Spelling suggestions: "subject:"1design manufacture"" "subject:"1design anufacture""
1 |
A NEW COMPREHENSIVE METHODOLOGY FOR THE EVALUATION OF PRODUCT SUSTAINABILITY AT THE DESIGN STAGE OF CONSUMER ELECTRONICS PRODUCTSde Silva, Niranjali 01 January 2005 (has links)
The aim of this thesis is to investigate and generate quantifiable measures of sustainability elements that apply to manufactured products in terms of environmental, social and economic benefits. This paper presents a new comprehensive methodology for sustainability evaluation of a new product at the design and development stage focusing on consumer electronics products through a Sustainability Scoring method. A new product is evaluated for its integral elemental and the overall sustainability contents impacting the product when it reaches the end-of-life by considering the entire life-cycle including the effective residual use of recovered materials in the subsequent life-cycles of the same or different products. This procedure can also be used by design engineers to assess a given product in comparison with a similar product, such as a prior or a subsequent model, or one from a competitor. The proposed six major integral sustainable elements are: products environmental impact, societal impact, functionality, resource utilization and economy, manufacturability and recyclability/remanufacturability. Each of these elements has corresponding sub-elements and influencing factors which are categorized using appropriate weighting factors according to their relative importance to the product.
|
2 |
Aggregate process planning and manufacturing assessment for concurrent engineeringBradley, Hugh D. January 1997 (has links)
The introduction of concurrent engineering has led to a need to perform product development tasks with reduced information detail. Decisions taken during the early design stages will have the greatest influence on the cost of manufacture. The manufacturing requirements for alternative design options should therefore be considered at this time. Existing tools for product manufacture assessment are either too detailed, requiring the results of detailed design information, or too abstract, unable to consider small changes in design configuration. There is a need for an intermediate level of assessment which will make use of additional design detail where available, whilst allowing assessment of early designs. This thesis develops the concept of aggregate process planning as a methodology for supporting concurrent engineering. A methodology for performing aggregate process planning of early product designs is presented. Process and resources alternatives are identified for each feature of the component and production plans are generated from these options. Alternative production plans are assessed in terms of cost, quality and production time. A computer based system (CESS, Concurrent Engineering Support System) has been developed to implement the proposed methodology. The system employs object oriented modelling techniques to represent designs, manufacturing resources and process planning knowledge. A product model suitable for the representation of component designs at varying levels of detail is presented. An aggregate process planning functionality has been developed to allow the generation of sets of alternative plans for a component in a given factory. Manufacturing cost is calculated from the cost of processing, set-ups, transport, material and quality. Processing times are calculated using process specific methods which are based on standard cutting data. Process quality cost is estimated from a statistical analysis of historical SPC data stored for similar operations performed in the factory, where available. The aggregate process planning functionality has been tested with example component designs drawn from industry.
|
3 |
Application Of Parametric Design To User Center ProductsTu, Yu-Wei 15 October 2013 (has links)
No description available.
|
Page generated in 0.0335 seconds