It is necessary for radars to suppress interferences to near the noise level to achieve the best performance in target detection and measurements. In this dissertation work, innovative signal processing approaches are proposed to effectively mitigate two of the most common types of interferences: jammers and clutter. Two types of radar systems are considered for developing new signal processing algorithms: phased-array radar and multiple-input multiple-output (MIMO) radar. For phased-array radar, an innovative target-clutter feature-based recognition approach termed as Beam-Doppler Image Feature Recognition (BDIFR) is proposed to detect moving targets in inhomogeneous clutter. Moreover, a new ground moving target detection algorithm is proposed for airborne radar. The essence of this algorithm is to compensate for the ground clutter Doppler shift caused by the moving platform and then to cancel the Doppler-compensated clutter using MTI filters that are commonly used in ground-based radar systems. Without the need of clutter estimation, the new algorithms outperform the conventional Space-Time Adaptive Processing (STAP) algorithm in ground moving target detection in inhomogeneous clutter. For MIMO radar, a time-efficient reduced-dimensional clutter suppression algorithm termed as Reduced-dimension Space-time Adaptive Processing (RSTAP) is proposed to minimize the number of the training samples required for clutter estimation. To deal with highly heterogeneous clutter more effectively, we also proposed a robust deterministic STAP algorithm operating on snapshot-to-snapshot basis. For cancelling jammers in the radar mainlobe direction, an innovative jamming elimination approach is proposed based on coherent MIMO radar adaptive beamforming. When combined with mutual information (MI) based cognitive radar transmit waveform design, this new approach can be used to enable spectrum sharing effectively between radar and wireless communication systems. The proposed interference mitigation approaches are validated by carrying out simulations for typical radar operation scenarios. The advantages of the proposed interference mitigation methods over the existing signal processing techniques are demonstrated both analytically and empirically.

This thesis investigates techniques and algorithms for mitigating radio frequency interference (RFI) affecting radio astronomy observations. In the past radio astronomy has generally been performed in radio-quiet geographical locations and unused parts of the radio spectrum, including small protected frequency bands. The increasing use of the entire spectrum and global transmitters such as satellites are forcing the astronomy community to begin implementing active interference cancelling. The amount of harmful interference affecting observations will also increase as future instruments such as the Square Kilometre Array (SKA) are required to use larger bandwidths to reach up to 100 times the current sensitivity levels, and as spectral line observations require observing in bands licensed to other spectrum users. Particular attention is paid to interference cancellation algorithms which make use of reference beams. This has proven to be successful in removing interference from the contaminated astronomical data. Reference antenna cancellers are closely analysed, leading to filters and techniques that can offer improved RFI excision for some important applications. It is shown that pre- and post-correlation reference antenna cancellers give similar results, and an important aspect of the cancellers is the use of a second reference signal when the reference interference-to-noise ratio is low. These modified filters can theoretically offer infinite interference suppression in the voltage domain, equivalent to that of post-correlation interference cancellers, and their internal structure can offer an understanding of the residual RFI and added receiver noise components of a variety of reference antenna techniques. The effect of variable geometric delays is also considered and various filters are compared as a function of the geometric fringe rate.

Interference is a key limiting factor in modern communication systems. In a wireless cellular network, the performance of cell-edge users is severely limited by the intercell interference. This thesis studies the use of interference-channel and relay-channel techniques to mitigate intercell interference and to improve the throughput and coverage of cellular networks. The aim of this thesis is to demonstrate the benefit of the proposed interference mitigation schemes through both information theoretical studies and applications in the cellular network. There are three mains results in this thesis: First, it is shown that for the $K$-user cyclic Gaussian interference channel, where the $k$th user interferes with only the ($k -1$)th user (mod $K$) in the network, the Etkin-Tse Wang power splitting strategy achieves the capacity region to within 2 bits in the weak interference regime. For the special 3-user case, this gap can be sharpened to $1\frac{1}{2}$ bits by the time-sharing technique. Second, it is shown that for a two-user Gaussian interference channel with an in-band-reception and out-of-band transmission relay, generalized hash-and-forward together with Han-Kobayashi information splitting can achieve the capacity region of this channel to within a constant number of bits in a certain weak-relay regime. A generalized-degrees-of-freedom analysis in the high signal-to-noise ratio regime reveals that in the symmetric channel setting, each common relay bit improves the sum rate up to two bits. The third part of this thesis studies an uplink multicell joint processing model in which the base stations are connected to a centralized processing server via rate-limited digital backhaul links. This thesis proposes a suboptimal achievability scheme employing the Wyner-Ziv compress-and-forward relaying technique and successive-interference-cancellation decoding. The main advantage of the proposed approach is that it results in achievable rate regions that are easily computable, in contrast to previous schemes in which the rate regions can only be characterized by exponential number of rate constraints.

Interference is a key limiting factor in modern communication systems. In a wireless cellular network, the performance of cell-edge users is severely limited by the intercell interference. This thesis studies the use of interference-channel and relay-channel techniques to mitigate intercell interference and to improve the throughput and coverage of cellular networks. The aim of this thesis is to demonstrate the benefit of the proposed interference mitigation schemes through both information theoretical studies and applications in the cellular network. There are three mains results in this thesis: First, it is shown that for the $K$-user cyclic Gaussian interference channel, where the $k$th user interferes with only the ($k -1$)th user (mod $K$) in the network, the Etkin-Tse Wang power splitting strategy achieves the capacity region to within 2 bits in the weak interference regime. For the special 3-user case, this gap can be sharpened to $1\frac{1}{2}$ bits by the time-sharing technique. Second, it is shown that for a two-user Gaussian interference channel with an in-band-reception and out-of-band transmission relay, generalized hash-and-forward together with Han-Kobayashi information splitting can achieve the capacity region of this channel to within a constant number of bits in a certain weak-relay regime. A generalized-degrees-of-freedom analysis in the high signal-to-noise ratio regime reveals that in the symmetric channel setting, each common relay bit improves the sum rate up to two bits. The third part of this thesis studies an uplink multicell joint processing model in which the base stations are connected to a centralized processing server via rate-limited digital backhaul links. This thesis proposes a suboptimal achievability scheme employing the Wyner-Ziv compress-and-forward relaying technique and successive-interference-cancellation decoding. The main advantage of the proposed approach is that it results in achievable rate regions that are easily computable, in contrast to previous schemes in which the rate regions can only be characterized by exponential number of rate constraints.

This thesis investigates techniques and algorithms for mitigating radio frequency interference (RFI) affecting radio astronomy observations. In the past radio astronomy has generally been performed in radio-quiet geographical locations and unused parts of the radio spectrum, including small protected frequency bands. The increasing use of the entire spectrum and global transmitters such as satellites are forcing the astronomy community to begin implementing active interference cancelling. The amount of harmful interference affecting observations will also increase as future instruments such as the Square Kilometre Array (SKA) are required to use larger bandwidths to reach up to 100 times the current sensitivity levels, and as spectral line observations require observing in bands licensed to other spectrum users. Particular attention is paid to interference cancellation algorithms which make use of reference beams. This has proven to be successful in removing interference from the contaminated astronomical data. Reference antenna cancellers are closely analysed, leading to filters and techniques that can offer improved RFI excision for some important applications. It is shown that pre- and post-correlation reference antenna cancellers give similar results, and an important aspect of the cancellers is the use of a second reference signal when the reference interference-to-noise ratio is low. These modified filters can theoretically offer infinite interference suppression in the voltage domain, equivalent to that of post-correlation interference cancellers, and their internal structure can offer an understanding of the residual RFI and added receiver noise components of a variety of reference antenna techniques. The effect of variable geometric delays is also considered and various filters are compared as a function of the geometric fringe rate.

Femtocells have been introduced as a solution to poor indoor coverage in cellular communication which has hugely attracted network operators and stakeholders. However, femtocells are designed to co-exist alongside macrocells providing improved spatial frequency reuse and higher spectrum efficiency to name a few. Therefore, when deployed in the two-tier architecture with macrocells, it is necessary to mitigate the inherent co-tier and cross-tier interference. The integration of cognitive radio (CR) in femtocells introduces the ability of femtocells to dynamically adapt to varying network conditions through learning and reasoning. This research work focuses on the exploitation of cognitive radio in femtocells to mitigate the mutual interference caused in the two-tier architecture. The research work presents original contributions in mitigating interference in femtocells by introducing practical approaches which comprises a power control scheme where femtocells adaptively controls its transmit power levels to reduce the interference it causes in a network. This is especially useful since femtocells are user deployed as this seeks to mitigate interference based on their blind placement in an indoor environment. Hybrid interference mitigation schemes which combine power control and resource/scheduling are also implemented. In a joint threshold power based admittance and contention free resource allocation scheme, the mutual interference between a Femtocell Access Point (FAP) and close-by User Equipments (UE) is mitigated based on admittance. Also, a hybrid scheme where FAPs opportunistically use Resource Blocks (RB) of Macrocell User Equipments (MUE) based on its traffic load use is also employed. Simulation analysis present improvements when these schemes are applied with emphasis in Long Term Evolution (LTE) networks especially in terms of Signal to Interference plus Noise Ratio (SINR).

In recent years, Smart Grid (SG) is envisioned to be the next generation electric power system by replacing traditional power grid due to its advantage of using two way communications. To implement reliable SG wireless communication networks, IEEE introduced a new wireless standard (IEEE802.15.4g) for Smart Utility Networks (SUNs). However, SUN operates on 2.4 GHz unlicensed band which is overlapped with Wireless Local Area Networks (WLANs) that leads to coexistence in Smart Utility Networks. In this paper, the coexistence problem of SUN is addressed in terms of homogeneous and heterogeneous interferences. To mitigate the homogeneous interference, Contention Access Period (CAP) and Contention Free Period (CFP) of a super frame of IEEE 802.15.4g is used to access the channel using slotted CSMA/CA algorithm by modifying the Backoff Period (BP) and Clear Channel Assessment (CCA) period for different priority data. An analytical model is developed using Markov chain, through which we demonstrate the accuracy of the proposed model in terms of throughput, channel access delay, probability of successful transmission and collision for nodes with different priority data. Performance evaluation is further investigated by comparing the proposed scheme with the existing PA-MAC. A channel switching mechanism is explored to mitigate the heterogeneous interference by the prediction of Naive Bayes Classifier. Predicted result shows that proposed mechanism effectively mitigates the heterogeneous interference by choosing the non-overlapping and non-coexisting channel.

No description available.

In airborne communication systems such as airborne cell-extender repeaters the receiver faces the challenge of demodulating the signal of interest (SOI) in the presence of excessive amounts of Co-Channel Interference (CCI) from a large number of sources. This results in the overloaded environment where the number of near-equal power co-channel interferers exceeds the number of antenna array elements. This thesis first analyzes the interference environment experienced by an airborne cellular repeater flying at high altitudes. Link budget analysis using a two-ray propagation model shows that the antenna array mounted on an airborne receiver has to recover the SOI out of hundreds of co-channel interfering signals. This necessitates use of complex overloaded array signal processing techniques. An extensive literature survey on narrowband signal extraction algorithms shows that joint detection schemes, coupled with antenna arrays, provide a solution for narrowband overloaded array problem where as traditional beamforming techniques fail. Simulation results in this thesis investigates three "promising" overloaded array processing algorithms, Multi-User Decision Feedback Equalizer (MU-DFE), Iterative Least Squares with Projection (ILSP), and Iterative Least Squares with Enumeration (ILSE). ILSE is a non-linear joint maximum-likelihood detector, is shown to demodulate many more signals than elements even when the users are closely spaced and the channel is blindly estimated. Multi-user time delay estimation is one of the most important aspects of channel estimation for overloaded array processing. The final chapter of the thesis proposes a low-complexity data-aided time-delay estimation structure for embedding in a Per Survivor Processing (PSP) trellis for overloaded array processing. An extensive analysis proves that the multi-user delay estimation is separable, which leads to the proposed multi-user algorithm that estimates the user delays with a bank of simple data-aided synchronization loops to reduce the complexity. This thesis shows simulation results for the single-user case where the low-complexity Delay Locked Loop (DLL) structure, working at a low oversampling rate of 2 samples per symbol, estimates and compensates for any integer or non-integer sample delay within ±Tsym(symbol period). Two extensions to this technique are proposed to provide efficient multi-user delay estimation. The first multi-user structure employs a bank of DLLs, which compensate for the timing offset of each user simultaneously. This multi-user algorithm is suitable for CDMA-type applications, where each user has a distinct PN-code with good auto- and cross-correlation properties. We show that for spreading gain of 31, the presence of an interpolator enables us to reduce the oversampling factor from 4 to 2 samples per chip. Thus, the requirements of the A/D converter are relaxed without sacrificing system performance. Furthermore, we show that the proposed scheme meets the requirements of multi-user interference cancellation techniques for residual worst-case timing errors, i.e., residual timing error < 0.2 Tc, as reported in [200]. Finally, the thesis recommends a similar multi-user structure for narrowband TDMA-type system, which is based on bank of DLLs with whitening pre-filters at the front end of each branch. / Master of Science

An antenna array is overloaded when the number of cochannel signals in its operating environment exceeds the number of elements. Conventional space-time array processing for narrow-band signals fails in overloaded environments. Overloaded array processing (OAP) is most difficult when signals impinging on the array are near equal power, have tight excess bandwidth, and are of identical signal type. In this thesis, we first demonstrate how OAP is theoretically possible with the joint maximum likelihood (JML) receiver. However, for even a modest number of interfering signals, the JML receiverà ­s computational complexity quickly exceeds the real-time ability of any computer. This thesis proposes an iterative joint detection technique, Spatially Reduced Search Joint Detection, (SRSJD), which approximates the JML receiver while reducing its computational complexity by several orders of magnitude. This complexity reduction is achieved by first exploiting spatial separation between interfering signals with a linear pre-processing stage, and second, performing iterative joint detection with a (possibly) tail-biting and time"-varying trellis. The algorithm is sub-optimal but is demonstrated to well approximate the optimum receiver in modest signal to interference ratios. SRSJD is shown to demodulate over 2M zero excess bandwidth synchronous QPSK signals with an M element array. Also, this thesis investigates a temporal processing technique similar to SRSJD, Temporally Reduced Search Joint Detection (TRSJD), that separates co-channel, asynchronous, partial response signals. The technique is demonstrated to separate two near equal power QPSK signals with r= .35 root raised-cosine pulse shapes." / Master of Science