A number of older bridges built before the 1970’s were constructed with floor systems consisting of a non-composite concrete slab over steel girders. Many of these bridges do not satisfy current load requirements and may require replacement or strengthening. A potentially economical means of strengthening these floor systems is to connect the existing concrete slab and steel girders to permit the development of composite action. This dissertation describes a research program investigating methods to develop composite action in existing non-composite floor systems by the use of postinstalled shear connectors. Three types of post-installed shear connection methods were investigated. These methods are referred to as the double-nut bolt, the high tension friction grip bolt, and the adhesive anchor. These post-installed shear connectors were tested under static and fatigue loading, and design equations for ultimate strength and fatigue strength were developed. These post-installed shear connectors showed significantly higher fatigue strength than conventional welded shear studs widely used for new construction. The superior fatigue strength of these post-installed shear connectors enables strengthening of existing bridge girders using partial composite design, thereby requiring significantly fewer shear connectors than possible with conventional welded shear studs. Five full-scale non-composite beams were constructed and four of these were retrofitted with post-installed shear connectors and tested under static load. The retrofitted composite beams were designed as partially composite with a 30-percent shear connection ratio. A non-composite beam was also tested as a baseline specimen. Test results of the full-scale composite beams showed that the strength and stiffness of existing non-composite bridge girders can be increased significantly. Further, excellent ductility of the strengthened partially composite girders was achieved by placing the postinstalled shear connectors near zero moment regions to reduce slip at the steel-concrete interface. Parametric studies using the finite element program ABAQUS were also conducted to investigate the effects of beam depth, span length, and shear connection ratio on the system behavior of strengthened partially composite beams. The studies showed that current simplified design approaches commonly used for partially composite beams in buildings provide good predictions of the strength and stiffness of partially composite bridge girders constructed using post-installed shear connectors. / text

In recent years the use of carbon fiber reinforcing polymers (CFRP) to repair damaged structural components has become more accepted and practiced. However, the current reference for designing FRP systems to repair and strengthen reinforced concrete (RC) and prestressed concrete (PSC) girders has limitations. Similarly, very few resources address solutions for the debonding problem associated with CFRP laminates or the use of CFRP laminates to repair structural members with pre-existing damage. The included experimental program consists of testing both RC and PSC girders with simulated lateral damage and CFRP repairs. A total of 34 RC beams were statically tested under a 4-point loading until failure and had cross-section dimensions of 5” x 10” (14cm x 25.4cm), were 8’ long (2.44m), and were reinforced with either #3 or #4 mild steel rebar. 13 PSC girders having cross-section dimensions representing a half-scaled AASHTO type II shape, were 20’ long (6.1m), and were prestressed with five 7/16” (11.1mm) diameter low-lax 7-wire strands. Ten of the PSC girders were statically loaded until failure under a 4-point testing setup, but 3 PSC girders were dynamically tested under fatigue loading using a 3-point arrangement. Different configurations of CFRP laminates, number and spacing of CFRP transverse U-wraps, and amount of longitudinal CFRP layers are studied. The results present the flexural behavior of all specimen including load-deflection characteristics, strain characteristics, and modes of failure. Ultimately, results are used to recommend important considerations, needed criteria, and proper design procedures for a safe and optimized CFRP repair configuration.