No description available.

This thesis presents research into ultra-low noise photonic microwave synthesis and the development of a novel, frequency comb-based, fibre optic time transfer technique. The focus in the first area is on reducing the noise introduced in the optical-to- electrical conversion process using balanced optical-microwave phase detectors. Two mainly free-space and two mainly fibre-based devices were built and their performance was characterised. The phase noise of the optical-to-electrical conversion of the free-space device was -119 dBc Hz⁻¹ at 1 Hz and -143 dBc Hz⁻¹ at 20 kHz from an 8 GHz carrier which is the best performance reported for a free-space balanced-optical microwave phase detector. The improved fibre-based set-ups demonstrated a state-of-the-art amplitude-to-phase noise suppression of 60 dB and a phase noise of the optical-to-electrical conversion of -131 dBc Hz⁻¹ at 1 Hz and 148 dBc Hz⁻¹ at 20 kHz from an 8 GHz carrier. The novel time transfer technique developed in the second part superimposes timing information onto the optical pulse train of an ITU-channel-filtered frequency comb using an intensity modulation scheme. Time transfer over a 50 km long, delay-stabilised fibre spool produced a state-of-the-art time deviation of 300 fs and an accuracy of approximately 0.01 ns which is close to the best performance achieved using amplitude modulated cw lasers. Using this technique on a 159 km long installed fibre link between NPL and Reading, the same time deviation was achieved and an accuracy of approximately 0.08 ns was obtained, limited by uncertainty of the time interval counter. Using the same fibre link, microwave frequency transfer of the ITU-channel-filtered comb was demonstrated with a fractional frequency instability of 2x10⁻¹⁷ at 5000 s which is approximately at the same level as the best previously reported results which were obtained with a 30 nm wide optical frequency comb.

No description available.