The primary focus of this thesis is to examine the detailed seismic structure of the northern Cascadia margin, including the Cascadia basin, the deformation front and the continental shelf. The results of this study are contributing towards understanding sediment deformation and tectonics on this margin. They also have important implications for exploration of hydrocarbons (oil and gas) and natural hazards (submarine landslides, earthquakes, tsunamis, and climate change). The first part of this thesis focuses on the role of gas hydrate in slope failure observed from multibeam bathymetry data on a frontal ridge near the deformation front off Vancouver Island margin using active-source ocean bottom seismometer (OBS) data collected in 2010. Volume estimates (∼ 0.33 km^3) of the slides observed on this margin indicate that these are capable of generating large (∼ 1 − 2 m) tsunamis. Velocity models from travel time inversion of wide angle reflections and refractions recorded on OBSs and vertical incidence single channel seismic (SCS) data were used to estimate gas hydrate concentrations using effective medium modeling. Results indicate a shallow high velocity hydrate layer with a velocity of 2.0 − 2.1 km/s that corresponds to a hydrate concentration of 40% at a depth of 100 m, and a bottom simulating reflector (BSR) at a depth of 265 − 275 m beneath the seafloor (mbsf). These are comparable to drilling results on an adjacent frontal ridge. Margin perpendicular normal faults that extend down to BSR depth were also observed on SCS and bathymetric data, two of which coincide with the sidewalls of the slump indicating that the lateral extent of the slump is controlled by these faults. Analysis of bathymetric data indicates, for the first time, that the glide plane occurs at the same depth as the shallow high velocity layer (100±10 mbsf). In contrast, the glide plane coincides with the depth of the BSR on an adjacent frontal ridge. In either case, our results suggest that the contrast in sediments strengthened by hydrates and overlying or underlying sediments where there is no hydrate is what causing the slope failure on this margin. The second part of this dissertation focuses on obtaining the detailed structure of the Cascadia basin and frontal ridge region using mirror imaging of few widely spaced OBS data. Using only a small airgun source (120 cu. in.), our results indicate structures that were previously not observed on the northern Cascadia margin. Specifically, OBS migration results show dual-vergence structure, which could be related to horizontal compression associated with subduction and low basal shear stress resulting from over-pressure. Understanding the physical and mechanical properties of the basal layer has important implications for understanding earthquakes on this margin. The OBS migrated image also clearly shows the continuity of reflectors which enabled the identification of thrust faults, and also shows the top of the igneous oceanic crust at 5−6 km beneath the seafloor, which were not possible to identify in single-channel and low-fold multi-channel seismic (MCS) data. The last part of this thesis focuses on obtaining detailed seismic structure of the Vancouver Island continental shelf from MCS data using frequency domain viscoacoustic full waveform inversion, which is first of its kind on this margin. Anelastic velocity and attenuation models, derived in this study to subseafloor depths of ∼ 2 km, are useful in understanding the deformation within the Tofino basin sediments, the nature of basement structures and their relationship with underlying accreted terranes such as the Crescent and the Pacific Rim terranes. Specifically, our results indicate a low-velocity zone (LVZ) with a contrast of 200 m/s within the Tofino basin sediment section at a depth 600 − 1000 mbsf over a lateral distance of 10 km. This LVZ is associated with high attenuation values (0.015 − 0.02) and could be a result of over pressured sediments or lithology changes associated with a high porosity layer in this potential hydrocarbon environment. Shallow high velocities of 4 − 5 km/s are observed in the mid-shelf region at depths > 1.5 km, which is interpreted as the shallowest occurrence of the Eocene volcanic Crescent terrane. The sediment velocities sharply increase about 10 km west of Vancouver Island, which probably corresponds to the underlying transition to the Mesozoic marine sedimentary Pacific Rim terrane. High attenuation values of 0.03 − 0.06 are observed at depths > 1 km, which probably corresponds to increased clay content and the presence of mineralized fluids. / Graduate / 0373 / 0372 / 0605 / subbarao@uvic.ca

Humanitarian clearance of minefields is most often carried out by hand, conventionally using a a metal detector and a probe. Detection is a very slow process, as every piece of detected metal must treated as if it were a landmine and carefully probed and excavated, while many of them are not. The process can be safely sped up by use of Ground-Penetrating Radar (GPR) to image the subsurface, to verify metal detection results and safely ignore any objects which could not possibly be a landmine. In this thesis, we explore the possibility of using Full Wave Inversion (FWI) to improve GPR imaging for landmine detection. Posing the imaging task as FWI means solving the large-scale, non-linear and ill-posed optimisation problem of determining the physical parameters of the subsurface (such as electrical permittivity) which would best reproduce the data. This thesis begins by giving an overview of all the mathematical and implementational aspects of FWI, so as to provide an informative text for both mathematicians (perhaps already familiar with other inverse problems) wanting to contribute to the mine detection problem, as well as a wider engineering audience (perhaps already working on GPR or mine detection) interested in the mathematical study of inverse problems and FWI.We present the first numerical 3D FWI results for GPR, and consider only surface measurements from small-scale arrays as these are suitable for our application. The FWI problem requires an accurate forward model to simulate GPR data, for which we use a hybrid finite-element boundary-integral solver utilising first order curl-conforming N\'d\'{e}lec (edge) elements. We present a novel `line search' type algorithm which prioritises inversion of some target parameters in a region of interest (ROI), with the update outside of the area defined implicitly as a function of the target parameters. This is particularly applicable to the mine detection problem, in which we wish to know more about some detected metallic objects, but are not interested in the surrounding medium. We may need to resolve the surrounding area though, in order to account for the target being obscured and multiple scattering in a highly cluttered subsurface. We focus particularly on spatial sensitivity of the inverse problem, using both a singular value decomposition to analyse the Jacobian matrix, as well as an asymptotic expansion involving polarization tensors describing the perturbation of electric field due to small objects. The latter allows us to extend the current theory of sensitivity in for acoustic FWI, based on the Born approximation, to better understand how polarization plays a role in the 3D electromagnetic inverse problem. Based on this asymptotic approximation, we derive a novel approximation to the diagonals of the Hessian matrix which can be used to pre-condition the GPR FWI problem.