Within the past few decades a new technology has emerged using Fiber Reinforced Polymers (FRP) to rehabilitate and retrofit reinforced concrete (RC) structures. In FRP shear strengthening applications it is largely recognized that debonding is the prevailing failure mode. FRP debonding typically occurs prematurely as a brittle failure mode that limits the efficiency of the strengthening technique. No systematic tests have been conducted to investigate the capacity gained by anchoring FRP laminates to RC elements in shear applications. The objective of this research program was to study the effects of anchoring FRP laminates to RC members with FRP anchors thereby delaying or potentially eliminating debonding of FRP sheets from the concrete surface. FRP anchors used in this research were made from fibers used as part of FRP sheets that get bundled into a roll with a fanned upper end of the anchor allowing the fibers to be splayed over the FRP sheet. A single shear pull test experiment was developed to study the effects of anchoring FRP laminates using FRP anchors with varying anchor diameters, lengths, and patterning. The results of the experimental portion of this research project were used in combination with finite element analyses to develop models for anchored FRP sheets that can be used in design of shear strengthening applications.

Over the past three decades the use of externally bonded fiber reinforced polymer (FRP) materials for structural strengthening applications has become an accepted and widely used method. A primary concern of FRP structural strengthening systems is that the FRP often debonds from the concrete well before the load capacity of the FRP material is reached. In addition, debonding failures are often brittle and occur with little warning. Past research concluded that fastening FRP sheets with FRP anchors is an effective method for delaying or preventing debonding failures. However, there is a clear lack of research pertaining to fastening FRP sheets with FRP anchors, and a corresponding lack of design guidance. The primary objective of this research program was to better understand the behavior of bonded FRP sheets that are secured with FRP anchors to aid in future development of design recommendations of this anchorage system. This thesis deals with carbon fiber unidirectional sheets applied using the wet layup system. Design parameters that were investigated include: manufacturer of the FRP materials, unanchored and anchored sheets, number of anchor rows and spacing between rows, number of sheet plies (single or double), and length of bonded sheet behind the anchors. A total of sixteen specimens were tested. Experimental results show that FRP anchorage systems are very effective in increasing load capacity by delaying debonding. Finite element models were also developed of anchored and unanchored bonded FRP sheets.