Thesis (M.S.)--University of Wisconsin--Madison, 1967. / eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references.

No description available.

No description available.

Thesis (M.S.)--University of Wisconsin--Madison, 1984. / Typescript. eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references.

Thesis (Ph.D.)--Hong Kong University of Science and Technology, 2005. / Includes bibliographical references (leaves 116-124). Also available in electronic version.

No description available.

No description available.

A well designed runner and feeding system should produce castings with minimal defects and low pour weight. This thesis investigates how the filling regime and solidification of the mould influences defects in the castings produced from that mould. Design guidelines to reduce such defects are proposed and tested. An existing shrinkage fault in a Grey Iron disc brake casting is simulated using a commercial finite-difference computer program. Three criteria are used to predict the defect and the effect of changes to the feeder geometry. Critical Fraction Solidification analysis is used to determine whether the feeder remains in liquid contact with the casting during solidification and this approach is shown to correctly predict the presence or absence of porosity* The feeder block is extended below the ingate of the casting to improve liquid contact between the casting and feeder without significantly increasing the feeder mass. Plant trials confirm the change to the feeder eliminates the porosity defect. The runner system and mould venting for a thin walled Ductile Iron casting are investigated. Trials show that by setting the total mould vent area to be greater than the net ingate area of the castings, the cold-shut frequency is halved. A method for runner system design based on peak linear flow velocity in the runner during mould filling is proposed. A new pressurised runner system produces castings with significantly fewer defects and reduced pour weight when runner areas are designed to maintain peak velocity below 1 m/s. Peak velocity and magnesium levels are demonstrated to be critical factors in the elimination of cold-shut defects. A pressurised runner system is also shown to isolate inclusion defects from castings more effectively than an unpressurised system. From this work, a technique is proposed which allows the yield of an existing runner and feeder system for iron castings to be improved with confidence in the results.

Thesis (M.S.)--Worcester Polytechnic Institute. / Keywords: CRP; Thixocasting; Rheocating; Semisolid. Includes bibliographical references (leaves 46-48).

No description available.