[Truncated abstract] Respiratory system impedance (Zrs) is commonly measured at low to medium frequencies (0.5 - 40 Hz) to infer structural and physiological information about the respiratory system. Coupled with the use of mathematical models of the lungs, Zrs has been used to partition the behaviour of the conductive airways and the respiratory tissues. High-frequency (HF) Zrs beyond 100 Hz has been comparatively less studied and understood. Past work has revealed spectral features at high frequencies termed antiresonances, marked by peaks in the real part of Zrs, often coinciding with zero-crossings in the imaginary part. It has been shown that the first occurrence of antiresonance in humans primarily reflects the contribution of the airways, and is a property of sound wave propagation in the airways. Also, the first antiresonance is altered in diseases such as chronic airflow obstruction, and wheeze in infants. The main aim of this project is to shed further understanding about the first antiresonance, via the behaviour of two parameters characterising this feature of the HF spectrum: the frequency at which the first antiresonance occurs, far,1, and the magnitude of the real part of Zrs at this frequency, Rrs(far,1). In our studies, Zrs is measured as an input impedance using the forced oscillation technique with a loudspeaker-in-box and wavetube setup, and employing pseudorandom frequency signals. We studied the effects of altered lung conditions, first in an animal model, then progressed on to humans. v vi In the rat, we found that both far,1 and Rrs(far,1) tended to decrease together with increasing lung volume. With methacholine(MCh)-induced bronchoconstriction, rats showed increases in far,1 and Rrs(far,1) with increasing MCh dose, but these occurred at higher doses compared to increases in airway resistance. The changes in these HF parameters were independent of the changes in tissue properties. ... It was found that in a group of patients with emphysema, VDRrs(far,1) was significantly more negative, potentially due to alterations to airway dimensions and wall properties. Furthermore, VDRrs(far,1) was correlated with extent of obstruction and hyperinflation, suggesting a relationship with severity of emphysema. These results show that the first antiresonance reflect changes in the airways, and its measurement shows promise as a clinical tool, in its potential as an easy-to-perform assessor of conditions in which the airways are altered. Keywords: antiresonance, respiratory input impedance, high frequencies, emphysema

Ces travaux de recherche portent sur la problématique CEM (Compatibilité Electromagnétique) en électronique de puissance. Cette étude s'intéresse particulièrement à la modélisation HF (haute fréquence) des convertisseurs d'énergie dans le but d'étudier la propagation des perturbations conduites vers le réseau avec ou sans l’utilisation du RSIL (Réseau Stabilisateur d'Impédance de Ligne). Une première partie présente les outils de modélisation des sources de perturbation dans les convertisseurs statiques.La seconde partie est consacrée à la modélisation HF d'un système d'entraînement à vitesse variable. L'onduleur de tension triphasé est représenté par trois générateurs équivalents afin de reconstituer le découpage des tensions de sortie. Un modèle HF du câble blindé de 4 conducteurs tenant compte de la dissymétrie est ensuite proposé. Les résultats de simulation ont été validés par des relevés expérimentaux. La comparaison montre qu'il est possible de modéliser correctement le comportement HF du dispositif jusqu'à 20MHz.Une troisième partie porte sur la propagation des perturbations conduites vers le réseau sans RSIL. Il a fallu pour cela déterminer et modéliser l'impédance du réseau. L'influence du pont redresseur à diodes sur la propagation des perturbations de mode commun a ensuite été étudiée. Les résultats de simulation montrent que l'impact de ces perturbations sur la tension réseau est prépondérant lorsque le pont redresseur est à l'état bloqué. Les résultats expérimentaux ont permis de valider cette étude. Ce travail se termine par une étude préliminaire sur l'association de deux convertisseurs connectés localement à une même source d'énergie / These research works focus on EMC (Electromagnetic Compatibility) in power electronics systems. Specifically, the study focuses on HF (high frequency) modeling of the power converters in order to study the conducted emissions toward the power grids with or without the use of an LISN (Line Impedance Stabilisation Network). The first part presents the modeling tools of the electromagnetic emissions sources in power converters.The second part describes the HF modeling method of an adjustable speed drive (ASD) that will be used to estimate the conducted emissions. In a first part, a behavioural model of PWM inverter is proposed as an EMI noise source. Then, a model of the shielded 4-wire energy cable that taking into account of the dissymmetry structure is proposed and validated in the frequency domain for two different lengths. The comparison of measurement and simulation results of conducted emissions (with LISN) shows the good compromise between the simulation duration and accuracy of the results.A third part is dedicated to the propagation of conducted emissions toward the power grid without using a LISN. The first stage consists in proposing a model impedance of the network impedance. The influence of the bridge rectifier diodes on the propagation paths of common mode disturbances has been studied in the second step. The simulation results show that the impact of these disturbances on the network voltage is more important when the bridge rectifier is normally off-state. The experimental results have validated this study. This work concludes with a preliminary study on the association of two converters connected locally to a single energy source