El texto completo de este trabajo no está disponible en el Repositorio Académico UPC por restricciones de la casa editorial donde ha sido publicado. / This article describes consolidated Direct Cut tests not drained in the laboratory, carried out on samples of volcanic sand from Arequipa, Peru. The samples were tested for maximum dry density and optimal moisture content; Furthermore, they were reinforced with polypropylene fibers and cement. The samples were reinforced with 0.5% cement with respect to the dry weight of the sample soil and tested at 3 days. The added polypropylene fiber has dimensions of 48 mm wide with 1.2855 mm long and 0.3325 mm thick, and they were used in different percentages regarding the dry weight of the soil sample (0.25% -0.75% -1.00% -1.25%). The results of the tests indicated that the addition of polypropylene fibers together with the cement increases the resistance to cut proportionally to the amount of fiber up to 1% of fiber, this being the best result obtained, decreasing the resistance as the percentage of polypropylene fiber.

In the construction of highways, airports, and other structures, the compaction of soils is needed to improve its strength. In 1933 Proctor developed a laboratory compaction test to determine the maximum dry density of compacted soils, which can be used for specifications of field compaction. The Compaction of soils is influenced by many factors, the most common are the moisture content, the soil type and the applied compaction energy. The objective of this research is the analysis of the maximum dry density values based on the soil classification and characterization. The method of choice in the determination of the maximum dry density from different soils was the Standard Proctor Test following the procedure for the standard Proctor test as is explained in ASTM Test Designation D-698. From this investigation, the maximum dry density of eight types of sands was obtained, the sands were classified by using the Unified Soil Classification System. The influence on the maximum dry density of the type of sands, type of fines, amount of fines and distribution of the grain size was determined, followed by a sensitivity analysis that measured the influence of these parameters on the obtained maximum dry density. The research revealed some correlations between the maximum dry density of soils with the type of fines, the fines content and the Uniformity Coefficient. These correlations were measured and some particular behavioral trends were encountered and analyzed. It was found that well-graded sands have higher maximum dry density than poorly graded when the soils have the same fines content, also it was encountered that plastic fines tend to increase the maximum dry density.

Quarry fines are by-products of the aggregate extraction and productionprocesses. Because such fine material cannot be marketed, it becomes aburden for the aggregate industry, resulting in stockpiles of financiallyunexploited material. Even though previous research has been focused onminimizing the generation of quarry fines, far too little attention has beenpaid to maximizing their utilization instead. The aim of this thesis is toinvestigate whether 0/2 mm and 0/4 mm quarry fines can be utilized asalternative materials in the construction industry, specifically in theunbound layer of a road or as filling against a bridge. The methodologyconsisted of four laboratory tests that investigated the water content,particle size distribution and percentage of filler content, optimummoisture content (OMC) and maximum dry density (MDD) relationshipas well as bearing capacity of the materials. The results show that theamount of filler content (<0.063 mm) can significantly impact thematerial’s water-holding capacity as well as its compaction capabilities.After comparing the bearing capacity measurements to the technicalrequirements of the Swedish Transport Administration, it was found thatthe 0/2 mm fits the necessary requirements for use in the unbound layerof either a flexible or rigid pavement but not as filling against a bridge.Further research is needed to determine the material’s relationship towater absorption and resistance to freezing and thawing cycles, as it isdifficult to assess its suitability for road construction solely on theseresults; however, despite its limitations, the study provides some valuableinsights into the potential applications of quarry fines.