This study focused on experimentally measuring the performance of a fully cooled, scaled up C3X turbine vane. Experimental measurements focused on investigating row-to-row interactions of coolant jets and the contributions of external film cooling and internal impingement cooling to overall cooling effectiveness. Overall effectiveness was experimentally measured using a thermally scaled, matched Biot number vane model featuring a realistic internal impingement scheme and had normalized surface temperatures that were representative of those found on engine components. A geometrically identical vane was also constructed out of low conductivity polystyrene foam to measure the normalized adiabatic wall temperature, or adiabatic effectiveness of the film cooling configuration. The vanes featured a full coverage film-cooling scheme with a five-row showerhead and 13 total rows of holes containing 149 total coolant holes. This study was the first study to make highly detailed measurements of overall effectiveness on a fully-cooled vane model and expands on previous studies of adiabatic and overall effectiveness on the showerhead and single rows of holes on a matched Biot vane by considering a fully cooled configuration to determine if the results from these previous studies also hold for a fully cooled configuration. Additionally, velocity and thermal fields were measured just upstream of two different suction side rows of holes in order to study the effect of introducing upstream coolant injection. The effects of mainstream turbulence and span-wise location were examined and at the downstream row of holes, the contributions of different rows of holes to the approach flow were compared. This study was the first to measure mean and fluctuating velocity data on the suction side of a turbine vane with upstream coolant injection. Understanding the effects of how upstream injection affects the performance of downstream rows of holes is critical to understanding the film cooling performance on a fully cooled turbine airfoil. / text

This study focused on experimentally determining the cooling performance of a fully cooled, scaled-up model of a C3X turbine vane. The primary objective was to determine the differences in overall effectiveness in the presence and absence of a hot mainstream flowing over the vane. Overall effectiveness was measured using a thermally scaled matched Biot number vane with an impingement plate providing the internal cooling. This is the first study focused on investigating the effect of removing the mainstream flow and comparing the contour and laterally-averaged effectiveness data in support of the development of an assembly line thermal testing method. It was found that the proposed method of factory floor testing of turbine component cooling performance did not provide comparable information to traditional overall effectiveness test methods. A second experiment was performed in which the effect of altering the angle of attack of a flow into a passive turbulence generator was investigated. Measurements in the approach flow were taken using a single wire hot-wire anemometer. This study was the first to investigate the effects such a setup would have on fluctuating flow quantitates such as turbulence intensity and integral length scale rather than simply the mean quantities. It was found that both the downstream turbulence intensity and the turbulence integral length scale increase monotonically with approach flow incidence angle at a specified distance downstream of the turbulence generator. / text