The continuous microreactor-assisted solution deposition (MASD) process was used for the deposition of CdS thin films on fluorine-doped tin oxide (FTO) glass. The MASD system, including a T-junction micromixer and a microchannel heat exchanger is capable of isolating the homogeneous particle precipitation from the heterogeneous surface reaction. The results show a dense nanocrystallite CdS thin films with a preferred orientation at (111) plane. Focused-ion-beam was used for TEM specimen preparation to characterize the interfacial microstructure of CdS and FTO layers. The band gap of the microreactor-assisted deposited CdS film was determined at 2.44 eV. X-ray Photon Spectroscopy show the bindings of energies of Cd 3d₃/₂, Cd 3d₅/₂, S 2p₃/₂ and S 2p₁/₂ at 411.7 eV, 404.8 eV, 162.1 eV, and 163.4 eV, respectively. The film growth kinetics was studied by measuring the film thickness deposited from 1 minute to 15 minutes in physical (FIB-TEM) and optical (reflectance spectroscopy) approaches. A growth model that accounts for the residence time in the microchannel using empirical factor (η) obtained from previous reported experimental data. Applying this factor in the proposed modified growth model gives a surface reaction rate of 1.61*10⁶ cm⁴ mole⁻¹s⁻¹, which is considerable higher than the surface reaction rates obtained from the batch CBD process. With the feature of separating homogeneous and heterogeneous surface reaction, the MASD process provides the capability to tailor the surface film growth rate and avoid the saturation growth regime in the batch process. An in situ spectroscopy technique was used to measure the UV-Vis absorption spectra of CdS nanoparticles formed within the continuous flow microreactor. The spectra were analyzed by fitting the sum of three Gaussian functions and one exponential function in order to calculate the nanoparticle size. This deconvolution analysis shows the formation of CdS nanoparticles range from 1.13 nm to 1.26 nm using a residence time from 0.26 s to 3.96 s. Barrier controlled coalescence mechanism seems to be a reasonable model to explain the experimental UV-Vis data obtained from the continuous flow microreactor, with a rate constant k' value of 2.872 s⁻¹. Using CFD, low skewness value of the RTD curve at high flow rate (short τ) suggests good radial mixing at high flow rate is responsible for the formation of smaller CdS nanoparticles with a narrower size distribution. The combination of CdS nanoparticle solution with MASD process resulted in the hindrance of CdS thin film deposition. It is hypothesized that the pre-existing sulfide (S²⁻) ions and CdS nanoparticles changes the chemical species equilibrium of thiourea hydrolysis reaction. Consequently, the lack of thiourea slows down the heterogeneous surface reaction. To test the scalability of the MASD process, a flow cell and reel-to-reel (R2R)-MASD system were setup and demonstrated for the deposition of CdS films on the FTO glass (6" x 6") substrate. The film deposition kinetics was found to be sensitive to the flow conditions within the heat exchanger and the substrate flow cell. The growth kinetics of the CdS films deposited by R2R-MASD process was investigated by with a deposition time of 2.5 min, 6.3 min, and 9 min. In comparison with the continuous MASD process, the growth rate in R2R-MASD is higher, however more difficult to obtain a linear relationship with the deposition time. / Graduation date: 2012 / Access restricted to the OSU Community at author's request from Jan. 13, 2012 - Jan. 13, 2013

Abstract Obesity is associated with greater risk of several diseases, such as type 2 diabetes and metabolic syndrome. Single nucleotide polymorphisms (SNP) within the fat mass- and obesity-associated gene FTO are robustly associated with increased body mass index (BMI) in several age and ethnic groups. Studies with transgenic mice support a mechanistic role for FTO protein in energy metabolism. Fto-deficient mice are leaner than wild-type and overexpression of Fto leads to obese phenotype; however, the precise mechanism of FTO action in the control of BMI has remained obscure. Fto mRNA is most abundant in the brain while high expression is present also in white and brown adipose tissues (WAT and BAT, respectively). WAT stores the nutritional energy and BAT dissipates it to produce heat. Furthermore, these organs participate in a complex endocrine network affecting the whole body metabolism, which is more or less disrupted in obesity. In the browning process, white adipocytes begin to manifest brown characteristics. MicroRNAs (miRNA) are small RNA molecules, which fine-tune post-transcriptionally the expression of genes important in several cellular processes, including WAT and BAT differentiation and browning of WAT. FTO has been shown to participate in these processes as well as miRNA regulation. The current study used a new Fto-deficient mouse model to reveal deeper insights into the role of Fto on genes affecting WAT and BAT differentiation and function, as well as WAT browning. Furthermore, the effects of Fto on the miRNA regulation in WAT browning and BAT were investigated. Our results supported a role for Fto in adipose tissue. Fto-deficient mice were resistant to diet-induced obesity and their WAT and BAT adipocytes did not become hypertrophic similar to wild-type on high-fat diet. Furthermore, the expression of genes affecting adipose tissue differentiation and function was altered in Fto-deficient WAT and BAT, especially after high-fat diet, and the changes may be mediated via altered miRNA expression. Fto-deficient WAT was more susceptible to browning, which in part contributed to the lean phenotype of these mice. Current study supported a role for Fto in whole body metabolism and adaptation of adipose tissue to changes in dietary environment. / Tiivistelmä Lihavuus on toistuvasti yhdistetty useisiin liitännäissairauksiin, kuten tyypin 2 diabetekseen ja metaboliseen oireyhtymään. FTO-geenissä (fat mass- and obesity-associated) esiintyvien yhden nukleotidin muutoksien (single nucleotide polymorphia, SNP) on useissa ikä- ja etnisissä ryhmissä raportoitu liittyvän korkeampaan painoindeksiin ihmisillä. Muuntogeenisillä hiirillä tehdyt tutkimukset tukevat FTO:n mekanistista roolia energia-aineenvaihdunnassa, sillä Fto-poistogeeniset hiiret ovat villityypin hiiriä laihempia ja sen yliekspressio johtaa ylipainoon. FTO:n tarkka rooli painon säätelyssä on kuitenkin vielä epäselvä. Fto:ta tuotetaan eniten aivoissa, mutta myös valkoisessa ja ruskeassa rasvassa. Valkoinen rasva varastoi ravinnosta saatavan energian ja ruskea hajottaa sitä lämmöntuotantoon. Näillä kudoksilla on lisäksi tärkeä rooli energia-aineenvaihdunnan monimutkaisessa verkostossa. Valkoisen rasvakudoksen ruskettumisprosessissa valkoiset rasvasolut alkavat muistuttaa ruskeita rasvasoluja. Mikro-RNA:t (miRNA) ovat pieniä RNA-juosteita, jotka hienosäätävät geenien ekspressiota transkription jälkeen ja vaikuttavat useisiin solun tärkeisiin tapahtumiin, myös valkoisen ja ruskean rasvasolun erilaistumiseen ja ruskettumiseen. FTO osallistuu näihin prosesseihin sekä miRNA-säätelyyn. Tämän tutkimuksen tavoitteena oli selventää Fto:n roolia valkoisen ja ruskean rasvakudoksen erilaistumisessa ja toiminnassa Fto-poistogeenisen hiirimallin avulla. Lisäksi selvitettiin Fto:n vaikutuksia valkoisen rasvan ruskettumiseen ja ruskean rasvan toimintaan osallistuvien miRNA:iden säätelyyn. Tulokset tukivat FTO:n roolia rasvakudoksessa. Fto-poistogeeniset hiiret eivät lihoneet rasvaisella ruokavaliolla eivätkä niiden rasvasolut varastoineet rasvaa yhtä paljon kuin villityypin hiirillä rasvaisen ruokavalion jälkeen. Lisäksi Fto-poistogeenisen rasvakudoksen erilaistumiseen ja toimintaan liittyvien geenien esiintyvyys muuttui erityisesti rasvaisella ruokavaliolla. Nämä muutokset voivat osittain selittyä muuttuneella miRNA-säätelyllä. Tulokset viittasivat siihen, että Fto-poistogeeninen valkoinen rasvakudos oli alttiimpaa ruskettumiselle, mikä osaltaan vaikutti Fto-poistogeenisten hiirten laihuuteen. Tutkimus tuki Fto-geenin roolia energia-aineenvaihdunnan säätelyssä sekä rasvakudoksen mukautumisessa ruokavalion muutoksiin.

The work deals with the deposition of layers for electrochromic device with different methods. Transparent electrically conductive layer of SnO2 was deposited by pyrolytic decomposition of peroxostannate solution. Hydrogen peroxide in starting solution contributes to the oxidation process of growth layers and to increase the electrical conductivity. Active electrochromic layer of WO3 was electrolytic deposited from the peroxotungstic acid solution. Optimal deposition time and the optimal annealing temperature of deposited layers were found. Passive electrochromic layer of V2O5 was deposited using dip-coating method from peroxovanadate solution. A contribution of solution diluted with distilled water was investigated. Found results were used to construct complete electrochromic device with polymer gel electrolyte.

Diss. (sammanfattning) Umeå : Umeå universitet, 2010. / Härtill 4 uppsatser. Även tryckt utgåva.