This paper presents a new hybrid PAPR reduction technique for the OFDM signal, which combines a multiple symbol representations method with a signal clipping method. The clipping method is a nonlinear PAPR reduction scheme, where the amplitude of the signal is limited to a given threshold. Considering the fact that the signal must be interpolated before A/D conversion, a variety of clipping methods has been proposed. Some methods suggest the clipping before interpolation, having the disadvantage of the peaks re-growth. Other methods contributed that the clipping after interpolation, having the disadvantage of out-of-band power production. In order to overcome this problem different filtering techniques have been proposed. Filtering can also cause peak re-growth, but less than the clipping before interpolation. Another clipping technique supposes that only subcarriers having the highest phase difference between the original signal and its clipped variant will be changed. This is the case of the partial clipping method. To further reduce the PAPR, the dynamic of the clipped signal can be compressed. Linear methods like partial transmit sequence or selective mapping has been proposed for the reduction of PAPR as well. Another PAPR reduction method is the tone reservation. It uses tones on which no data is sent to reduce the transmitted signal peaks. Derivatives of this method with lower computation complexity and improved performance have been proposed: One-Tone One-Peak and one by-one iteration. A similar PAPR reduction method is the multiple symbol representations, where alternative signalling points are used to represent one symbol. The simulation results highlight the advantages of the proposed PAPR reduction method. / The proposed technique namely Adaptive Active Constellation Extension (Adaptive ACE) Algorithm reduced the high Peak-to-Average Power Ratio (PAPR) of the Orthogonal Frequency Division Multiplexing (OFDM) systems. The Peak-to-Average Power Ratio (PAPR) is equal to 6.8 dB for the target clipping ratios of 4 dB, 2 dB and 0 dB by using Adaptive Active Constellation Extension (Adaptive ACE) Algorithm. Thus, the minimum PAPR can be achieved for low target clipping ratios. The Signal-to-Noise Ratio (SNR) of the Orthogonal Frequency Division Multiplexing (OFDM) signal obtained by the Adaptive Active Constellation Extension (Adaptive ACE) algorithm is equal to 1.2 dB at a Bit Error Rate (BER) of 10-0..4 for different constellation orders like 4-Quadrature Amplitude Modulation (4-QAM), 16-Quadrature Amplitude Modulation (16-QAM) and 64-Quadrature Amplitude Modulation (16-QAM). Here, the Bit Error Rate of 10-0.4 or 0.398, that means a total of 398-bits are in error when 1000-bits are transmitted via a communication channel or approximately 4-bits are in error when 10-bits are transmitted via a communication channel, which is high when compared to that of the original Orthogonal Frequency Division Multiplexing (OFDM) signal. The other problems faced by the Adaptive Active Constellation Extension (Adaptive ACE) algorithm are Out-of-Band Interference (OBI) and peak regrowth. Here, the Out-of-Band Interference (OBI) is a form of noise or an unwanted signal, which is caused when the original Orthogonal Frequency Division Multiplexing (OFDM) signal is clipped for reducing the peak signals which are outside of the predetermined area and the peak regrowth is obtained after filtering the clipped signal. The peak regrowth results to, increase in the computational time and computational complexity. In this paper, we have proposed a PAPR reduction scheme to improve the bit error rate performance by applying companding transform technique. Hence, 1-1.5 dB reduction in PAPR with this Non-companding technique is achieved. In Future, We can accept to implement the same on Rician and Rayleigh channels. / Clement Ranjith Anthikkad (E-mail: clement.ranjith@gmail.com / clan11@bth.se) & Irfan Ahmed Baig (E-mail: baig.irfanahmed@gmail.com / ir-a11@bth.se )

Orthogonal frequency division multiplexing (OFDM) has become a very popular method for high-data-rate communication. However, it is well known that OFDM is plagued by a large peak-to-average power ratio (PAPR) problem. This high PAPR results in overdesigned power amplifiers, which amongst other things leads to inefficient amplifier usage, which is undesirable. Various methods have been recommended to reduce the PAPR of an OFDM transmission; however, all these methods result in a number of drawbacks. In this thesis, a novel method called offset modulation (OM-OFDM) is proposed to control the PAPR of an OFDM signal. The proposed OM-OFDM method does not result in a number of the drawbacks being experienced by current methods in the field. The theoretical bandwidth occupancy and theoretical bit error rate (BER) expression for an OM-OFDM transmission is derived. A newly applied power performance decision metric is also introduced, which can be utilised throughout the PAPR field, in order to compare various methods. The proposed OM-OFDM method appears to be similar to a well-known constant envelope OFDM (CE-OFDM) transmission. The modulation, structural and performance differences between an OM-OFDM and a CE-OFDM method are discussed. By applying the power performance decision metric, the OM-OFDM method is shown to offer significant performance gains when compared to CE-OFDM and traditional OFDM transmissions. In addition, the OM-OFDM method is able to accurately control the PAPR of a transmission for a targeted BER. By applying the power performance decision metric and complementary cumulative distribution function (CCDF), the proposed OM-OFDM method is shown to offer further performance gains when compared to existing PAPR methods, under frequency selective fading conditions. In this thesis, the OM-OFDM method has been combined with an existing active constellation extended (ACE) PAPR reduction method. To introduce a novel method called offset modulation with active constellation extension (OM-ACE), to control the PAPR of an OFDM signal. The theoretical BER expression for an OM-ACE transmission is presented and validated. Thereafter, by applying the decision metric and CCDF, the OM-ACE method is shown to offer performance improvements when compared to various PAPR methods. The use of OM-OFDM for cognitive radio applications is also investigated. Cognitive radio applications require transmissions that are easily detectable. The detection characteristics of an OM-OFDM and OFDM transmission are studied by using receiver operating characteristic curves. A derivation of a simplified theoretical closed-form expression, which relates the probability of a missed detection to the probability of a false alarm, for an unknown deterministic signal, at various signal-to-noise ratio (SNR) values is derived and validated. Previous expressions have been derived, which relate the probability of a missed detection to the probability of a false alarm. However, they have not been presented in such a generic closed-form expression that can be used for any unknown deterministic signal (for instance OFDM and OM-OFDM). Thereafter, an examination of the spectrum characteristics of an OM-OFDM transmission indicates its attractive detection characteristics. The proposed OM-OFDM method is further shown to operate at a significantly lower SNR value than an OFDM transmission, while still offering better detection characteristics than that of an OFDM transmission under Rician, Rayleigh and frequency selective fading channel conditions. In addition to its attractive PAPR properties, OM-OFDM also offers good detection characteristics for cognitive radio applications. These aspects make OM-OFDM a promising candidate for future deployment. / Thesis (PhD)--University of Pretoria, 2012. / Electrical, Electronic and Computer Engineering / unrestricted