Thesis (Ph. D.)--State University of New York at Binghamton, Thomas J. Watson School of Engineering and Applied Science, Systems Science Dept., 2004 / Only abstract available. "At the request of the author, this graduate work is not available for purchase." Includes bibliographical references.

No description available.

No description available.

Dissertation (Ph.D.)--Auburn University, 2006. / Abstract. Vita. Includes bibliographic references (p.91-95).

Thesis(M.S.)--Auburn University, 2007. / Abstract. Vita. Includes bibliographic references.

Dissertation (Ph.D.)--Auburn University, 2005. / Abstract. Vita. Includes bibliographic references.

Dissertation (Ph.D.)--Auburn University, 2006. / Abstract. Vita. Includes bibliographic references.

Thesis (Ph. D.)--State University of New York at Binghamton, Thomas J. Watson School of Engineering and Applied Science, Department of Systems Science and Industrial Engineering, 2007. / Includes bibliographical references.

Environmental stress tests, or accelerated life tests, apply stresses to electronic packages that exceed the stress levels experienced in the field. In theory, these elevated stress levels are used to generate the same failure mechanisms that are seen in the field, only at an accelerated rate. The methods of assessing reliability of electronic packages can be classified into two categories: a statistical failure based approach and a physics of failure based approach. This research uses a statistical based methodology to identify the critical factors in reliability performance of a flip chip on board component level assembly and a physics of failure based approach to develop a low cycle strain based fatigue equation for flip chip component level assemblies. The critical factors in determining reliability performance were established via experimental investigation and their influence quantified via regression analysis. This methodology differs from other strain based fatigue approaches because it is not an empirical fit to experimental data; it utilizes regression analysis and least squares to obtain correction factors, or correction functions, and constants for a strain based fatigue equation, where the total inelastic strain is determined analytically. The end product is a general flip chip on board equation rather than one that is specific to a certain test vehicle or material set.

Avatrel 8000P's excellent photo-definition properties and mechanical strength make it an ideal polymer collar material. Avatrel 8000P is a high contrast, I-line sensitive mixture that can be developed in traditional aqueous-base developers. The great photolithographical performance of this photopolymer can be partly contributed to the minimal amount of light absorbed by the base norbornene polymer. The processing conditions noted in this work are an optimized version, which have been shown to give superior photolithographical performance. The simple baking procedures make Avatrel 8000P easier to process than SU-8. The ability to develop Avatrel 8000P in aqueous base can reduce chemical waste. As shown by SEM images, high fidelity structures with aspect ratios of 7:1 can be fabricated in thick films with vertical sidewalls. Bonding between two copper surfaces over various gap sizes was achieved by electroless deposition without the addition of surfactants or inhibitors in the bath. The effect of anneal temperature on the electroless bond formed was analyzed. The electroless bond strength increased with anneal temperature. However, the bond strength estimation for samples annealed at 80°C to 120°C is a minimum value due to the failure location of most of the pillars and the resulting area used in the calculation of bond strength. Grain growth from copper recrystallization and removal of small defects improve the bond strength. Large voids at the interface of the two pillars were related to rough starting surfaces for the electroplated pillars.