1 |
Optimisation of energy recovery from domestic animal waste.Kazoka, Arthur January 2013 (has links)
M. Tech. Civil Engineering / Rural communities in South Africa and Africa as a whole are faced with a problem of the lack of reliable, efficient, sustainable and affordable energy sources. This problem serves as a catalyst to the slow economic development of the rural communities. In order to eradicate the problem and expedite economic development, a need exists to expand energy supply from the national grid or introduce alternative clean, sustainable, environmentally friendly and affordable energy sources to rural areas. However, expanding the national grid would not be sustainable in the long term because 80% of the national grid energy in South Africa is generated from burning fossil fuels, which is neither environmentally friendly nor renewable. The aim of this study was to address the above challenge through scientific investigation of the feasibility of introducing biogas as an alternative source of energy in rural areas. The investigation was to establish a mix ratio of the three types of domestic animal waste namely cow dung, pig dung and chicken droppings, which would optimise biogas production. Biogas, which is a mixture of mainly methane and carbon dioxide gases would in turn be used for cooking. Therefore, the broad objective of the study was to optimise methane gas production through the anaerobic digestion of domestic animal waste.
|
2 |
Biogas production from solid food waste and its use for electricity productionKhune, Selebogo Mervyn 15 October 2021 (has links)
M.Tech. (Department of Chemical Engineering, Faculty of Engineering and Technology), Vaal University of Technology. / An enormous amount of food waste (FW) is generated worldwide. Most of this waste is discarded in landfills, where it undergoes uncontrolled anaerobic digestion (AD) process, which emits excessive amounts of greenhouse gases, (methane and carbon dioxide), thereby contributing to global warming. A controlled AD of FW is key for organic waste management with a positive impact on the environment and economy. In South Africa (SA) there is little uptake of biogas technology for FW management due to little research on biogas potential at small to large scale. Furthermore, there is an over reliance on foreign data, which leads to misfit parameters to local raw materials; consequently, producing biogas of low quality and quantity with low degradation of waste. Biogas with poor quality reduces the efficiency of biogas conversion to energy and the low production rate makes the system less feasible. Considering the challenges faced with FW management and the little uptake of the AD technology in SA, this study aimed to treat FW through AD and convert the biogas produced to electricity. A complete-mix biogas pilot plant (VUT-1000C) was designed, constructed and commissioned. The materials used for constructing the pilot plant were sourced locally to prove the applicability of the AD technology in SA. The biodigester was operated at mesophilic temperature, 37 oC, aided by a solar system. A stand-alone 1 m3 plug-flow ambient biodigester (STH-1000A) was operated semi-continuously as well as a control. Cow dung (CD) was used to inoculate the biodigesters, which were then operated semi-continuously at their optimum organic loading rate (OLR). The STH-1000A digester was operated at 0.446 kgVS/m3/day OLR, according to the manufacturer’s specification, while for VUT-1000C, the OLR was determined. The highest biogas and methane yields obtained were 582 and 332 L/kgVS/m3, respectively, at the determined optimal OLR of 1.5 kgVS/m3/day for the VUT-1000C digester this was supported by the modified Gompertz model with an R2 value of 0.9836. VUT-1000C produced 1200 L/day while STH-1000A produced 150 L/day. VUT-1000C proved to be a more effective biodigester than STH-1000A owing to the digester design and operation at mesophilic conditions. The key design findings are higher reactor working volume and high digester temperature. From the 1000 L of biogas produced from VUT-1000C, 1.8 kW of electricity was generated, which is equivalent to powering 300 6W light bulbs for 1 hour. The energy balance of the pilot plant showed that only 10 percent of the energy output was required to operate the plant. These results show that SA has a 475 GWh energy potential based on the current FW figures. Furthermore, the study has shown that biogas technology is readily available for South Africans and that the designed biogas plant was very efficient in FW-to-energy conversion.
|
3 |
Microbial community analysis of a UASB reactor and application of an evolutionary algorithm to enhance wastewater treatment and biogas productionEnitan, Abimbola Motunrayo January 2015 (has links)
Submitted in complete fulfillment for the degree of Doctor of Philosophy (Biotechnology), Durban University of Technology, Durban, South Africa, 2015. / Anaerobic digestion, a proven and highly efficient biological process for treating industrial wastewater and biogas generation is an underutilized technology in South Africa. Some of the industries that have on-site anaerobic reactors tend to face problems in operating these reactors due to poor understanding of the process and implementation of the technology. This has resulted in high pollutant loads in their final effluents and low energy recovery. In this study, an on-site full–scale upflow anaerobic sludge blanket (UASB) reactor treating brewery wastewater was extensively monitored in order to evaluate the efficiency in terms of effluent quality, biogas production and microbial structure. Furthermore, developed and adopted kinetic models were used to optimize the performance of the full–scale UASB reactor using a combined Pareto differential evolution (CPMDE) algorithm.
A preliminary analysis of the raw wastewater has shown that the wastewater produced from the brewery industry was high in organic matter with a total chemical oxygen demand (COD) between 1096.41 to 8926.08 mg/L. The average removal efficiency of COD from the UASB reactor after treatment was 79% with a methane (CH4) production of 60-69% at temperature ranges of 28-32˚C and hydraulic retention time (HRT) of 12 h within the optimal pH range for anaerobic bacteria (6.6 and 7.3) under various organic loading rates. However, the results also showed an increase in total suspended solids (TSS), nitrogen (N2), ammonia (NH3) and orthophosphate concentrations when comparing the influent to the effluent, which indicated the necessity for further optimization of the reactor condition in order to reduce these effluent parameters to acceptable standards and to increase CH4 production.
In order to optimize the process, a thorough understanding of microbial interaction was essential. A combination of different molecular techniques viz., fluorescence in–situ hybridization (FISH), polymerase chain reaction (PCR) and quantitative real-time PCR (QPCR) were employed to understand the microbial community structure of the granular sludge samples using species specific primers and probes. The results revealed that the dominance of diverse groups of eubacteria belonging to phyla Proteobacteria, Firmicutes and Chloroflexi and an uncultured candidate division WS6 with four different orders of methanogenic Archaea viz., Methanomicrobiales,
Methanococcales, Methanobacteriales and Methanosarcinales belonging to hydrogenotrophic and aceticlastic methanogens were within the reactor samples. Quantification of the 16S rDNA copies of eubacteria and methanogenic Archaea using species-specific primers further confirmed the spatial distribution of these microorganisms within the different compartments of the reactor where, the upper compartments were dominated by eubacteria and the lower compartments by methanogenic Archaea. The concentration of Archaea per nanogram of DNA was much higher (96.28%) than eubacteria (3.78%) in lower compartments, while, the eubacteria concentration increased to 98.34% in upper compartments with a decrease in Archaea quantity (1.66%).
A modified kinetic methane generation model (MMGM) was developed on the basis of mass balance principles with respect to substrate (COD) degradation and the endogenous decay rate to predict CH4 production efficiency of the reactor. Furthermore, a Stover–Kincannon kinetic model was adopted with the aim of predicting the final effluent quality in terms of COD concentration and model coefficients were determined using the data collected from the full–scale reactor. Thereafter, a model-based multi-objective optimization was carried out using the CPMDE algorithm with three–objective functions namely; maximization of volumetric CH4 production rate; minimization of effluent substrate concentration and minimization of biomass washout, in order to increase the overall efficiency of the UASB reactor. Important decision variables and constraints related to the process were set for the optimization. A set of non-dominated solutions with high CH4 production rates of between 2.78 and 5.06 L CH4/g COD/day at low biomass washout concentrations were obtained at almost constant solution for the effluent COD concentration. A high COD removal efficiency (85-87%) at ~30-31˚C and 8-9 h HRT was obtained for the multi-objective optimization problem formulated.
This study could significantly contribute towards optimization of a full–scale UASB reactor treating brewery wastewater for better effluent quality and biogas production. Knowledge on the activity and performance of microbial community present in the granular sludge taken from the full–scale UASB reactor would contribute significantly to future optimization strategies of the reactor. In addition, optimization using an evolutionary algorithm under different operational conditions would help to save both time and resources wasted in operating anaerobic bioreactors.
|
4 |
Evaluation of water hyacinth (Eichhornia crassipes) suitability as feedstock for biogas productionMakofane, Rosina 08 1900 (has links)
The suitability of water hyacinth in biogas production was evaluated as a means of waste management in the interests of sustainable energy production. Batch anaerobic digestion (AD) of water hyacinth was conducted to determine the optimal pre-treatment method for maximum methane production. Physical pre-treatment methods produced a highest cumulative methane of 2.3 L during batch AD. The selected pre-treatment method, hand-cutting, was further evaluated in a semi-continuous AD using both mono- and co-digestion. The emphasis was on identifying microbial communities involved and their response to organic loading rates (OLRs). The Illumina Miseq results proved that bacterial communities were more sensitive to disturbances caused by irregular OLRs as compared to archaeal communities. In addition, the variation in substrate nutrients as a result of mono- and co-digestion of water hyacinth, contributed to variations in the bacterial diversity. For example, Bacteroides and Petrimonas diversity varied between mono- and co-digestion. Overall, the study verified that water hyacinth is a suitable feedstock for biogas production and the simple pre-treatment methods are recommended. Furthermore, OLRs influenced the microbial community structure and associated biogas yield. / National Research Foundation (South Africa) / Environmental Science / M. Sc. (Environmental Science)
|
5 |
Development of a Conceptual Framework for Adoption and Sustainable Utilization of Biogas as an Alternative Source of Energy for EmmissionUhunamure, Solomon Eghosa 20 September 2019 (has links)
PhD (Geography) / Department of Geography and Geo-Information Sciences / Improved access to modern affordable, sustainable and reliable energy supply is fundamental in the development of any economy and in the achievement of sustainable development goals. However, energy as a resource is increasingly and becoming scare in many countries and subsequently expensive, with a substantial impact on the socio-economic progress, especially in any country that lacks the financial, physical, social and human capital to secure its energy supply. Energy can also be produced though the anaerobic fermentation of biological waste, such as animal excrement, which is methane-rich. Fermentation also produces a nutrient-rich digestate. Biogas can be used for domestic purposes, such as cooking and heating. Furthermore, it can be converted into electricity. Biogas technology is of particular significance in rural households, where energy crisis are common. This thesis therefore aimed at developing an adoption and sustainable utilisation framework of biogas as an alternative source of energy for greenhouse gases emission reduction in the Limpopo Province. The sample involved 72 households with biogas digesters, which were purposively sampled and 128 households without digesters, which were randomly selected. The study was based on the primary data that were elicited using open and closed-ended questionnaires. Empirically, the results of this thesis developed a sustainable, simplified, appropriate and comprehensive framework for biogas adoption and utilisation, including an analysis of important factors that could influence the adoption of this desired technology, for cost-effectiveness and sustainability. / NRF
|
6 |
A techno-socio-economic potential assessment of organic waste-to- energy conversion through biogas technology for rural households in Vhembe District of LimpopoRasimphi, Thilivhali Eugene 02 February 2016 (has links)
MENVSC / Department of Ecology and Resource Management
|
Page generated in 0.0452 seconds