Spelling suggestions: "subject:"NOx 2mission"" "subject:"NOx 2emission""
1 |
Modeling The NOx Emissions In A Low NOx Burner While Fired With Pulverized Coal And Dairy Biomass BlendsUggini, Hari 2012 May 1900 (has links)
New regulations like the Clean Air Interstate Rule (CAIR) will pose greater challenges for Coal fired power plants with regards to pollution reduction. These new regulations plan to impose stricter limits on NOX reduction. The current regulations by themselves already require cleanup technology; newer regulations will require development of new and economical technologies.
Using a blend of traditional fuels & biomass is a promising technology to reduce NOX emissions. Experiments conducted previously at the Coal and Biomass energy lab at Texas A&M reported that dairy biomass can be an effective Reburn fuel with NOX reduction of up to 95%; however little work has been done to model such a process with Feedlot Biomass as a blend with the main burner fuel. The present work concerns with development of a zero dimensional for a low NOx burner (LNB) model in order to predict NOX emissions while firing a blend of Coal and dairy biomass. Two models were developed. Model I assumes that the main burner fuel is completely oxidized to CO,CO2,H20 and fuel bound nitrogen is released as HCN, NH3, N2; these partially burnt product mixes with tertiary air, undergoes chemical reactions specified by kinetics and burns to complete combustion. Model II assumes that the main burner solid fuel along with primary and secondary air mixes gradually with recirculated gases, burn partially and the products from the main burner include partially burnt solid particles and fuel bound nitrogen partially converted to N2, HCN and NH3. These products mix gradually with tertiary air, undergo further oxidation-reduction reactions in order to complete the combustion. The results are based on model I. Results from the model were compared with experimental findings to validate it.
Results from the model recommend the following conditions for optimal reduction of NOx: Equivalence Ratio should be above 0.95; mixing time should be below 100ms. Based on Model I, results indicate that increasing percentage of dairy biomass in the blend increases the NOx formation due to the assumption that fuel N compounds ( HCN, NH3) do not undergo oxidation in the main burner zone. Thus it is suggested that model II must be adopted in the future work.
|
2 |
Numerical Study of NOx and Flame Shape of a DLE BurnerHamedi, Naser January 2012 (has links)
For natural gas combustion, there is a large amount of experience in the gas turbine industry. However, much of the design work is based on costly combustion tests due to insufficient accuracy of existing prediction tools for data such as emissions and effects due to fuel composition. In the present work, Computational Fluid Dynamics (CFD) approach is used to study partially premixed combustion in the 3rd generation DLE (Dry Low Emission) burner that is used in SGT-700 and SGT-800 gas turbines. The fuels that are studied here are natural gas and enriched hydrogen fuel. The CFD models which are used in this work are an axisymmetric and a 3D model and the softwares are ANSYS CFX and ANSYS FLUENT. One of the main objectives of this thesis is the study of flame shape and NOx emission in hydrogen enriched combustion. In the first study of the present work, effect of adding hydrogen to non-preheated gas combustion was investigated and the results were compared with the available measurement data. Calculated laminar burning velocity with CANTERA showed a good agreement with the experimental and numerical references. Also, the accuracy of generated flamelet libraries in CFD tools to calculate adiabatic flame temperature was compared with different available tools. Results showed good agreement between available tools for the ranges of interest. In addition, flame shape and NOx prediction was studied in the gas turbine burner. Adding hydrogen to the fuel increased significantly turbulent burning velocity and OH distribution in the domain. The effect of hydrogen on the central stagnation point was studied and the simulation results did not show a significant effect on the stagnation point location. Beside the flame shape, this study showed that although the CFD NOx prediction tools in ANSYS CFX and ANSYS FLUENT predict the trend of NOx and the flame propagation in the right manner, in order to use as a reliable prediction tool in the gas turbine industry they need to be improved.
|
3 |
Environmental Technology ManagementAl-Harbi, Meshari 24 March 2008 (has links)
With steadily increasing emissions regulations being imposed by government agencies, automobile manufacturers have been developing technologies to mitigate NOX emissions. Furthermore, there has been increasing focus on CO2 emissions. An effective approach for CO2 reduction is using lean burn engines, such as the diesel engine. An inherent problem with lean-burn engine operation is that NOX needs to be reduced to N2, but there is an excess of O2 present. NOX storage and reduction (NSR) is a promising technology to address this problem. This technology operates in two phases; where in the lean phase, normal engine operation, NOX species are stored as nitrates, and in a reductant rich phase, relative to O2, the NOx storage components are cleaned and the NOX species reduced to N2.
In this study, the effects of reductant type, specifically CO and/or H2, and their amounts as a function of temperature on the trapping and reduction of NOX over a commercial NSR catalyst have been evaluated. Overall, the performance of the catalyst improved with each incremental increase in H2 concentration. CO was found ineffective at 200°C due to precious metal site poisoning. The addition of the H2 to CO-containing mixtures resulted in improved performance at 200°C, but the presence of the CO still resulted in decreased performance in comparison to activity when just H2 was used. At 300-500°C, H2, CO, and mixtures of the two were comparable for trapping and reduction of NOX, although the mixtures led to slightly improved performance.
Although NSR technology is very efficient in reducing NOX emissions, a significant challenge that questions their long-term durability is poisoning by sulfur compounds inherently present in the exhaust. Therefore, during operation, NSR catalysts require an intermittent high-temperature exposure to a reducing environment to purge the sulfur compounds from the catalyst. This desulfation protocol ultimately results in thermal degradation of the catalyst. As a second phase of this study, the effect of thermal degradation on the performance of NSR technology was evaluated. The catalyst performance between a 200 to 500°C temperature range, using H2, CO, and a mixture of both H2 and CO as reductants was tested before and after different high-temperature aging steps. Tests included water-gas shift (WGS) reaction extent, NO oxidation, NOX storage capacity, oxygen storage capacity (OSC), and NOX reduction efficiency during cycling. The WGS reaction extent was affected by thermal degradation, but only at low temperature. NO oxidation did not show a consistent trend as a function of thermal degradation. The total NOX storage capacity was tested at 200, 350 and 500°C. Little change was observed at 500°C with thermal degradation and a steady decrease was observed at 350°C. At 200°C, there was also a steady decrease of NOX storage capacity, except after aging at 700°C, where the capacity increased. There was also a steady decrease in oxygen storage capacity at test temperatures between 200 and 500°C after each increase in thermal degradation temperature, except again when the sample was degraded at 700°C, where an increase was observed. In the cycling experiments, a gradual drop in NOX conversion was observed after each thermal degradation temperature, but when the catalyst was aged at 700°C, an increase in NOX conversion was observed. These data suggest that there was redispersion of a trapping material component during the 700°C thermal degradation treatment while the oxygen storage capacity data indicate redispersion of oxygen storage components. It therefore seems likely that it is these oxygen storage components that are becoming ‘‘activated’’ as trapping materials at low temperature.
|
4 |
Environmental Technology ManagementAl-Harbi, Meshari 24 March 2008 (has links)
With steadily increasing emissions regulations being imposed by government agencies, automobile manufacturers have been developing technologies to mitigate NOX emissions. Furthermore, there has been increasing focus on CO2 emissions. An effective approach for CO2 reduction is using lean burn engines, such as the diesel engine. An inherent problem with lean-burn engine operation is that NOX needs to be reduced to N2, but there is an excess of O2 present. NOX storage and reduction (NSR) is a promising technology to address this problem. This technology operates in two phases; where in the lean phase, normal engine operation, NOX species are stored as nitrates, and in a reductant rich phase, relative to O2, the NOx storage components are cleaned and the NOX species reduced to N2.
In this study, the effects of reductant type, specifically CO and/or H2, and their amounts as a function of temperature on the trapping and reduction of NOX over a commercial NSR catalyst have been evaluated. Overall, the performance of the catalyst improved with each incremental increase in H2 concentration. CO was found ineffective at 200°C due to precious metal site poisoning. The addition of the H2 to CO-containing mixtures resulted in improved performance at 200°C, but the presence of the CO still resulted in decreased performance in comparison to activity when just H2 was used. At 300-500°C, H2, CO, and mixtures of the two were comparable for trapping and reduction of NOX, although the mixtures led to slightly improved performance.
Although NSR technology is very efficient in reducing NOX emissions, a significant challenge that questions their long-term durability is poisoning by sulfur compounds inherently present in the exhaust. Therefore, during operation, NSR catalysts require an intermittent high-temperature exposure to a reducing environment to purge the sulfur compounds from the catalyst. This desulfation protocol ultimately results in thermal degradation of the catalyst. As a second phase of this study, the effect of thermal degradation on the performance of NSR technology was evaluated. The catalyst performance between a 200 to 500°C temperature range, using H2, CO, and a mixture of both H2 and CO as reductants was tested before and after different high-temperature aging steps. Tests included water-gas shift (WGS) reaction extent, NO oxidation, NOX storage capacity, oxygen storage capacity (OSC), and NOX reduction efficiency during cycling. The WGS reaction extent was affected by thermal degradation, but only at low temperature. NO oxidation did not show a consistent trend as a function of thermal degradation. The total NOX storage capacity was tested at 200, 350 and 500°C. Little change was observed at 500°C with thermal degradation and a steady decrease was observed at 350°C. At 200°C, there was also a steady decrease of NOX storage capacity, except after aging at 700°C, where the capacity increased. There was also a steady decrease in oxygen storage capacity at test temperatures between 200 and 500°C after each increase in thermal degradation temperature, except again when the sample was degraded at 700°C, where an increase was observed. In the cycling experiments, a gradual drop in NOX conversion was observed after each thermal degradation temperature, but when the catalyst was aged at 700°C, an increase in NOX conversion was observed. These data suggest that there was redispersion of a trapping material component during the 700°C thermal degradation treatment while the oxygen storage capacity data indicate redispersion of oxygen storage components. It therefore seems likely that it is these oxygen storage components that are becoming ‘‘activated’’ as trapping materials at low temperature.
|
5 |
Development and Validation of a NOx Emission Testing Setup for a Diesel Engine, Fueled with Bio-DieselKohli, Dhruv 27 April 2009 (has links)
No description available.
|
6 |
Simulation Of Circulating Fluidized Bed Combustors Firing Indigenous LigniteOzkan, Mert 01 November 2010 (has links) (PDF)
A comprehensive model, previously developed for a rectangular parallelepiped shaped 0.3 MWt circulating fluidized bed combustor (CFBC) fired with high calorific value coal burning in sand and validated against experimental data is adapted to cylindrical configuration and is extended to incorporate NOx formation and reduction reactions and pressure drops around cyclone, downcomer and loop seal. Its predictive accuracy is tested by applying it to the simulation of Middle East Technical University (METU) 150 kWt CFBC burning low calorific value indigenous lignite with high Volatile Matter/Fixed Carbon (VM/FC) ratio in its own ash and comparing its predictions with measurements. Favorable comparisons are obtained between the predicted and measured temperatures, pressure profiles and emissions of gaseous species. Results reveal that predictive accuracy in pressure profile strongly depends on the correlation utilized for entrainment in dilute zone and that accuracy in NO emission requires data on
partitioning of coal nitrogen into char-N and volatile-N and is affected significantly by dilute zone oxygen content.
|
7 |
The influence of CO₂ pricing on NOx emissions programsPaine, Jeffery Hubbard 14 February 2011 (has links)
Electricity generating units (EGUs) are major emitters of both nitrogen oxides (NOx) and CO₂, and cap-and-trade programs are either currently used or proposed as management strategies for both pollutants. Emission cap and trade programs for these two pollutants have generally been considered independently, but since each EGU will have a characteristic NOx to CO₂ emission ratio, these programs are inherently connected. This thesis examines the extent to which CO₂ emission pricing and NOx emission markets are likely to influence each other, using Texas as a case study. The relationship is first demonstrated with a simple scenario of four power plants, followed by a second scenario accounting for the largest 34 plants in Texas. The analysis demonstrates that future CO₂ pricing will cause NOx emissions markets to be inefficient at reducing emissions through changes in the dispatching order. There will also exist a greater potential for NOx price spikes. Two plausible alternatives to this problem are suggested: a temporally- and spatially-variable NOx program, or increased emphasis on retrofitting the existing fleet of power plants for NOx reduction. / text
|
8 |
Effects Of Transport Properties And Flame Unsteadiness On Nitrogen Oxides Emissions From Laminar Hydrogen Jet Diffusion FlamesPark, Doyoub 01 January 2005 (has links)
Experimental studies on the coupled effects of transport properties and unsteady fluid dynamics have been conducted on laminar, acoustically forced, hydrogen jet diffusion flames diluted by argon and helium. The primary purpose of this research is to determine how the fuel Lewis number and the flow unsteadiness play a combined role in maximum flame temperature and affect NOx emission from jet diffusion flame. The fuel Lewis number is varied by increasing/decreasing the mole fraction of diluents in the fuel stream. Therefore, maximum flame temperatures and then NOx emission levels were expected to differ for Ar- and He-diluted flames. In an investigation of unsteady flames, two different frequencies (10 and 100 Hz) were applied to observe a behavior of NOx emission levels and flame lengths by changes of unsteady fluid dynamics and transport properties.
|
9 |
Characterization of a Novel Porous Injector for Multi-Lean Direct Injection (M-LDI) CombustorLi, Jianing 29 October 2018 (has links)
No description available.
|
10 |
The Study of NO<sub>x</sub> Emission as Affected by the Chemical Properties of Ohio Coals in a Drop Tube ReactorJung, Kyung Sook 03 December 2001 (has links)
No description available.
|
Page generated in 0.0838 seconds