Over the last decade, the miniaturization of analytical systems has become an increasingly important and interesting research area. Miniaturized systems offer many advantages, including reduced reagent and sample consumption, shorter analysis times, portability and disposability. This dissertation describes novel approaches in this direction, focusing on two areas: the miniaturization of existing column chromatographic systems and the development of microfluidic systems in which the separation is performed in a channel on a microchip. A new type of methacrylate-based monolithic capillary columns for liquid chromatography and capillary electrochromatography were prepared within the confines of fused-silica tubing using Starburst dendrimers to affect porosity. The polyamidoamine (PAMAM) dendrimers were incorporated into a solution of functionalized monomer, cross-linker, solvents, and polymerization initiator. Thermal polymerization, followed by the removal of solvent and dendrimers, produced a continuous rod of polymer with uniform porosity. Different column porosities were obtained by varying the amount of the dendrimer template. The chromatographic performance of these monolithic columns was evaluated using a peptides mixture obtained by tryptic digestion of chicken egg lysozyme. A distinct advantage of polymer monolithic stationary phases over conventional packed chromatographic beds is the ability to prepare them easily and rapidly via free radical polymerization within the channels of a microfluidic device. In this work, continuous polymeric beds were prepared within a channel of three different microchip substrates: glass, poly(dimethylsiloxane) and polycarbonate. The methacrylate-based monolith was cast in-situ via UV-initiated polymerization. The functionalization of the inner wall of the channel with methacryloyl groups enabled the covalent binding of the monolith to the wall. The morphology of the wall-anchored monolith was studied by SEM of chip sections, and by SEM of an extruded segment of non-anchored monolith from a separate chip. / Graduation date: 2005

An oscillating plasma glow discharge detector for gas chromatography is used to obtain fingerprint information about an analyte by combining both the average cell current and oscillation frequency signals. Five homologs each of the n-alkanes, 1-alkenes, 1-alkynes, 2-ketones and aldehydes are studied. Although triplicate determinations had some scatter due to noise, they showed clustering that allows several of these compounds to be distinguished from the others by using a two-dimensional plot of the ratios of frequency peak area to current peak area and frequency peak height to current peak height. Fingerprint identification information is improved by changing the cell pressure, applied voltage and electrode spacing. Changes in the discharge operating conditions produce changes in the analyte peak responses. The relative magnitudes of the analyte current and frequency peak responses also change with respect to each other under different discharge conditions. Unique fingerprints or patterns of responses are created for each analyte by changing the discharge operating conditions. The detector responses toward 10 organic compounds, representing seven different functional groups, are recorded under 56 different combinations of discharge conditions. The ratios of the frequency to current peak responses (heights and areas) for three of the 56 sets of conditions investigated provide enough information to distinguish between nine compounds. Principal component analysis and hierarchical cluster analysis, multivariate exploratory techniques, are used to observe natural clustering in the data. / Graduation date: 1994

The radial heterogeneity of some columns used in high performance liquid chromatography (HPLC) was investigated using an on-column microelectrochemical amperometric detector. Such a detector allowed the recording of the elution profiles at different spatial positions throughout the column exit cross-section. From this, we obtain information about the radial distribution of the mobile phase velocity, column efficiency, and analyte concentration. In all cases, the results obtained show that the spatial distribution of the mobile phase velocity does not follow a piston-flow behavior but exhibits radial heterogeneity with differences not exceeding 5% between the center and wall regions of any column. The efficiency was found to be lower in the wall region of the column than in its core region (the central core with a radius of 1/3 the column inner radius) by up to 40-50% in some columns. The radial distribution of the maximum concentration of the peaks varies throughout the column exit section, partially due to the radial variations of the column efficiency. The technology used in constructing the microelectrochemical detectors was further exploited to fabricate and incorporate an online detector array for a pressurized flat wide column measuring 10x10x0.1 cm in dimensions. Thus, unlike traditional thin layer chromatography, samples in this pressurized flat bed are completely eluted and detected in a time-based mode just like they are in HPLC. Also, a lateral arrangement of the detector array allows for an easy monitoring of the homogeneity of the flat wide column. Also, information on the surface properties of three novel chemically bonded phase packing materials for HPLC was obtained using solid state cross-polarization (CP) magic-angle spinning (MAS) nuclear magnetic resonance (NMR) spectroscopic experiments for the 29Si, and 13C nuclei. These packing materials were: Cogent bidentate C18 bonded to type-C silica, hybrid packing materials XTerra MS C18, and XBridge Prep. C18. The spectra obtained using cross-polarization magic angle spinning (CP-MAS) on the Cogent bidentate C18 bonded to type-C silica show the surface to be densely populated with hydride groups (Si-H), with a relative surface coverage exceeding 80%. The hybrid packing materials XTerra and XBridge gave spectra that reveal the silicon atoms to be bonded to alkyl moieties embedded in the molecular structure of these materials with over 90% of the alkyl silicon atoms found within the completely condensed silicon environments.

Thesis (M.Sc.)--Memorial University of Newfoundland, 2005. / Bibliography: leaves 63-67.

Thesis (M. Sc.)(Chemistry)--University of Pretoria, 2006. / Summaries in English and Afrikaans. Includes bibliographical references. Available on the Internet via the World Wide Web.

The main focus of this thesis is on hydrophilic interaction chromatography (HILIC) and the preparation of stationary phases for HILIC. The mechanism of HILIC is also discussed; a large part of the discussion has been adapted from a review written by me and professor Irgum for the Journal of Separation Science (ref 34). By reevaluating the literature we have revealed that the notion of HILIC as simply partitioning chromatography needed modification. However, our interest in the HILIC mechanism was mainly inspired by the need to understand how to construct the optimal HILIC stationary phase. The ultimate stationary phase for HILIC is still not found. My theory is that a non-charged stationary phase capable of retaining a full hydration layer even at extreme acetonitrile (> 85%) concentrations should give a HILIC stationary phase with a more pure partitioning retention behavior similar to that of a swollen C18 reversed phase. The preparation of a sorbitol methacrylate grafted silica stationary phase is one of our attempts at producing such a stationary phase. The preparation of such a grafted silica has been performed, but with huge difficulty and this work is still far from producing a column of commercial quality and reprodicibility. This thesis also discusses a new method for the initiation of atom transfer radical polymerization from chlorinated silica. This new grafting scheme theoretically results in a silica particle grafted with equally long polymer chains, anchored to the silica carrier by a hydrolytically stable silicon-carbon bond. The hydrolytic stability is especially important for HILIC stationary phases due to the high water concentration at the surface.

Increasing consumer awareness of food safety issues requires the development of highly sophisticated techniques for the authentication of food commodities. The food products targeted for falsification are either products of high commercial value or those produced in large quantities. For this reason, the present investigation is directed toward the characterization of coffee samples according to geographical origin attributes. In addition, the current examination is focused on the identification of particular marker compounds that compose the volatile and semivolatile aroma fraction of flavoured and dessert coffees. The conducted research involved the development of a rapid headspace solid phase microextraction (HS-SPME) – gas chromatography – time-of-flight mass spectrometry (GC-TOFMS) method for the verification of geographical origin traceability of coffee samples. As opposed to the utilization of traditional univariate optimization methods, the current study employs the application of multivariate experimental designs to the optimization of extraction-influencing parameters. Hence, the two-level full factorial first-order design aided in the identification of two influential variables: extraction time and sample temperature. The optimum set of conditions for the two variables was 12 min and 55 oC, respectively, as directed by utilization of the Doehlert matrix and response surface methodology. The high-throughput automated SPME procedure was completed under optimized conditions by implementing a single divinylbenzene/carboxen/polydimethylsiloxane (DVB/CAR/PDMS) metal fiber with excellent properties of durability, which ensured the complete analysis of coffee samples in sequence. The coffee sample originating from an authentic Brazilian coffee producing region and characterized by rich volatile and semivolatile chromatographic profiles was selected as a reference starting point for data evaluation. The combination of the retention index (RI) system using C8-C40 alkanes and the mass spectral library search was utilized for the confirmation of analyte identity in this reference sample. Twenty-nine volatile and semivolatile compounds selected across the wide range of GC chromatogram were then evaluated in terms of chromatographic peak areas for all samples that are to be submitted to this classification study. The semiquantitative results were submitted to statistical evaluation, namely principal component analysis (PCA) for the establishment of corresponding geographical origin discriminations.

Membrane extraction with a sorbent interface (MESI) is a sample preparation technique with a rugged and simple design allowing for solvent-free, on-line performance. When coupled to gas chromatography (GC), MESI is an extremely promising tool for the analysis of volatile organic compounds (VOCs), as it is selective and sensitive for detecting trace levels of analytes. A new calibration method to be used with the MESI technique is presented herein. The aim of this project was to characterize and quantify the biomarker ethylene in human breath and plant emissions. The MESI-GC system was optimized, and an external calibration curve for ethylene standard was obtained. Qualitative measures were obtained from emissions of the higher plant Arabidopsis thaliana. The dominant calibration method was validated by examining changes in mass transfer trends when flow and temperature conditions were altered. Finally, the dominant calibration method was used to quantify ethylene in real human breath samples from non-smoking and smoking volunteers. Results were consistent with those reported in literature. These findings suggest that the dominant calibration technique is a useful tool for monitoring ethylene in human breath and Arabidopsis.

Increasing consumer awareness of food safety issues requires the development of highly sophisticated techniques for the authentication of food commodities. The food products targeted for falsification are either products of high commercial value or those produced in large quantities. For this reason, the present investigation is directed toward the characterization of coffee samples according to geographical origin attributes. In addition, the current examination is focused on the identification of particular marker compounds that compose the volatile and semivolatile aroma fraction of flavoured and dessert coffees. The conducted research involved the development of a rapid headspace solid phase microextraction (HS-SPME) – gas chromatography – time-of-flight mass spectrometry (GC-TOFMS) method for the verification of geographical origin traceability of coffee samples. As opposed to the utilization of traditional univariate optimization methods, the current study employs the application of multivariate experimental designs to the optimization of extraction-influencing parameters. Hence, the two-level full factorial first-order design aided in the identification of two influential variables: extraction time and sample temperature. The optimum set of conditions for the two variables was 12 min and 55 oC, respectively, as directed by utilization of the Doehlert matrix and response surface methodology. The high-throughput automated SPME procedure was completed under optimized conditions by implementing a single divinylbenzene/carboxen/polydimethylsiloxane (DVB/CAR/PDMS) metal fiber with excellent properties of durability, which ensured the complete analysis of coffee samples in sequence. The coffee sample originating from an authentic Brazilian coffee producing region and characterized by rich volatile and semivolatile chromatographic profiles was selected as a reference starting point for data evaluation. The combination of the retention index (RI) system using C8-C40 alkanes and the mass spectral library search was utilized for the confirmation of analyte identity in this reference sample. Twenty-nine volatile and semivolatile compounds selected across the wide range of GC chromatogram were then evaluated in terms of chromatographic peak areas for all samples that are to be submitted to this classification study. The semiquantitative results were submitted to statistical evaluation, namely principal component analysis (PCA) for the establishment of corresponding geographical origin discriminations.

Membrane extraction with a sorbent interface (MESI) is a sample preparation technique with a rugged and simple design allowing for solvent-free, on-line performance. When coupled to gas chromatography (GC), MESI is an extremely promising tool for the analysis of volatile organic compounds (VOCs), as it is selective and sensitive for detecting trace levels of analytes. A new calibration method to be used with the MESI technique is presented herein. The aim of this project was to characterize and quantify the biomarker ethylene in human breath and plant emissions. The MESI-GC system was optimized, and an external calibration curve for ethylene standard was obtained. Qualitative measures were obtained from emissions of the higher plant Arabidopsis thaliana. The dominant calibration method was validated by examining changes in mass transfer trends when flow and temperature conditions were altered. Finally, the dominant calibration method was used to quantify ethylene in real human breath samples from non-smoking and smoking volunteers. Results were consistent with those reported in literature. These findings suggest that the dominant calibration technique is a useful tool for monitoring ethylene in human breath and Arabidopsis.