Spelling suggestions: "subject:"chain length distribution"" "subject:"shain length distribution""
1 |
Influence of Genome-Specific Granule-Bound Starch Synthase I (GBSSI/Waxy) on Starch Composition, Structure and In Vitro Enzymatic Hydrolysis in Wheat (Triticum aestivum L.)2013 November 1900 (has links)
Wheat grain quality and consumption is influenced by its constituents structure and concentrations. In the first part of the dissertation, six Canadian bread wheat cultivars; four (CDC Teal, AC Superb, AC Barrie, AC Splendor) belonging to the Canada Western Red Spring (CWRS), and two (AC Foremost, and AC Crystal) to the Canada Prairie Spring Red (CPSR) market classes were characterized for the relationship between their starch constituents and starch in vitro enzymatic hydrolysis. CPSR cultivars with relatively longer amylopectin chains of DP 37-45, reduced chain lengths of DP 15-18, and a low volume percent of small C-type starch granules, had reduced starch in vitro enzymatic hydrolysis rates. In the second part of the dissertation, near-isogenic wheat lines differing at the Waxy locus were analyzed for the influence of genome-specific granule-bound starch synthase I (GBSSI/Waxy; Wx-A, Wx-B, Wx-D) on starch composition, structure and starch in vitro enzymatic hydrolysis. Amylose concentration was more severely affected in genotypes with GBSSI missing from two genomes (double nulls) than from one genome (single nulls) of wheat, indicating dosage dependent amylose synthesis. Subtle differences in amylopectin chain length distribution were observed among non-waxy, partial and completely waxy starches, suggesting a non-limiting role of genome-specific GBSSI for amylopectin synthesis. A suppressive role of Wx-D on the short chain phenotype of wheat amylopectin was observed. In addition, Wx-D increased the volume percentage of large A-type starch granules and reduced starch hydrolysis index. Thus, among the waxy isoproteins, Wx-D might be the major contributor for reducing the rate of in vitro starch enzymatic hydrolysis in wheat. In the third part of the dissertation, endosperm starch’s physicochemical properties and structure during grain development in wheat waxy-null genotypes were analyzed. The study was conducted with pure starch isolated from wheat grains at 3-30 days post anthesis (DPA), at three day intervals. Changes in amylopectin structure were observed until 12 DPA, suggesting the formation of a basic amylopectin skeleton by this stage. A differential influence of waxy isoproteins on amylopectin structure formation has been suggested, with Wx-B and Wx-D affecting short glucan chains of DP 6-8 at 3 and 6 DPA, Wx-A being effective at 9 and 12 DPA, and Wx-D affecting DP 18-25 chains from 18-30 DPA.
|
2 |
Starch microstructure and functional properties in waxy rice (Oryza sativa L.)Rosa Cuevas Unknown Date (has links)
Rice starch contains two types of glucose polymers, mainly linear amylose and hyper-branched amylopectin. Waxy rice has been characterised by the lack of amylose, the proportion of which being one of the most important parameters measured for rice quality. Germplasm collection work conducted in the Lao People’s Democratic Republic has previously demonstrated the diversity of this type of rice in terms of quality. The definition of a waxy rice variety is dependent on the meaning of amylose. The conventional method for determining amylose content has shown that waxy rice could have up to 5% amylose. However, including a 0% amylose standard in the standard curve causes the amylose content of these varieties to become 0-2%. In this work, the absence of amylose in waxy rice has been determined through three different approaches. Granule-bound starch synthase I (GBSS1), the enzyme which synthesises amylose, was not detected in waxy rice. Long linear chains associated with amylose were also not detected by size exclusion chromatography (SEC). The absence of these long chains affected functional properties of waxy rice, as indicated by the differences in viscosity curves between waxy and non-waxy rice. Moreover, these waxy varieties themselves exhibit differences in their viscosity curves, another indication of the diversity in coking properties in these varieties. A new approach, the ‘lnP(N) technique’, in analysing chain length distributions was applied to varieties with known mutations in two of the enzymes involved in the synthesis of amylopectin, and in determining gelatinisation temperature. It was determined that the presence of a novel feature, an interruption to linearity at DP 18-24, of the lnP(N) plot was found in rice samples with mutations in the alk gene, which codes for starch synthase (SS) IIa, and in samples with inactive branching enzyme (BE) IIb. Single nucleotide polymorphisms (SNPs) in the gene coding for SSIIa have been associated with lowered gelatinisation temperature. On the other hand, non-functionality of BEIIb changes the amylopectin structure such that gelatinisation temperature is increased. The novel feature of the lnP(N) plot is found when either or both SSIIa and BEIIb are non-functional. Waxy rice starch has hot-water-soluble (HWS) and insoluble (HWI) components. It has been confirmed that the soluble polysaccharides are structurally different from phytoglycogen, and are similar to amylopectin. Structural differences between the two fractions, which can account for their differences in solubility, were determined. At the level of the chain length distribution, the HWI fraction contained long chains not found in the HWS fraction. Considerable amounts of sucrose and glucose were found in the HWS fraction. At another level of structure, the degree of branching of the HWS components was higher than in the HWI fraction. On the other hand, the whole molecules of the HWS fraction were smaller than those of the HWI fraction. These structural differences between the two fractions potentially affected their physical behaviour, particularly solubility. The amount of leached material appears to be a property of the method, as varying cooking conditions changed the amount of HWS components. This amount reaches equilibrium at certain conditions, indicating the limited amount of the HWS material. On the other hand, the HWI component contains molecules that are insoluble in water, rather than molecules that solubilise slowly. Given the stability of the HWS fraction in solution, the ratio of the HWS fraction to the HWI fraction could potentially be used in measuring quality if the amount of the HWS fraction is variety-specific. However, the quantity of the HWS fraction appears to be a feature of the starch, rather than of the variety. Nevertheless, the fact that the soluble fraction is structurally and thermodynamically different from the insoluble fraction could presumably be grounds to classify the soluble component as a group of molecules distinct from amylopectin.
|
3 |
Modeling of solution and surface–initiated atom transfer radical polymerizationMastan, Erlita 01 December 2015 (has links)
Controlled radical polymerization (CRP) can be viewed as the middle ground between living anionic polymerization (LAP) and conventional free radical polymerization (FRP). It combines the precise control over polymer structure offered by LAP, under a tolerant reaction condition similar to FRP. One of the most studied CRP is atom transfer radical polymerization (ATRP), with over 10,000 papers published since its introduction in 1995. Despite the numerous studies, knowledge on its fundamental mechanism is still lacking, as evident from the lack of expression for full MWD and polydispersity that account for termination reaction. Since termination is unavoidable in ATRP, the existing expressions give inaccurate predictions as dead chains accumulate. In this study, we derived expressions for full MWD at low conversion and for polydispersity. These expressions allow us to quantify and gain better understanding on the contribution of termination. In addition, the resulting polydispersity expression shows better agreement than the existing equation when correlated with experiment data.
In addition to the aforementioned questions, there are also controversies regarding the kinetics of surface-initiated ATRP, with researchers divided into two schools of theories. We evaluated the validity of these theories by comparing their predictions to experimental trends. Both theories were found to be inadequate in explaining all the experimental observations, thus triggering an investigation of the graft density. Graft density is an important determining property for polymer brushes, yet little is known about what affects its final value. Through simulations, we investigated the effect of experiment factors on the grafting density. A decrease in the amount of deactivator is found to decrease the grafting density, which could be explained by an increase in the number of monomers added per activation cycle. This knowledge allows us to explain the conflicting experiment observations regarding the growth trends of polymer layers reported in the literatures. / Thesis / Doctor of Philosophy (PhD) / Polymer materials are used almost everywhere in our daily life from clothing to water bottle. This wide range of applications owes to the nearly infinite possible properties that polymer can possess. Different polymerization processes to synthesize polymers have their own weaknesses and strengths. Herein we investigated the fundamental mechanism of one of the currently most attractive polymerization systems, atom transfer radical polymerization (ATRP). This process allows the synthesis of polymers with precisely tailored chain microstructures, making it possible to create polymer with sophisticated properties. Using modeling approaches, we derived explicit expressions for determining chain properties, allowing detailed investigation of how various factors affect these properties. Through these investigations, we obtained better understanding on the mechanism of ATRP in solution and on surface. This knowledge is crucial in providing insight and guiding experimental designs for better control over the material properties.
|
Page generated in 0.1272 seconds