under a wide range of microgrid motor inertia, loading and fault clearing time with both symmetrical and asymmetrical fault types. This study evaluates the expandability of the proposed control methodologies under an unbalanced meshed microgrid with fault-induced feeder switching and multiple contingencies in addition to random power output from renewable generators. The favorable results demonstrate the robust storage converter controller performance under a dynamic changing microgrid environment.

The goal of this study was to determine the economic feasibility of battery energy storage system (BESS). Three major economic benefits derived from BESS using were studied: 1. Energy Purchase Shifting, 2. Distribution Feeder Deferral, 3. Outage Avoidance. The economic analysis was based on theoretical modeling of the BESS and distribution system. Three simulation models were developed to quantify the effects of different parameters, such as: BESS round-trip efficiency, life span, rated power, rated discharge time, marginal cost of electric energy, 24 h feeder load profile, annual load variation, feeder load growth rate and feeder length. An optimal battery charging/discharging method was presented to determine the differential cost of energy (DCE). The annual maximum DCE was calculated using stochastic probability analysis on seasonal load variation. The net present value was evaluated as the present value difference between two investments: first, the distribution feeder upgrade without BESS deferral, and second, with BESS deferral. Furthermore, the BESS’s contributions under different outage strategies were compared. It was determined that feeder length is the most significant parameter. The economics of the studied system becomes favorable when the feeder length exceeds a critical value.

The purpose of this study is to analyse how a battery energy storage system (BESS) can support the frequency and voltage stability for an islanded microgrid containing a hydropower plant. Two different microgrids, both situated in Sweden, are evaluated. Modelling and dynamic simulations are conducted in the PowerFactory tool. The result shows that both the frequency and the voltage control can be improved with the BESS. However, with the allowed limit of ± 1 Hz, not all simulated scenarios including a BESS meets the requirement. A large difference between the BESS and generator capacity might be a possible cause for this. By dividing the larger loads so that smaller loads are attained, the frequency deviation might be reduced. Furthermore, by adjusting the systems PID-parameters according to the island mode operation, faster regulation can be attained. The system operates according to the Master slave control strategy, with the hydropower being the master unit with voltage control and the BESS being a slave unit with PQ control. The ability to operate an islanded microgrid can ensure the supply of electricity to inhabitants and vital functions in society. By utilizing a BESS for increasing electric stability, emission of CO2 is indirectly mitigated. As cost for BESS are expected to decrease rapidly, they will be accessible for utilization all over the world.

Battery Storage Systems (BESS) installed Behind the Meter (BTM) can provide demand management services, reducing electricity costs and enhancing overall electricity system stability. BTM BESS can also imporve self-consumption obtained with distributed generation assets like solar photovoltaics. This study examines the influence on value creation from consumption patterns and utility tariffs. Using Swedish and UK tariffs and a set of consumption profiles, the study determines the optimal BESS configuration and conducts simulations to assess profability through Net Present Value. Comparative analysis reveals the impact of utility tariffs and consumption profiles on profitablility. Projected BESS cost levels for 2030 and 2050 are used to evaluate expected future profitability.  The findings indicate that utility tariff has a stronger influence on BTM BESS profitability than consumption profile. Energy arbitrage creates most of the value, depending more on tariff structure than consumption pattern. However, with higher demand charges, the consumtion profile becomes more important as the relative value of peak shaving increases. Two sensitivity analyses have been performed. The first shows that NPVs are affected by decreased electricity price variability, emphasising the need for accurate long-term price forcasts. The second shows that existing electricity consumption forecasting techniques prove sufficient for effective peak shaving.  In conclusion, this research inderscores the significance of utility tariffs and consumption profiles in determining BTM BESS profitability. Energy arbitrage dominates value creation, while peak shaving gains importance with higher demand charges. Accurate long-term price forecasts are crucial for assessing BTM BESS profitability, and existing consumption forecasting techniques are suitable for peak shaving. / Batterilagring installerad bakom elmätaren kan optimera en fastighets elkonsumtion för att reducera elkostnader samt förbättra stabiliteten i elsystemet som helhet. Den här studien undersöker faktorer som påverkar värdeskapande genom energiarbitrage och peak shaving, inklusive konsumtionsprofiler och eltariffer. Studien undersöker även om det går att uppnål önsamhet under nuvarande och framtida prisnivåer för batterilagring. Studien utgår ifrån svenska och brittiska eltariffer samt fem konsumtionsprofiler, och fastställer den mest optimala konfigurationen av batterilagring genom optimering. Därefter jämförs lönsamheten genom nettonuvärde-analys för att dra slutsatser om hur eltariff och konsumtionsprofil påverkar lönsamhet. Studien visar att lönsamhet för batterilagring bakom mätaren beror mer på eltariff än konsumtionsprofil. Detta eftersom mest värde skapas genom energiarbitrage som är mindre beroende av konsumtionsprofil men direkt beroende av variationer i elpriset. Med högre effektavgifter ökar lönsamhetens beroende av konsumtionsprofilen då det relativa värdet av peak shaving höjs. En känslighetsanalys visar på en stark korrelation mellan värdet av energiarbitrage och variationer i elpriset, vilket visar vikten av långsiktiga prognoser av elprisets volatilitet. Befintliga tekniker för prognostisering av elkonsumtion har tillräcklig noggrannhet för effektivpeak shaving. Sammanfattningsvis visar studien hur eltariff och konsumtionsprofil påverkar lönsamheten för batterilagring installerad bakom elmätaren. Majoriteten av värdet skapas genom energiarbitrage för svenska och brittiska tariffer. Med högre effektavgifter ökar betydelsen av peak shaving. Dessutom betonar studien vikten av långsiktiga prognoser av elprisvolatilitet vid utvärderingen av lönsamheten för investeringar i batterilagring bakom mätaren.

The transition in the transport sector by the integration of battery electric vehicles (BEVs) brings a new challenge for the system operators to ensure the balance between supply and demand. The installation of new EV charges poses a surge in electricity demand in the coming years which jeopardizes the grid reliability and stability. With the new EV policies in place, Sweden will have a huge growth of BEVs and the associated charging infrastructures. The challenges faced by the electricity transmission and distribution will depend on the type and smart capability of the infrastructure. Therefore, research is conducted to analyze the impacts of the mix of public and private residential EV charging and how smart charging can help in mitigating the impacts. This thesis studies the impact of the mix of private residential and public EV chargers on the power network of Hammarby Sjöstad, a neighborhood of Stockholm. Four substations out of 20 corresponding to the areas with the highest proportion in the residential and commercial sectors in the network were chosen for the study and power flow analysis was carried out to analyze the impacts in the year 2025. EV chargers were categorized into public and private residential chargers. The public chargers had rated power of 22 kW each while residential chargers were rated at 3.68 kW each. EVs can behave as energy vectors, and it is possible to optimize their charging as a part of demand-side management which includes peak shaving or shifting. Optimizing EV charging was treated as a mixed integer linear programming (MILP) problem to schedule EV charging for both reducing losses and the cost of electricity import from the grid. Two optimization strategies were investigated to analyze their potential to reduce the peaks due to uncontrolled charging. Renewable energy generation from solar PVs integrated with EV chargers reduces the import of electricity from the grid during the day which not only reduced the losses but also the cost of importing electricity from the grid. The effect of intermittency of solar PV generation was reduced by implementing BESS. At low price periods, the BESS was charged using the excess PV power and at higher price periods, the BESS was discharged. Three scenarios were developed, where the Reference scenario refers to the base case without PV and BESS, With PV scenario considered only PV generation while With PVBESS scenario considered the implementation of BESS with PV. Three test cases were simulated for each of the scenarios, and it was found that by the implementation of smart charging, the losses in the network reduce by 35.5% and it also significantly reduced the losses in all the other scenarios. Implementation of smart charging reduced the cost of electricity import from the grid by 4.3%. The integration of PV generation led to a 7% further reduction in the losses and cost of electricity import as compared to the Reference scenario. The integration of BESS increased the losses in the network, but it also enhanced the self-consumption of PV power. The implementation of smart charging not only reduces the losses and costs of import but will lead to savings in grid reinforcement costs. / Övergången inom transportsektorn genom integrering av batteri -elektriska fordon (BEV) medför en ny utmaning för systemoperatörerna att säkerställa balansen mellan utbud och efterfrågan. Installationen av nya elavgifter innebär en kraftig ökning av elbehovet under de kommande åren, vilket äventyrar nätets tillförlitlighet och stabilitet. Med den nya EV -politiken på plats kommer Sverige att ha en enorm tillväxt av BEV och tillhörande ladd infrastrukturer. Utmaningarna för elöverföring och distribution beror på infrastrukturens typ och smarta kapacitet. Därför forskas för att analysera effekterna av blandningen av offentliga och privata EV -laddningar för bostäder och hur smart laddning kan hjälpa till att mildra effekterna. Denna avhandling studerar effekten av blandningen av privata bostäder och offentliga EV -laddare på kraftnätet i Hammarby Sjöstad, en stadsdel i Stockholm. Fyra transformatorstationer av 20 motsvarande de områden med den högsta andelen inom bostads- och kommersiella sektorer i nätet valdes ut för undersökningen och effektflödesanalys utfördes för att analysera effekterna år 2025. EV -laddare kategoriserades offentligt och privata bostadsladdare. De offentliga laddarna hade en nominell effekt på 22 kW vardera medan bostadsladdare var 3,68 kW vardera. Elbilar kan bete sig som energivektorer, och det är möjligt att optimera laddningen som en del av hanteringen på efterfrågesidan som inkluderar topprakning eller växling. Optimering av EV -laddning behandlades som ett blandat heltal linjärt programmeringsproblem (MILP) för att schemalägga EV -laddning för både minskning av förluster och kostnader för elimport från nätet. Två optimeringsstrategier undersöktes för att analysera deras potential att minska topparna på grund av okontrollerad laddning. Förnybar energiproduktion från solcellsanläggningar integrerade med EV -laddare minskar importen av el från nätet under dagen vilket inte bara minskade förlusterna utan också kostnaderna för att importera el från nätet. Effekten av intermittency av solcellsgenerering genererades genom att implementera BESS. Vid lågprisperioder debiterades BESS med överskott av PV -effekt och vid högre prisperioder laddades BESS ur. Tre scenarier utvecklades, där referensscenariot hänvisar till basfallet utan PV och BESS, med PV -scenario endast betraktat PV -generering medan With PVBESS -scenario övervägde implementeringen av BESS med PV. Tre testfall simulerades för vart och ett av scenarierna, och det visade sig att genom implementering av smart laddning minskar förlusterna i nätverket med 35,5% och det minskade också avsevärt i alla andra scenarier. Genomförandet av smart laddning minskade kostnaden för elimport från nätet med 4,3%. Integrationen av PV -produktion ledde till en ytterligare minskning av förlusterna och kostnaderna för elimport med 7% jämfört med referensscenariot. Integrationen av BESS ökade förlusterna i nätet, men det förbättrade också självförbrukningen av PV-kraft. Genomförandet av smart laddning minskar inte bara förluster och kostnader vid import utan leder till besparingar i nätförstärkningskostnader.