No description available.

This investigation concerns the validity and feasibility of using moduli reduction to monitor the effect of fatigue damage in graphite epoxy composites. Five laminate orientations were considered, [O]₄, [90]₄, [±45]_s, [0,90]_s, [0,90,±45]_s, and four inplane-stiffness properties were monitored for each. The stiffness parameters were E_xx, E_yy, G_xy, and v_xy, and were measured using a longitudinal tension test, a rail shear test and a transverse bend test. Nondestructive testing techniques such as C-scan and edge replication were also performed to aid in the observation of damage development. Results describe the response of each laminate orientation in tension-tension fatigue, including a record of changes in the stiffness properties at intervals during fatigue. Longitudinal stiffness (E_xx) and shear stiffness (G_xy) were shown to significantly decrease for the [0,90,±45]_s, laminate following fatigue loading. The inplane stiffness properties for the other four laminates remain essentially unchanged following fatigue loading. Matrix cracking and delamination appears to contribute to the stiffness reductions that occur in the [0,90,±45]_s laminate. / Master of Science

The thermal expansion behavior of Graphite/Epoxy Laminates between 116 and 366 degrees Kelvin was investigated using a novel implementation of the Priest interferometer concept. This thesis describes the design, construction and use of the interferometer along with the experimental results it was used to generate. The experimental program consisted of 25 tests on 25.4 mm and 6.35 mm wide, 8-ply quasi-isotropic T300/5208 graphite/epoxy specimens and 3 tests on a 25.4 mm wide unidirectional specimen. Experimental results are presented for all tests along with a discussion of the interferometer's limitations and some possible improvements in its design. / Master of Science

This study consisted of two main parts, the thermoviscoelastic characterization of Kevlar 49/Fiberite 7714A epoxy composite lamina and the development of a numerical procedure to predict the viscoelastic response of any general laminate constructed from the same material. The four orthotropic material properties, S₁₁, S₁₂, S₂₂, and S₆₆, were characterized by 20 minute static creep tests on unidirectional ([0]₈, [10]₈, and [90]₁₆) lamina specimens. The Time-Temperature-Superposition-Principle (TTSP) was used successfully to accelerate the characterization process. A nonlinear constitutive model was developed to describe the stress dependent viscoelastic response for each of the material properties. A new numerical procedure to predict long term laminate properties from lamina properties (obtained experimentally) was developed. Numerical instabilities and time constraints associated with viscoelastic numerical techniques were discussed and solved. The numerical procedure was incorporated into a user friendly microcomputer program called Viscoelastic Composite Analysis Program (VCAP), which is available for IBM ‘PC’ type computers. The program was designed for ease of use and includes graphics, menus, help messages, etc. The final phase of the study involved testing actual laminates constructed from the characterized material, Kevlar/epoxy, at various temperature and load levels for 4 to 5 weeks. These results were then compared with the VCAP program predictions to verify the testing procedure (i.e., the applicability of TTSP in characterizing composite materials) and to check the numerical procedure used in the program. The actual tests and predictions agreed, within experimental error and scatter, for all test cases which included 1, 2, 3, and 4 fiber direction laminates. The end result of the study was the development and validation of a user friendly microcomputer program that can be used by design engineers in industry to predict thermoviscoelastic properties of orthotropic composite materials. / Ph. D.