No / Near field imaging using microwaves in medical applications has gained much attention recently as various researchers have shown its capability and accuracy in identifying features of interest compared to well-known screening tools. This paper documents microwave imaging experiments for breast cancer detection. A simple phantom consisting of a plastic container with a low dielectric material imitating fatty tissue and a high dielectric constant object emulating tumor is scanned with a UWB microstrip antenna between 4 to 8 GHz. The measured results indicate that the prototype is a good candidate for imaging application.

This thesis presents studies of novel terahertz photonic devices, including photoconductive optoelectronic devices and guided-wave components, aimed at the development of next-generation terahertz systems. In chapter 2, a scalable interdigitated THz transmitter is designed to increase the output power and compared with a conventional 50 μm coplanar transmitter. In chapter 3, we compare four different receivers with different antenna geometries in terms of bandwidth and sensitivity. Then we describe a photoconductive near-field detector with a subwavelength aperture and its system integration and characterization. In chapter 4, a parallel metal plate waveguide is designed with an integrated step inside the waveguide that can couple to higher order TM modes efficiently from the TEM mode. In this chapter, we also experimentally and numerically study a 2-dimensionally tapered parallel plate waveguide, by which a free-space THz beam can be focused into a deep subwavelength-scale volume. In chapter 5, a parallel thin dielectric film waveguide is used to explore the guiding mechanism of an antiresonant optical reflection waveguide. Cylindrical silica single capillaries and a microstructured capillary, which guide in a similar way, are characterized in terms of mode profiles and attenuation. In chapter 6, we study oblique transmission through freestanding thin nickel films, which are perforated with periodic conical hole arrays. Surface modes can be supported by both metallic surfaces with different nonlinear dispersion curves, which results in spectral interferences in a near-field region when the surface modes couple out of the waveguide into free space.

In the last decade, design and application of negative materials have been one of the most interesting subjects in the electromagnetic research. The extraordinary properties of double negative (DNG) and single negative (SNG) materials have been studied extensively over this period. In this thesis, one of the unusual properties of negative materials, the evanescent amplification, is used to improve the sensitivity of the near field probes. The effect of placing DNG and SNG layers between the near field probes and the targets are investigated theoretically. A sensitivity definition is introduced for evanescent probes and it is shown using quantitative measures that the sensitivity can be increased using DNG and SNG materials for a target in vacuum and for a buried target. The electromagnetic loss of the negative materials and the mismatch between the material properties of the host medium and DNG and SNG materials are studied. Using an unmatched DNG layer or SNG layer enhances the sensitivity within an evanescent spectrum range while a lossless and matched DNG layer improves the sensitivity of entire evanescent spectrum. The idea of using negative materials is implemented over conventional near field probes by numerical experiments. Sensitivities of open-ended waveguides and open-ended coaxial lines for a specific application are studied in the presence of negative materials. In the case of precursor pitting detection on airplane bodies, the sensitivity of an open-ended waveguide probe is increased by 35 times for a λ/10 sized cubic crack. It is also shown that the negative material increases the quality of the image generated by the probe. The sensitivity improvement is also verified for an open-ended coaxial line. A 11 times improvement is achieved for a similar detection practice, with a λ/20 sized crack. The effect of coaxial line size and the dielectric material on the sensitivity enhancement are studied. The improvement is studied theoretically and numerically for an electrically small dipole. Theoretical studies show that when a small dipole is placed within a spherical shell made of DNG materials, the antenna parameters of the dipole becomes more sensitive to the position of a target placed outside the negative material shell. The field distribution generated by a small dipole in a multilayered spherical medium is studied for this purpose. Numerical analysis of a small dipole placed next to a planar DNG layer is presented. The DNG layer increases the sensitivity of the dipole due to a λ/30 sized metallic target by 5.5 times. To provide experimental verification, the sensitivity of an electrically small loop is studied. SNG materials with a negative permeability around 1.25 GHz are designed using modified split ring resonators (MSRR). By using the effective parameters of the designed structure, a sensitivity improvement of 10 times is achieved numerically. The improvement is verified using fabricated MSRR structures. The sensitivity of the small loop is enhanced by 9 times for a λ/12.2 sized metallic target. The sensitivity improvements are achieved within the frequency band where the MSRR structures behave as a μ-negative SNG material.

In the last decade, design and application of negative materials have been one of the most interesting subjects in the electromagnetic research. The extraordinary properties of double negative (DNG) and single negative (SNG) materials have been studied extensively over this period. In this thesis, one of the unusual properties of negative materials, the evanescent amplification, is used to improve the sensitivity of the near field probes. The effect of placing DNG and SNG layers between the near field probes and the targets are investigated theoretically. A sensitivity definition is introduced for evanescent probes and it is shown using quantitative measures that the sensitivity can be increased using DNG and SNG materials for a target in vacuum and for a buried target. The electromagnetic loss of the negative materials and the mismatch between the material properties of the host medium and DNG and SNG materials are studied. Using an unmatched DNG layer or SNG layer enhances the sensitivity within an evanescent spectrum range while a lossless and matched DNG layer improves the sensitivity of entire evanescent spectrum. The idea of using negative materials is implemented over conventional near field probes by numerical experiments. Sensitivities of open-ended waveguides and open-ended coaxial lines for a specific application are studied in the presence of negative materials. In the case of precursor pitting detection on airplane bodies, the sensitivity of an open-ended waveguide probe is increased by 35 times for a λ/10 sized cubic crack. It is also shown that the negative material increases the quality of the image generated by the probe. The sensitivity improvement is also verified for an open-ended coaxial line. A 11 times improvement is achieved for a similar detection practice, with a λ/20 sized crack. The effect of coaxial line size and the dielectric material on the sensitivity enhancement are studied. The improvement is studied theoretically and numerically for an electrically small dipole. Theoretical studies show that when a small dipole is placed within a spherical shell made of DNG materials, the antenna parameters of the dipole becomes more sensitive to the position of a target placed outside the negative material shell. The field distribution generated by a small dipole in a multilayered spherical medium is studied for this purpose. Numerical analysis of a small dipole placed next to a planar DNG layer is presented. The DNG layer increases the sensitivity of the dipole due to a λ/30 sized metallic target by 5.5 times. To provide experimental verification, the sensitivity of an electrically small loop is studied. SNG materials with a negative permeability around 1.25 GHz are designed using modified split ring resonators (MSRR). By using the effective parameters of the designed structure, a sensitivity improvement of 10 times is achieved numerically. The improvement is verified using fabricated MSRR structures. The sensitivity of the small loop is enhanced by 9 times for a λ/12.2 sized metallic target. The sensitivity improvements are achieved within the frequency band where the MSRR structures behave as a μ-negative SNG material.

No description available.

Yes / The potentially broad application area in engineering design using Genetic Al- gorithm (GA) has been widely adopted by many researchers due to its high consistency and accuracy. Presented here is the initial design of a wideband non-dispersive wire bow-tie antenna using GA for breast cancer detection applications. The ultimate goal of this design is to achieve minimal late-time ringing but at higher frequencies such as that located from 4 to 8 GHz, in which is desire to penetrate human tissue for near field imaging. Resistively loading method to reduce minimal ringing caused by the antenna internal reflections is implemented and discussed when the antenna is located in free space and surrounded by lossy medium. Results with optimised antenna geometry and di®erent number of resistive loads are presented and compared with and without existence of scatterers.

abstract: To detect and resolve sub-wavelength features at optical frequencies, beyond the diffraction limit, requires sensors that interact with the electromagnetic near-field of those features. Most instruments operating in this modality scan a single detector element across the surface under inspection because the scattered signals from a multiplicity of such elements would end up interfering with each other. However, an alternative massively parallelized configuration, consisting of a remotely interrogating array of dipoles, capable of interrogating multiple adjacent areas of the surface at the same time, was proposed in 2002. In the present work a remotely interrogating slot antenna inside a 60nm silver slab is designed which increases the signal to noise ratio of the original system. The antenna is tuned to resonance at 600nm range by taking advantage of the plasmon resonance properties of the metal’s negative permittivity and judicious shaping of the slot element. Full-physics simulations show the capability of detecting an 8nm particle using red light illumination. The sensitivity to the λ/78 particle is attained by detecting the change induced on the antenna’s far field signature by the proximate particle, a change that is 15dB greater than the scattering signature of the particle by itself. To verify the capabilities of this technology in a readily accessible experimental environment, a radiofrequency scale model is designed using a meta-material to mimic the optical properties of silver in the 2GHz to 5GHz range. Various approaches to the replication of the metal’s behavior are explored in a trade-off between fidelity to the metal’s natural plasmon response, desired bandwidth of the demonstration, and ii manufacturability of the meta-material. The simulation and experimental results successfully verify the capability of the proposed near-field sensor in sub-wavelength detection and imaging not only as a proof of concept for optical frequencies but also as a potential imaging device for radio frequencies. / Dissertation/Thesis / Doctoral Dissertation Electrical Engineering 2016

Using a near-field array of acoustic resonators, it is possible to modify a focused pressure field and enforce a spatial frequency corresponding to the resonator array spacing. This higher spatial frequency makes it possible to focus and image with a resolution that is better than if the focusing were in free space. This near-field effect is caused by the phase shifting properties of resonators and, specifically, the delayed phase found in waves with a temporal frequency lower than that of the resonators in the array. Using time reversal, arrays of resonators are explored and the subwavelength focusing is used to describe the ability to image subwavelength features. A one-dimensional equivalent circuit model accurately predicts this interaction of the wave field with an array of resonators and is able to model the aggregate effect of the phononic crystal of resonators while describing the fine spatial details of individual resonators. This model is validated by a series of COMSOL full-wave simulations of the same system. The phase delay caused by a single resonator is explored in a simple experiment as well as in the equivalent circuit model. A series of experiments is conducted with a two-dimensional array of resonators and complex images are produced which indicate the ability to focus complex sources with better resolution.

Yes / Near field imaging using microwaves in medical applications is of great current interest for its capability and accuracy in identifying features of interest, in comparison with other known screening tools. This paper documents microwave imaging experiments on breast cancer detection, using active antenna tuning to obtain matching over a wide bandwidth. A simple phantom consisting of a plastic container with a low dielectric material emulating fatty tissue and a high dielectric constant object emulating a tumor is scanned between 4 to 8 GHz with a UWB microstrip antenna. Measurements indicate that this prototype microwave sensor is a good candidate for such imaging applications. / Yorkshire Innovation Fund, Research Development Project (RDP)

Near field imaging using microwave in medical applications has gain much attention recently as various researches show its high ability and accuracy in illuminating object comparing to the well-known screening tools such as Magnetic Resonance Imaging (MRI), digital mammography, ultrasound etc. This has encourage and motivate scientists continue to exploit the potential of microwave imaging so that a better and more powerful sensing tools can be developed. This thesis documents the development of antenna design for microwave imaging application such as breast cancer detection. The application is similar to the concept of Ground Penetrating Radar (GPR) but operating at higher frequency band. In these systems a short pulse is transmitted from an antenna to the medium and the backscattered response is investigated for diagnose. In order to accommodate such a short pulse, a very wideband antenna with a minimal internal reflection is required. Printed monopole and planar metal plate antenna is implemented to achieve the necessary operating wide bandwidth. The development of new compact printed planar metal plate ultra wide bandwidth antenna is presented. A generalized parametric study is carried out using two well-known software packages to achieve optimum antenna performance. The Prototype antennas are tested and analysed experimentally, in which a reasonable agreement was achieved with the simulations. The antennas present an excellent relative wide bandwidth of 67% with acceptable range of power gain between 3.5 to 7 dBi. A new compact size air-dielectric microstrip patch-antenna designs proposed for breast cancer detection are presented. The antennas consist of a radiating patch mounted on two vertical plates, fed by coaxial cable. The antennas show a wide bandwidth that were verified by the simulations and also confirmed experimentally. The prototype antennas show excellent performance in terms the input impedance and radiation performance over the target range bandwidth from 4 GHz to 8 GHz. A mono-static model with a homogeneous dielectric box having similar properties to human tissue is used to study the interaction of the antenna with tissue. The numerical results in terms the matching required of new optimised antennas were promising. An experimental setup of sensor array for early-stage breast-cancer detection is developed. The arrangement of two elements separated by short distance that confined equivalent medium of breast tissues were modelled and implemented. The operation performances due to several orientations of the antennas locations were performed to determine the sensitivity limits with and without small size equivalent cancer cells model. In addition, a resistively loaded bow tie antenna, intended for applications in breast cancer detection, is adaptively modified through modelling and genetic optimisation is presented. The required wideband operating characteristic is achieved through manipulating the resistive loading of the antenna structure, the number of wires, and their angular separation within the equivalent wire assembly. The results show an acceptable impedance bandwidth of 100.75 %, with a VSWR < 2, over the interval from 3.3 GHz to 10.0 GHz. Feasibility studies were made on the antenna sensitivity for operation in a tissue equivalent dielectric medium. The simulated and measured results are all in close agreement.