Inserts are a crucial part of household and industrial furniture. These small plastic parts which often go unnoticed to the naked eye perform crucial functions like providing a base for the furniture, leveling the furniture, safeguarding the user from edges of the tubes used and providing an aesthetic finish. The inserts have a wing like structure on the exterior which enables them to be inserted and securely held in the tubes. The inserts are assembled into the pipes manually or through machines. The force required to install these inserts in the tube is called a push-in force whereas a pull-out force is the force required for removal of the is called a pull-out force. These forces are experienced by someone who assembles the furniture together. Thus, these forces directly define the ease with which the furniture can be assembled. In the first part of the present thesis, these push-in and pull-out forces are predicted using finite element simulations. These finite element simulations were validated by performing physical assembly and disassembly experiments on these inserts. It was found that the finite element simulations of the insert are useful tool in predicting the push-in forces with a high accuracy.   These push-in and pull-out forces for a single insert vary by 2-5 times when the dimensional variations in the tube are considered. The dimensional variations can be a result of the manufacturing processes from which these tubes are produced. The maximum and minimum dimensions that the tube can have are defined by the maximum material condition (MMC) and the least material condition (LMC). To reduce the variation in push-in and pull out forces, a stricter tolerance control can be applied to the manufacturing process. To avoid this cost while having a lower variation in the push-in and pull out forces, the design of the insert was modified. To achieve this enhanced design of the insert, a metamodel based optimization technique was used in the second part of the thesis. For this optimization, the geometrical parameters - wing height, wing diameter and stem thickness the of the insert were identified as the crucial factors which govern the assembly/disassembly forces. The identification of these parameters was done through a design of experiments. These parameters were then varied simultaneously in a metamodel based optimization which had an objective to minimize the variation in forces observed for an insert when the maximum material condition and the least material conditions are considered. The result for the enhanced design of the insert was then stated in terms of the ratio of these identified parameters. The modified design of the insert not only enables the manufacturer to have better performance, but also reduces the amount of plastic material required for manufacturing of the insert.

Road vehicle tyres, railway wheels and ball bearings all generate rolling contact forces which are transferred within a finite area of contact between the rolling element and the substrate. Either it is visible or not for the human eye, a certain degree of roughness is always present on the contacting surfaces and it influences the generation of both vertical and lateral contactforces. The purpose of this investigation is to enhance the understanding and modelling of the influence from small-scale surface roughness on the generation of rolling contact forces. To this end, a computationally efficient method to include roughness-induced contact nonlinearities in the dynamic modelling of rolling contacts is proposed. The method is implemented in a time domain model for vertical wheel–track interaction to model rolling-induced rail vibrations, showing good agreement with measurements. Furthermore, a test rig is developed and used for the investigation of tyre–road rolling contact forces. Detailed studies are performed on the influence of substrate roughness on the resulting contact forces for a tyre tread block which is rolling at different operating conditions. The choice of substrate as well as the rolling velocity and the slip ratio is observed to have significant influence on the resulting friction coefficient. For high slip ratios, stick–slip oscillations appear, exhibiting frequency content which is largely dependent on the choice of substrate. The outcomes of this study can potentially be used to improve future tyre–road contacts with respect to wear, traction and noise generation. / <p>QC 20161013</p> / Centre for Eco2 Vehicle Design