iii, 260 leaves : ill., charts & maps in back pocket / Title page, contents and abstract only. The complete thesis in print form is available from the University Library. / Thesis (Ph.D.1970) from the Dept. of Geology, University of Adelaide

A major change in sedimentary and structural style occurs in Eocene strata exposed along the southern margin of the Oregon Coast Range. Lithofacies of the early Tertiary Umpqua Group have been described, mapped and assigned to likely depositional environments. Submarine fan and slope facies (upper Roseburg Formation) overlie Paleocene basaltic basement rocks to the north, whereas fluvial, deltaic and shallow marine facies (Lookingglass Formation) overlie Franciscan-equivalent strata to the south along the flank of the Klamath Mountains. These two depositional systems are gradational into one another, and were prograding northwestward until about 52 Ma. Means of clast compositions from sandstones and conglomerates from both the Roseburg and Lookingglass Formations suggest derivation from identical recycled orogen or arc-continent collision sources in the Klamath Mountains. Change from Klamath-parallel to more north-south structural trends is well displayed within early Eocene strata of the Umpqua Group. Five major fault systems involve lower Umpqua (Roseburg and Lookingglass) strata, and were active while deposition was taking place. All these faults ceased to be active at about 52-50 Ma, and are overlapped by the middle Eocene Tyee Formation. Regional strain analysis indicates more than 20 percent shortening by right-lateral convergence during early Eocene time. The structural style and syn-tectonic deformation of marine slope facies suggest deposition in an active subduction complex until about 52 Ma. Structural trends in the southern Oregon Coast Range parallel those in the adjacent Klamath Mountains until the end of the early Eocene. At 52-50 Ma, subduction apparently ceased as incoming seamounts clogged the trench, and may have jumped to an outboard position near the present day coastline. In middle Eocene time, the newly developed forearc region rapidly filled with sediments from a much sandier depositional system. Paleomagnetic studies of relatively undeformed Tyee forearc strata indicate as much clockwise rotation as the much more deformed, underlying volcanic basement of the Oregon Coast Range. Rotation of the Oregon Coast Range as a single crustal block must have occurred after, rather than during seamount accretion to the continental margin, which was essentially complete by 52 Ma.

Uneconomic epithermal precious metal mineralization and associated alteration occur in the Tonopah Property, and are similar in style, although much less intense, to the deposits of the Tonopah camp two miles south. Mineralization is localized within a set of northwest-trending faults within the Tonopah, Mizpah, and King Tonopah Member of the Fraction-Tuff formations, and is associated with widespread propylitic and sparse fracture-localized potassic and argillic alteration. A younger set of Mn-calcite veins, anomalous in manganese, mercury, arsenic, and antimony, occurs in northeast-trending faults cutting older formations as well as the younger Tonopah Summit Member of the Fraction Tuff. This mineralization is possibly associated with silicification, zeolitization, and clay-alteration of the Fraction Tuff. The Tonopah Summit Member of the Fraction Tuff is reinterpreted as younger than the King Tonopah Member. Mega-breccia and basin morphology in the northeast may indicate an eruptive vent in this area.

No description available.

The level of organic maturation, thermal history, and source rock potential of Mesozoic and Tertiary strata in the Queen Charlotte Islands have been investigated with vitrinite reflectance measurements (%Ro rand)> numerical modelling (modified Arrhenius and Lopatin models), and Rock-Eval pyrolysis (source rock potential). The level of organic maturation increases from north to south and is primarily controlled by high heat flow associated with plutonism on Moresby Island. Upper Triassic-Lower Jurassic strata are overmature on Moresby Island with vitrinite reflectance values ranging from 2.40 to 5.80 %Ro rand Jurassic, Cretaceous, and Tertiary strata are immature to overmature on Graham Island with values ranging from 0.15 %Ro rand (Skonun Formation) to 2.43 % Ro rand (Haida Formation). Constant and variable geothermal gradient thermal regimes were numerically modelled with modified Arrhenius and Lopatin methods. Numerical modelling (assuming constant geothermal gradients) predicts high paleogeothermal gradients (45 to 90 °C/km) for up to 180 million years from the Late Triassic to the Tertiary. Variable paleogeothermal gradient modelling (utilizing a 30 °C/km background geothermal gradient) predicts peak geothermal gradients ranging up to 150 °C/km during Yakoun (183-178 Ma) and Masset (35-10 Ma) volcanism. The timing of hydrocarbon generation was estimated with numerical modelling. The levels of organic maturation for Mesozoic and Tertiary strata reflect the timing of plutonism and associated high heat flow. Triassic strata from west Graham Island and Cretaceous strata from north and south Graham Island entered the oil window during the Early Miocene and are still in the oil window. Jurassic strata in central Graham Island and north Moresby Island entered the oil window during the Bajocian and remain within the oil window. The Skonun Formation is generally immature except for strata at west Graham Island (Port Louis well) and at northeast Graham Island (basal strata in the Tow Hill well) which entered the oil window during the Late Miocene. Mean total organic carbon (TOC) contents are generally low (0.06 %) to moderately high (3.6 %) for Mesozoic and Tertiary strata. Some organic-rich horizons with TOC values up to 11.2 % occur in Upper Triassic (black limestone member of the Kunga Group) and Lower Jurassic (Sandilands and Ghost Creek Formations) source strata. Mesozoic and Tertiary strata generally contain gas prone Type III organic matter except for the Lower Jurassic Ghost Creek Formation and the Upper Triassic-Lower Jurassic Kunga Group which contain oil and gas prone Type II organic matter and significant amounts of oil prone Type I organic matter. Lateral variations in TOC and the quality of organic matter (QOM) for Triassic and Jurassic strata are primarily related to the level of organic maturation. The strata have poor to good hydrocarbon source potential on Graham Island. High heat flow associated with plutonism on Moresby Island has overmatured the strata resulting in poor source potential on Moresby Island. Hydrocarbon source potential for Cretaceous and Tertiary strata is primarily controlled by the level of organic maturation and depositional patterns. The Cretaceous Haida and Honna Formation generally contain terrestrially derived Type III organic matter with poor to fair gas source potential. The Skidegate Formation contains a mixture of Types II and III organic matter with decreased (terrestrial) Type III organic matter input and increased Type II (marine) organic matter input relative to the Haida Formation. Cretaceous strata from Moresby Island are generally overmature and have poor source potential whereas equivalent strata from Graham Island are immature to overmature and have fair to moderate gas source potential. Generally immature coal and lignite from the Tertiary Skonun Formation have poor to fair gas source potential. Resinite horizons containing hydrogen-rich organic matter have good oil and gas source potential where mature. Siltstone and shale facies of the Skonun Formation contain moderate amounts of Type II organic matter and have good hydrocarbon source potential. / Science, Faculty of / Earth, Ocean and Atmospheric Sciences, Department of / Graduate

Southern Alabama holds one of the world's most complete shallow shelf Cretaceous-Tertiary boundary sections. The boundary is exposed in a sequence of marl-limestone interbeds in a roadcut south-east of Braggs in Lowndes County, Alabama. Benthic foraminifera were extracted in 10cm intervals to obtain a high-resolution record of assemblage succession across this controversial boundary. A local sea level curve was then formulated using previous paleobathymetric foraminiferal assemblage models from the Gulf Coast and the Atlantic Coastal margin. Sea-level fluctuations thus evident have revealed a fourth-order cycle similar to those found by Briskin and Fluegeman (1990) with an average period of around 430 kyr through the Paleocene. This cycle includes a drop from outer slope to middle shelf conditions in the latest Cretaceous and a subsequent increase from inner shelf to outer shelf conditions in the earliest Paleocene. Within this cycle are several fifth-order cycles that are interpreted as having a periodicity of roughly 100 kyr. Sea-level cycles with Milankovitch frequencies occurring on an ice-free Paleocene Earth lend support to the concept of astronomical forcing of climate and thus sea-level. / Department of Geology

No description available.

No description available.

[Truncated abstract] Detailed sedimentological, petrographical, geochemical and palynological studies have provided insight into the source rocks and the processes that operated during formation of the Tertiary Yandi channel iron deposit (CID) of the eastern Pilbara, Western Australia. Yandi is the largest and most valuable CID in the world, accounting for more than 2.5% of global iron production in 2003, and is the type-example of CID. The Yandi CID occupies the palaeo-Marillana Creek in the central Hamersley Ranges. It is near-coincident-with the modern Marillana Creek which incised Proterozoic bedrock of the Weeli Wolli Formation (Hamersley Group) and associated dolerite intrusions. Three lithostratigraphic units fill the palaeo-Marillana Creek and comprise the Marillana Formation. The units in stratigraphic order are the: (1) Munjina Member; (2) Barimunya Member, which hosts the majority of the iron resource; and (3) Iowa Eastern Member. Fossil pollen and spores in organic-rich claystones in the Munjina Member indicate that deposition of the Marillana Formation most likely commenced in the Early Oligocene in response to erratic seasonal flows with high energy flood events and intervening quiescent suspension settling of clays. The Marillana Formation consists of twelve facies. These conglomerate and clay facies form three facies associations. The basal facies association is composed of polymictic conglomerate, clay and interbedded CID that represents a lag deposit along the base of the palaeochannel. This facies association characterises the Munjina Member. The second facies association consists of iron-rich conglomerate sheets, bars and subordinate scour-fills and characterises the Barimunya Member. Channel iron deposits of the overlying Iowa Eastern member consist of reworked Barimunya Member iron conglomerates. The upper facies association is polymictic conglomerate with clay that characterises the remainder of the Iowa Eastern Member. Polymictic iron conglomerate in the Munjina and Barimunya Members contains Weeli Wolli Formation and dolerite clasts indicating local derivation. Rare earth element profiles of the other iron conglomerate facies indicate derivation of the Barimunya and Iowa Eastern CID from a different source. These iron conglomerates are characterised by relatively flat LREE profiles. The LREE exhibit an enriched profile approaching the MREE [(average La/Nd)N = 0.7], and the HREE profile shows minor enrichment approaching ytterbium [(average Dy/Yb)N = 0.9]. Comparison of iron conglomerate REE profiles to those of the bedrock indicates that these conglomerates were most probably derived from the Joffre Formation BIF of the Hamersley Group

The tertiary history of the Chiricahua volcanic field of southeastern Arizona is essentially that of rhyolitic ash-flow deposition and concomitant block faulting in the period from 29 to 25 m.y., as determined by K-Ar analysis. The Rhyolite Canyon ash-flow sheet is the youngest of three sheets, each more than 1000 feet thick. Its distribution is limited mainly to the Chiricahua and northern Pedregosa Mountains with a lesser amount of deposits in the neighboring Swisshelm and Peloncillo Mountains. It is estimated that the original areal extent was of the order of 700 square miles and that the volume of deposits was around 100 cubic miles. The source area of the Rhyolite Canyon sheet is identified as a 13-mile diameter caldera, named the Turkey Creek caldera. This is the first major caldera of the Valles type described in the Mexican Highland and Sonoran Desert sections of the Basin and Range. It is unique because of its denudation. Erosion to 5000-foot depth locally has exposed thick sections of moat deposits and a fine grained monzonite pluton associated with central doming. Rhyolite Canyon tuff in the caldera, some 3000 feet thick, is domed and intruded by the monzonite. More than 1500 feet of tuff breccia, tuffaceous sediments, and rhyolite flows are exposed in the moat, along with 3000 feet of monzonite forming annular segments a couple miles wide abutting or overlying rocks forming the caldera wall. The most monzonite is similar to that in the dome and was emplaced amidst the period of deposition in the caldera. Petrographic and trace element analyses indicate a cogenetic relation between the Rhyolite Canyon sequence and the moat rhyolites. The K-Ar age of the Rhyolite Canyon tuff is very close to that of the monzonite. The ash-flow sheet immediately underlying the Rhyolite Canyon sheet is also very close in age as indicated by K-Ar analyses. Block faulting and tilting took place between the two sheets and also following the deposition of the Rhyolite Canyon sheet. There is evidence that the present basin-range structure was not established until after the Rhyolite Canyon sheet had been emplaced.