Northwest Natural Gas Canpany has proposed to convert the Bruer and Flora pools of the Mist Gas Field in west-central Columbia County, Northwestern Oregon, to pipeline gas storage reservoirs. Conversion to underground storage of pipeline gas in these depleted gas reservoirs would be the first in the Pacific Northwest. The Bruer and Flora Pools are fault trapped within the Cowlitz Formation. The shales overlying the Cowlitz Formation create a local seal for these gas reservoirs. X-ray diffraction and density log measurements suggest that the clay in these shales is primarily composed of smectite, which provides an excellent caprock seal. The reservoir rock of the Bruer and Flora Pools is the arkosic Cl ark and Wilson Sand. An average weighted grain density for the sand is 2.65 g/cm3. The abundance of potassium feldspar in the sand, hence K40, creates a background gamma radiation for the sand roughly equal to that of the shale, making the sand and shale virtually indistinguishable on the gamma ray log. Bottan Hole Temperatures (BHT), which were recorded on open hole logs, indicate the Bruer Pool is 7°C (20°F) wanner than the Flora Pool, even though the Flora Pool is deeper. This temperature anomaly may be the result of equipment variation. A calibrated temperature survey would remove any discrepancies. A comparison of the thermal gradient determined in a previous study of the Oregon Coast Range and a gradient determined using BHT, suggest that BHT provide a good approximation of formation temperature. Utilizing the formation water analysis determined from four different wells in the Mist Gas Field, average total dissolved solids was found to be 24, 444 mg/l. Of the four analyses, the sample from Well CC#6 R/D2 is considered to be the most representative of the Bruer and Flora fools formation waters. Analysis of the four samples using the Palmer System suggests that the formation water of the Cowlitz Formation is in the early stages of sea water diagenasis. Formation water resistivity (Rw) was determined using a chemical and spontaneous potential analysis. Rw derived using chemical analysis averaged 0.175 ohm-meters and is considered the ITDst precise. Water saturation determined using the Archie saturation equation averaged 47.5% and ranged from 26.4 to 80.0% for the zone 814-836 meters (2670-2742 feet) in CC#10. These results are similar to those determined by the Thermal Time Decay (TDT) log.

The study area is located in northwestern Columbia County, and covers an area of approximately 70 square kilometers. The purpose of the study was to investigate the possible correlation of the Scappoose and Astoria Formations and determine their stratigraphic relationship to the Columbia River Basalt Group through mapping, geochemistry and petrography.

A fault-like linearity along the lower Clackamas River is evaluated by analysis of physiographic and structural alignments, geological relationships, and by gravity and magnetic data. The study has resulted in the verification of a structural feature extending along the Clackamas River and the eastern front of the Portland Hills. Physiographic alignments were examined in twelve 15 minute and two 7-1/2 minute quadrangle maps. A significant northeasterly morphologic trend, N. 20⁰ W. and N. 40° W., and other secondary trends, namely, the N-S, E-W, and N. 50-60° E., has developed in the Portland area. The consistent northwest trend is observed throughout the entire area studied which strongly suggests that the alignments are very good indicators of underlying structural features. Structural alignments show that approximately 60% of the known mapped faults and fold axes concur with the dominant northwest physiographic trend. Seismic first motion analysis supports the established morphologic trend. A series of regionally co-aligned morphologic and structural features striking S. 40 -50⁰ E. across the state of Oregon suggest the presence of a major structural fault system aligned with the Portland Hills-Clackamas River structural alignment. The geologic cross sections developed from map and well data generally lack any tangible evidence as to the nature of the physiographic alignment. An apparent offset of the lower Pliocene Sandy River mudstone suggests movement as recent as middle Pliocene. Geophysical information was obtained from six gravity traverses and three magnetic traverses. The consistency of the size and shape of the gravity anomaly, 2.18 milligals/O. 2 mile, downdropped to the east, across the physiographic alignment defines the zone of a fault or a steep fold developed in the Columbia River basalt. The magnetic anomalies show a consistent change in the magnetic gradient corresponding to the structural zone.

Explosion structures occur in flows of Grande Ronde Basalt in the study area near Troy, Oregon. Data from nineteen stratigraphic sites indicate that the maximum number of flows that contain explosion structures at any one site is six. In the informally named Troy flow, explosion structures are widespread.

A series of tufa mounds is found within the northern basin of Lake Abert, located within southeastern Oregon. The mounds have been divided into 3 main groups and 1 sub-group (A1, A2, B, and C) based upon spatial and textural considerations. Mound groups appear at two different elevations: the 1310 meter elevation (Groups A2, B, and C), and the 1318 meter elevation (Group A1). Published carbon age dating of the Lake Abert 1325 meter strandline and the 1310 meter strandline indicates that the mounds were formed during the Late Pleistocene/Early Holocene. Facies analysis and mineralogical analysis of the mounds indicates that the mounds were primarily formed subaqueously during a lake regression, supporting oxygen isotope data from previous researchers. Magnetometer data within Groups A1 and A2 suggests that the mounds are associated with a series of magnetic lows which are oriented in joint sets (NW-SE, and N-S) which match the orientation of faulting within the region. While there appears to be another early mound building episode, no direct evidence confirms this.

Upper Triassic metavolcanic and metasedimentary strata in the study area are intruded by the Hurricane Divide and Craig Mountain Plutons of the Late Jurassic-Cretaceous Wallowa Batholith. The Clover Creek Greenstone is overlain by the Martin Bridge Limestone, which is in tum overlain by the Hurwal Argillite; although the sequence is in normal stratigraphic order, contacts are generally tectonic. Concurrent with Early-Middle Jurassic regional deformation, during intermediate to mafic dikes, emplacement of the plutons of the Wallowa Batholith began. The plutons intruded vertically through the greenstone and limestone and then horizontally above the greenstone. This resulted in intense penetrative plastic deformation particularly of the Martin Bridge Limestone. Emplacement of the Hurricane Divide Pluton followed a northeast axis, and resulted in isoclinal folding and the formation of northerly trending synformal anticlines in the Martin Bridge atop a zone of uncoupling between the plastic limestone and the more rigid underlying Clover Creek metavolcanic basement. Subsequent final emplacement of the Craig Mountain Pluton caused cross folding of these anticlinal structures. Granitic plutonism was followed by regional uplift with associated faulting and erosion. Miocene Columbia River Basalt flood lavas were injected along many of the more northerly trending of these faults. This magmatism was concurrent with or followed by block uplift on the order of 1800 m of the Wallowa Mountains along the Wallowa Fault.

Mickey Springs in the Alvord Desert, southeast Oregon, is analogous to other Basin and Range hydrothermal systems where the requisite conditions of heat source and permeable pathways are met through crustal thinning due to normal faulting. This study examines the morphology and lifespan of near-surface spring features through use of ground penetrating radar, thermoluminescence (TL) dating, and elevation modeling. Duration of hydrothermal activity at Mickey Springs has not previously been determined, and age determinations of sinter at the site are conflicting. The reason for and timing of this change in silica saturation in the hydrothermal fluid has not been resolved. Three morphologies of silica sinter deposition have been identified at Mickey Springs. These are (1) well-sorted, fine-grained sandstone with ripple marks, cross beds and preserved root casts, to poorly-sorted conglomerate of primarily basalt clasts, both cemented by coeval silica deposition, (2) large depressions (12-32 m diameter) rimmed with sinter, characterized by fine silt and clay blanketing a sinter apron and infilling the central depression, and (3) quaquaversal sinter mounds identified by outcropping pool-edge sinter typically surrounding a shallow depression of loose sediment. Silica-cemented sandstone and conglomerate were the first features formed by coeval hydrothermal processes at the site, and were emplaced prior to 30 kya as suggested by structural and stratigraphic relationships. Structure between two interacting fault tips may have constrained the extent of silica cementation. By 30 kya, a left-stepping fault oriented roughly north/south further constrained the near-surface permeable zone. TL dates from sediment stratigraphically below and above sinter aprons around mounds and depressions (former spring vents) indicate sinter deposition between 30 and 20 kya. Location of these features was dictated by development of the left-stepping fault. As pluvial Lake Alvord filled at the end of the Pleistocene, lake sediment filled most vents, which were largely inactive, with fine-grained silt and clay. Today, hydrothermal activity persists in two modes: (1) The current high-temperature springs, steam vents and mudpots concentrated in a 50 x 50 m area south of the sinter mounds and depressions, and (2) scattered springs and steam vents that exploit previous permeable pathways that once provided the hydrothermal fluid which precipitated the sinter aprons. Currently there is no active silica sinter deposition at Mickey Springs. Structures and stratigraphic relationships identified through this study favor a transport-limited and structurally controlled model of fluid transport. Sinter deposition is determined to have occurred before the most recent highstand of pluvial Lake Alvord. A climate driven model, where groundwater recharge from pluvial Lake Alvord circulates to a deep heat source and enhances spring discharge, is not supported by these findings, as no evidence was found for sinter precipitation after the drying of the lake. Future studies of other hydrothermal systems in the Basin and Range may reveal that permeable pathways along local structures are the primary drivers in this region.

This study examined source rock geochemistry of the southern Tyee Basin. Total organic carbon, rock-eval pyrolysis, vitrinite reflectance, thermal alteration index and visual assessments were performed on splits from cutting samples from five wells and on outcrop samples from four measured sections. Organic matter was found to be dispersed, averaging about 0.5 weight percent. The organic matter is primarily terrestrial in origin, or type I l l , with low potential for gas production and no oil potential. Three coal samples are clearly the richest sources of organic matter examined in this study.

The recent contributions of several investigators has indicated the Portland basin may be a pull-apart structure associated with wrench tectonism. Because of the large density contrast between sedimentary and volcanic units and because of their reasonably uniform and continuous nature, gravity survey methods can be used to identify covered structures with considerable success. The study utilized gravity modeling techniques to investigate the structure and genesis of the Portland basin's eastern margin.

This research formulated a recent geologic history of the Clatsop Plains dating from 3500 years BP to present. Research consisted of geomorphic mapping, near-surface stratigraphic evaluation, carbon dating and subsurface interpretation of available data.