The Multi-Agency Radiation Survey and Site Investigation Manual (MARSSIM) requires that Final Status Surveys be performed on materials and surfaces that vary in surface smoothness and/or uniformity. To obtain accurate survey data, it may be necessary to adjust detector response for these surface variations. NUREG-1507 refers to such surface efficiency adjustment factors as ��[subscript s], the source efficiency. This parameter is meant to be a detector-independent, yet surface and nuclide-dependent parameter that can be used to adjust observed count rate to provide a true measure of the degree of contamination present. Key measurements in the calculation of (��[subscript s]) are the energy of the radionuclide contaminant and the average height of the detector above the contaminated surface. During the last year, Oregon State University, Department of Nuclear Engineering and Radiation Health Physics provided technical support for a Final Status Survey of a commercial nuclear plant. OSU NE/RHP has conducted research and experimentation to determine site-specific source efficiency (��[subscript s]) values for concrete surfaces which had undergone simulated decommissioning activities, such as surface scabbling. Source efficiency (��[subscript s]) values were determined for seven separate scabbled concrete surfaces which had been prepared using 5 tool types. Fourteen concrete cores were intentionally contaminated with known amounts of two beta emitting radionuclides: ��������Tl and ������Tc. The ��[subscript s] values were examined as a function of the type of scabbled surface as well as the contaminating nuclide. / Graduation date: 2003

Master of Science / Department of Grain Science and Industry / Bhadriraju Subramanyam / A synthetic zeolite (Odor-Z-Way, sodium aluminum silicate) used for odor adsorption was tested for its ability to control adults of stored-grain insects on wheat and on concrete petri dishes used to simulate floors of empty bins. Insect species tested included unsexed adults of the lesser grain borer, Rhyzopertha dominica (F.); rice weevil, Sitophilus oryzae (L.); maize weevil, Sitophilus zeamais (Motschuslky); red flour beetle, Tribolium castaneum (Herbst), and sawtoothed grain beetle, Oryzaephilus surinamensis (L.). Two formulations were evaluated under laboratory conditions (28±1⁰C and 65±1% r.h.): coarse zeolite (with 90% of particles having a mean diameter at or below 155 µm) and fine zeolite (with 90% of particles having a mean diameter at or below 47.0 µm). On concrete, arenas in 9-cm diameter Petri dishes were sprinkled with the synthetic zeolite to provide deposits of 0 (control), 5 and 10 g/m[superscript]2. Mortality was assessed at times ranging from 10 minutes to 24 hours followed by 48 hours recovery on wheat. Mortality in adults of the five species increased as the rate of application and the duration of exposure increased. Concrete Petri dishes sprinkled with the fine zeolite yielded percent mortality greater or equal to that observed with the coarse zeolite- sprinkled Petri dishes. Bioassays on wheat were conducted using two dosage rates: 0.1 to 3.0 g/kg for R. dominica and 0.05 to 1.0 g/kg for the other insect species. Mortality was assessed 7 days post- infestation. A concentration of 0.75 g/kg of fine or coarse zeolite achieved 100% mortality in adults of S. zeamais, T. castaneum, and O. surinamensis. All adults of S. oryzae were killed using 0.50 g/kg of coarse or fine zeolite. Adults of R. dominica were the least susceptible: 2.50 g/kg of fine zeolite and 3.0 g/kg of coarse zeolite were required for 100% mortality. Mortality generally increased with the concentration of zeolite applied on wheat. Efficacy was not related to particle size. This is the first study showing the efficacy of a synthetic zeolite against adults of five species of stored-product insects on concrete and wheat. Synthetic zeolites can be a suitable alternative to currently used pesticides for treatment of empty bin floors and stored wheat for insect control.