Spelling suggestions: "subject:"miljø"" "subject:"bilja""
51 |
New switching pattern for AC/AC converters with RB-IGBTs for offshore wind parksMogstad, Anne Berit January 2008 (has links)
<p>Offshore wind power has an increasing interest in the research community and among the politicians. Therefore it is important to find the right solutions to meet the environmental and commercial requirements to give offshore wind power a promising future. This thesis are proposing a new converter topology for offshore wind parks. Since the topology is based on DC transmission in stead of AC transmission it is better suited for use in this type of parks. All the converters are located in the wind turbines and the turbines are connected in series directly connected to shore without any transformation stages. The one-phase AC to three-phase AC converter with the new switching pattern is explained and a method to calculate the losses in the converter is given. The loss calculation method is based on the characteristics of the switch found in the data sheet, which in this case is a RB-IGBT. The conduction losses, turn-on, turn-off and recovery losses for one switch are calculated and multiplied with the number of switches in the converter. An equation of the total losses per switch is given and there are performed loss simulations for the converter in PSCAD with good results. In the AC-AC converter there are bidirectional switches, in this case two reverse-blocking IGBTs. The RB-IGBT is compared to other types of bidirectional switches which is made of IGBTs and diodes in anti parallel. The comparison shows that with the RB-IGBTs the on-state voltage drop is halved since a RB-IGBT has the same on-state voltage drop as a normal IGBT. This also reduces the on-state losses. The architecture of the RB-IGBT is almost the same as the IGBT but with an extension of the p+ layer on the edges up to the gate isolation. This separates the sides from the active region of the chip so the leakage currents from the side surfaces of the device are blocked. A design of a high power high frequency transformer for the converter topology in the nacelle of the wind turbine is proposed. A design method is used and a program to calculate the necessary values is made. The transformer should be a double E-core with a centre leg of 4.5 cm made of the ferrite material N27. Both primary and secondary windings, which will be copper foils, should be wound on the centre leg of the core using a bobbin. The primary windings will be separated in two sections each section having 12 layers with two turns per layer. The secondary windings will be sandwiched between the primary sections and will consist of 24 layers with two turns per layers. Each foil conductor has a height of 4.5 cm and a thickness of 0.3165 mm. The new converter topology reduces the converter losses due to fewer converter stages, a new type of reverse-blocking IGBT and a new switching pattern. It also reduces the weight of the converter system because of no capacitors and a lighter transformer. This is important for floating wind turbines. A prototype of the converter topology with protection should be made to verify the results of this thesis. Simulation studies for the whole park during operation and faults should also be carried out to see if the topology fits the harsh conditions offshore.</p>
|
52 |
Implementation of Permanent Magnet Motors in Electric VehiclesElvestad, Eirik January 2008 (has links)
<p>This thesis has studied permanent magnet motors in electric vehicles (EVs) under the assumption that they are tractable due to a low weight and high compactness. The implementation has been investigated through a case study, which resulted in an EV simulation model. The model contains a maximal torque per ampere and a closed-loop field weakening controller. Abstract Faults are a special concern in permanent magnet motors. Fault sources and faulted behavior are addressed separately. The EV model was used to simulate faulted behavior. Abstract Two passive fault measures are suggested as the most attractive for propulsion purpose motors; these are shutting down the inverter and imposing a balanced short to the machine terminals. The balanced three phase short circuit showed a considerable transient behavior not seen during inverter shutdown. This results in an increased requirement to the inverter rating using the balanced short. Also, demagnetization risk of rotor magnets is higher under the balanced short. Abstract The maximal braking torque during inverter shutdown was high for the simulation model, and exceeded the braking torque of any fault. This concern led to a mathematical examination of the inverter shutdown, resulting in two equations that may be of use during design. The resulting equations are based on simplifications done in the literature, and show the relationship of the balanced short to the inverter shutdown.</p>
|
53 |
Hybrid Life Cycle Assessment of Wood-based Biofuel Production and Consumption Scenarios in NorwayBright, Ryan January 2008 (has links)
<p>An increasingly urgent need to develop alternatives to fossil fuels in road trans- portation stems from both the need to combat climate change and the need to prepare for a transition beyond peak oil. Biofuels can be part of an al- ternative solution to both. In Norway, the boreal forest o®ers a considerable resource base, and emerging technologies may soon make it commercially vi- able to convert these resources into low-carbon biofuels. Therefore, it is critical that policy-makers are provided with the knowledge needed to make informed decisions regarding the environmentally sustainable production of wood-based biofuels in Norway over near- and mid-term time horizons. A combined supply-demand resource assessment was performed to map the resource base and to quantify the wood-based bioenergy potential in Norway. A set of selected conversion technologies were chosen and evaluated for a series of scenarios addressing the utilization of woody-biomass resources through each of the systems. An integrated economic input-output LCA approach was taken to perform biofuel production-consumption scenario analyses in Norway up to 2050 in e®orts to quantify climate change mitigation and fossil displacement potentials. It was found that a growing resource base, when used to produce second generation biofuels, can displace anywhere from 35-50% of fossils used in land transport which can warrant signi¯cant AGW mitigation potential both from within road transport and other key sectors.</p>
|
54 |
A Solution for Low Voltage Ride Through of Induction Generators in Wind Farms using Magnetic Energy Recovery SwitchFønstelien, Olav Jakob January 2009 (has links)
<p>Induction generators constitute 30 percent of today’s installed wind power. They are very sensitive to grid voltage disturbances and need retrofitting to enhance their low voltage ride through (LVRT) capability. LVRT of induction generators by shunt-connected FACTS controllers such as STATCOMs have been proposed in earlier studies. However, as this report concludes, in this application their VA-rating requirement is considerably higher than that of series-connected FACTS controllers. One such series FACTS controller is the magnetic energy recovery switch (MERS). It consists of four power electronic switches and a capacitor in a configuration identical to the single-phase full bridge converter. Its arrangement in an electric circuit, however, is different, with only two of the converter’s terminals utilised and connected in series. It has the characteristic of a variable capacitor and is related to FACTS controllers with series capacitors such as the GCSC and the TCSC. Successful operation of MERS for LVRT of induction generators has been demonstrated by simulations and verified by small-scale experiments. Index terms – Low voltage ride through (LVRT), magnetic energy recovery switch (MERS), series-connected FACTS controller, wind power, grid code, induction generator.</p>
|
55 |
Path Exchange Method for Hybrid Life-Cycle AssessmentBaboulet, Olivier January 2009 (has links)
<p>To keep process-specificity while extending system boundaries hybrid techniques were developed allowing the micro structure of the important parts of a system to be revealed at the same time the entire economic system in which the system is embedded to be covered. Despite the substantial improvements bestowed by hybrid techniques some downsides still hold. Tiered hybrid LCA first does not model feedbacks whereas the relationship between the process-based system and the input-output based system is interactive and second it may suffer from double counting incidents as a process may be instigated in both the IO and LCI data. Integrated hybrid LCA overcomes those aforementioned pitfalls but only at a price of high labor and data intensity. This work aims to elaborate a new hybridisation method that avoids previously mentioned drawbacks. This technique is designed to not operate anymore at the matrix level as is the case for current hybridisation techniques but at the structural path level, per se the finest level of detail possible for the disaggregation of the Leontief inverse, and as such an ad hoc basis to carry out an hybrid analysis. It is argued that the method presented here constitutes a culmination amongst hybridization techniques. Its operability and capabilities are demonstrated before an interpretation from an input-output vantage point is carried out on a case-study not to be found in the literature, a comparison across the faculties of a university.</p>
|
56 |
Offshore Power Transmission : Submarine high voltage transmission alternativesUlsund, Ragnar January 2009 (has links)
<p>Offshore power transmission is becoming an increasingly important issue. To moderate climate change, world leaders have set environmental goals that will be very difficult to reach without renewable power production and the removal of production units with high emissions. Wind power and electrification have been the focus in this report. Plans for the expensive wind power are already moving offshore. This report has made an attempt at suggesting a guideline for well-suited transmission systems, for wind power projects located at a distance in order to make them more economically attractive. Another emphasis has been to find the most suitable transmission system for gas turbines at offshore installations. As expected, the use of alternating current is best suited at shorter distances. At longer distances this system is still feasible up to 350 km, but losses will be high and there will be limited power available. A conventional thyristor-based direct current system will therefore be an attractive option for high power ratings and long distances. On the other hand, direct current based on voltage-source converters is considered more expensive, but has an improved control of reactive power and is therefore preferable to the conventional direct current system. To determine which system has the best design, one has to consider each case individually.</p>
|
57 |
Shell Eco Marathon : Electric Drive for World's Most Fuel Efficient CarFaleide, Rolv Marius January 2009 (has links)
<p>A direct driven permanent magnet synchronous machine with concentrated windings is optimized with respect to system efficiency. The goal is to win the European Shell Eco Marathon Urban Concept group using a hydrogen fuel cell and an electric motor. Considerations such as on-board energy storage, a freewheel for coasting, winding design and connections are taken into account. The result is a machine with higher efficiency at all loads and an optimal operation point at cruising speed, obtaining 93% efficiency. Considerations for further improvements in both power electronics and motor design are presented, along with a new philosophy for making very slow PMSM CW machines with multiple phases, both yielding higher efficiency and smaller requirements to structural stiffness.</p>
|
58 |
Configuration of large offshore wind farmsFlo, Randi Aardal January 2009 (has links)
<p>This master thesis is written at the Department of Electric Power Engineering at the Norwegian University of Science and Technology. The work has been carried out at NTNU in Trondheim. The thesis deals with configuration of large offshore wind farms and transmission systems, and is a continuation of the project written during the autumn 2008. Today several plans on 1000 MW offshore wind farms exists. The size of the wind farms has led to a challenge of how to find an efficient and secure design of the overall system. The system has to be cost-effective in order to compete with other forms of power generation. In this study, costs is not considered. The purpose of this thesis was to study different transmission systems and configuration of an 1000 MW wind farm located 75 km from shore. The optimal distance between the turbines is a compromise between wake effect, wind farm are and cable lengths. To perform a detailed study of wake effects and optimal spacing, computer programs like WindSim would be necessary. Three common wind farm configurations is radial, star and ring layout. The selection of layout depends on costs, wind data and the wind farm area. Various wind turbine systems have been developed and different wind generators have been built. According to the survey of different wind generator system and considering the grid connection requirements on wind turbines, the developing trends of wind turbine generator systems shows that variable speed is very attractive and concepts with full-scale power converters will become more attractive. In this thesis two wind farm configurations with different transmission system were further studied. AC/AC, AC/DC and DC/DC are possible transmission systems. In this thesis AC/AC and AC/DC were compared. The selected layout of the wind farm was the radial layout. Number of strings was 35, with eight turbines in each string. Each wind turbine could produce 3.6 MW, which gives a total generation of 1008 MW. The two configurations were modeled in PSS/E. Siemens has made a model called WT3 that was developed to simulate performance of a wind turbine employing a doubly fed induction generator (DFIG). The model was developed in close cooperation with the GE Energy modeling team. This model was used in this thesis. For the dc transmission the HVDC Light from ABB was used. Two different disturbances were applied. One at the connection point at shore, and one at the connection point for all the radials. The load flow results shows that the losses are 5.8$%$ higher in the AC/DC system. The dynamical result shows that both of the systems were stable, and fulfill the grid code requirements. The results indicates that the short-circuit MVA is higher in the ac system than in the dc system. After a fault the voltage recovery was more smoother in the dc system, and the voltage recovery time were shorter.</p>
|
59 |
Life Cycle Assessment of Offshore Wind Electricity Generation in ScandinaviaTveten, Åsa Grytli January 2009 (has links)
<p>In this study a Multi Regional Input Output model has been developed for the base year 2000, and thereafter extended and hybridized to enable a study of offshore wind power generation in Scandinavia. Foremost the per-unit environmental impact of offshore wind power generation was calculated to an average of 16.5 grams of CO2-eq. per kWh. The MRIO model offers a broad system boundary, covering a complete set of background flows and enables in this way a thorough study of the inter-regional value chains and the corresponding emissions embodied in trade. Scenarios from 2000 to 2030 for future offshore wind power were developed on the basis of GDP projections and projections for future energy demand. One baseline scenario, assuming no further offshore wind power installation, was developed, together with a Medium and a High scenario of future offshore wind power installation. The installed wind power was assumed to replace non-renewable energy sources, primarily domestically and secondly in power importing countries. The Medium and High scenario resulted in a cumulative reduction of 220 Mtons CO2-equivalents and 308 Mtons by 2030, respectively. The Norwegian offshore wind power was by a large exported, while Denmark and Sweden experienced a substantial wind power implementation into their economies, resulting in considerable increase in the percentage share of renewable energy in their electricity mix. This shows that offshore wind power could have a vital role in reaching the European Unions target of a 20% share of renewable energy by 2020, under the assumption that a substantial capacity of wind power is installed. The results from this study provide important guidance and a broad overview of the effect a large wind power implementation will have on the Scandinavian economy.</p>
|
60 |
Development and Aplication of Mathematical Programs for Contribution Analysis in Life Cycle AssessmentVlad, Monica January 2009 (has links)
<p>The environmental impact of a final product can be regarded as the sum of the impacts of all processes needed to obtain it. The impacts of these processes in all individual layers of production can be quantified using contribution analysis methods. SPA is an advanced method used to identify the chain of production processes linking the most highly emitting process with the final product. This analysis was performed in Matlab, using a specialized algorithm developed by Peters and Hertwich in 1996. In this thesis we test an interdisciplinary approach combining LCA and operational research methods for doing a SPA. A mixed integer program was developed and implemented in Gams. The performance of this generalized algorithm was benchmarked against the specialized algorithm for three test cases performed on three databases of increasing complexity. The results suggest the advantage of this algorithm in performing analysis on sparse data systems compared with the classic method involving Matlab. However, Matlabs specialized algorithm performs better for dense data systems. Many of the requirements and limitations imposed by the software involved in different steps have proved manageable. This study proves that mathematical programming can be a very useful tool for contribution analysis in general and SPA in particular.</p>
|
Page generated in 0.0246 seconds