- About
-
The Global ETD Search service is a free service for researchers
to find electronic theses and dissertations. This service is
provided by the
Networked Digital Library of Theses and Dissertations.
Our metadata is collected from universities around the world. If you manage a university/consortium/country archive and want to be added, details can be found on the NDLTD website.
Search results
Showing 51 to 60 of 1623 (0.016 seconds)| 51 |
Correlation of mechanical test parameters with fatigue crack growth rates in structural steelsDivsalar, F. January 1988 (has links)
No description available.
|
| 52 |
Processing, microstructure and properties of mullite-cordierite compositesEbadzadeh, Touradj January 1996 (has links)
No description available.
|
| 53 |
High speed double torsion testing of pipe grade polyethylenesWheel, Marcus A. January 1991 (has links)
No description available.
|
| 54 |
Mechanical properties of particle reinforced aluminaMorsi, Khaled M. B. E. January 1995 (has links)
No description available.
|
| 55 |
Crack analysis by distributed strain nuclei with application to indentation testingLin, Shiann January 1997 (has links)
No description available.
|
| 56 |
The application of the J-integral to stress corrosion crackingMackay, F. G. January 1987 (has links)
No description available.
|
| 57 |
Detection of cracks in cylinders using modal analysisWake, Richard Neil January 1997 (has links)
No description available.
|
| 58 |
Automated crack detection during cold headingOsman, K. A. January 1988 (has links)
No description available.
|
| 59 |
Structure-property relations in aluminium-lithium alloysNicholls, David John January 1989 (has links)
This work describes the effect of microstructure on the behaviour of small fatigue cracks in the two Al-Li-Cu-Mg-Zr alloys 8090 and 8091. The slip distribution in these alloys was varied through thermo-mechanical processing. Although slip distribution affected tensile, cyclic and long fatigue crack behaviour, it did not affect small fatigue crack behaviour due to low levels of closure and reduced slip reversibility near to a free surface. Similarly, underageing and overageing had no effect on small fatigue crack behaviour. Therefore, small fatigue crack growth is concluded to be insensitive to precipitate size and distribution. Due to differences in grain size, small fatique cracks in 8091 were observed to propagate twice as slowly as in 8090. Small fatigue cracks grew more rapidly than long fatigue cracks under the same nominal K and displayed no threshold behaviour. This was shown to be due to the combined effects of the low closure levels, high applied stresses and proximity to the surface. Corrections to K to account for these factors were shown to be less effective than using J as a correlating parameter. None of these factors affected the suitability of K for characterizing microstructural effects. Small and long fatigue crack data were comparable when plotted versus calculated plastic zone size. Low cycle fatigue behaviour was shown to be related to small fatigue crack behaviour and similar microstructural effects were observed. Total rather than plastic strain was identified as the critical parameter when comparing small fatigue crack and LCF behaviour. Small fatigue crack growth behaviour was shown to be inconsistent with the plastic work accumulation criterion for the exhaustion mechanism of fatigue. Finally, because of low K's and the lack of closure, fatigue mechanisms may be easier to study in small cracks than in long cracks. (D91005)
|
| 60 |
Fatigue of aluminium-lithium alloysDudgeon, Helen D. January 1990 (has links)
No description available.
|
Page generated in 0.0296 seconds