The objective of this thesis is to design, analyze, and fabricate an innovative backpack energy harvester for human walking. To model human walking with backpack energy harvester, a simple dual-mass model has been developed and studied first. Dual-mass model for three types of distinct harvesters were investigated, pure damping, traditional rack pinion energy harvester and our MMR based energy harvester. A comparison in the output power and human comfort between the three types of harvesters is discussed. However, the dual-mass model could not effectively represent human walking in real situation with sinusoidal input, like M shaped Ground Reaction Force (GRF), vertical Center of Mass (COM) motion, etc. Thus, a bipedal walking model has been proposed to simulate human walking with backpack harvester. Experiments were conducted to compare power output and efficiency of MMR based backpack energy harvester with traditional rack pinion backpack energy harvester, and verify conclusions from the bipedal walking model that the proposed backpack energy harvester using mechanical motion rectifier (MMR) mechanism has larger power output than traditional backpack energy harvester at different walking speed. In human treadmill test, subjects were asked to wear the backpack frame which embedded with harvesters walking on a treadmill. Two walking speed, 3mph and 3.5mph, and four resistor values has been tested. The test results showed that the MMR based backpack energy harvester generated more power regardless of resistor values and walking speed. Up to 4.84W average power and instant power of 12.8W could be obtained while the subject walking on the treadmill at 3.5mph speed with MMR based backpack energy harvester. / Master of Science

Sufficient power supply to run GPS machinery and transmit data on a long-term basis remains to be the key challenge for wildlife tracking technology. Traditional ways of replacing battery periodically is not only time and money consuming but also dangerous to live-trapping wild animals. In this paper, an innovative wildlife tracking collar with multi-source energy harvester with advantage of high efficiency and reliability is proposed. This multi-source energy harvester entails a solar energy harvester and an innovative rotational electromagnetic energy harvester is mounted on the "wildlife tracking collar" which will extend the duration of wild life tracking by 20% time as was estimated. A feedforward and feedback control of DC-DC converter circuit is adopted to passively realize the Maximum Power Point Tracking (MPPT) logic for the solar energy harvester. A novel electromagnetic pendulum energy harvester with motion regulator is proposed which can mechanically rectify the irregular bidirectional swing motion of the pendulum into unidirectional rotational motion of the motor. No electrical rectifier is needed and voltage drops from diodes can be avoided, the EM pendulum energy harvester can provide 200~300 mW under the 0.4g base excitation of 4.5 Hz. The nonlinearity of the disengage mechanism in the pendulum energy harvester will lead to a broad bandwidth frequency response. Simulation results shows the broadband advantage of the proposed energy harvester and experiment results verified that at some frequencies over the natural frequency the efficiency is increased. / Master of Science