International Telemetering Conference Proceedings / October 18-21, 2004 / Town & Country Resort, San Diego, California / Digital modulation schemes that are power and bandwidth efficient are highly desirable. After non-linear amplification has been done, signal modulation schemes having constant or quasi-constant envelopes are not as susceptible to spectral regrowth as those with non-constant envelopes. Since such distortion generates interference in the adjacent channels, the power operation of the amplifier in non-constant envelope modulations is typically backed off, resulting in systems with reduced power efficiency. On the other hand, constant envelope modulation may have different bandwidth spectra. This paper examines the statistical characteristics of N-GMSK and N-FQPSK [1] signals to assess the bandwidth efficiency in the presence of amplifier nonlinearities.

International Telemetering Conference Proceedings / October 27-30, 1997 / Riviera Hotel and Convention Center, Las Vegas, Nevada / A simple, low cost radio frequency (RF) power and spectrally efficient integrated transceiver/modem architecture employing Feher’s patented Quadrature Phase Shift Keying (FQPSK) is described. The FQPSK signals presented in this paper are obtained by using additional post low-pass filters in the FQPSK architecture. This implementation significantly improves the spectral efficiency of the worldwide commercially standardized Gaussian Minimum Shift Keying (GMSK) systems. The Bit Error Rate (BER) performance of FQPSK in additive white Gaussian noise (AWGN) channel has been investigated by means of computer simulation and hardware prototype measurements. The results of the hardware and software simulations are compared to GMSK and QPSK/OQPSK performance. These results show that the filtered FQPSK modulated signal passing through a non-linear amplifier (NLA) can achieve a spectral efficiency improvement of about 60% over NLA filtered OQPSK and an integrated spectral efficiency improvement of 50% over GMSK and a better BER performance. In particular, 100 kb/s to 34 Mb/s hardware experimental results over 2.4 GHz NLA (saturated) 1 Watt system confirmed that FQPSK hardware systems attain a BER=f(Eb/N0) performance within 1 dB to 2 dB of predicted theoretical results.

International Telemetering Conference Proceedings / October 25-28, 1999 / Riviera Hotel and Convention Center, Las Vegas, Nevada / This paper describes the design considerations used by Aydin Telemetry in the development of its high data rate Feher Patented Quadrature Phase Shift Keying (FQPSK) [1] frequency agile transmitter. We will address several key areas of interest to the Telemetry community, such as the use of commercially available VLSI parts to minimize parts count while maximizing reliability, adaptive filtering to accommodate a wide range of data rates, and user selectable features to achieve a universal transmitter design. User selectable features include differential encoder, 15 stage IRIG randomizer, and 1/2 rate convolutional FEC coding. This paper also addresses the spectral efficiency that can be achieved using a Class-C amplifier with FQPSK and the measured bit error rate (BER) performance versus Eb/No.

This work is focused on design of L band power amplifier. First, the design of the amplifier is substantiated by necessary theoretical basics of RF power amplifiers. Then, after comparsion of availible RF power amplifiers concepts, the doherty power amplifier is chosen as a suitable type. Design of the amplifier is focused on the linearity and efficiency. AWR design program is used for simulation of the amplifier. Amplifier is then realized and parameters are measured. Measured results are then discussed and evaluated. This work proposes design of the linear doherty amplifier for modern communications systems.

<p>This thesis is concerned with the use of multiple antenna elements in wireless communication over frequency non-selective radio channels. Both measurement results and theoretical analysis are presented. New transmit strategies are derived and compared to existing transmit strategies, such as beamforming and space-time block coding (STBC). It is found that the best transmission algorithm is largely dependent on the channel characteristics, such as the number of transmit and receive antennas and the existence of a line of sight component. Rayleigh fading multiple input multiple output (MIMO) channels are studied using an eigenvalue analysis and exact expressions for the bit error rates and outage capacities for beamforming and STBC is found. In general are MIMO fading channels correlated and there exists a mutual coupling between antenna elements. These findings are supported by indoor MIMO measurements. It is found that the mutual coupling can, in some scenarios, increase the outage capacity. An adaptive antenna testbed is used to obtain measurement results for the single input multiple output (SIMO) channel. The results are analyzed and design guidelines are obtained for how a beamformer implemented in hardware shall be constructed. The effects of nonlinear transmit amplifiers in array antennas are also analyzed, and it is shown that an array reduces the effective intermodulation distortion (IMD) transmitted by the array antenna by a spatial filtering of the IMD. A novel frequency allocation algorithm is proposed that reduces IMD even further. The use of a low cost antenna with switchable directional properties, the switched parasitic antenna, is studied in a MIMO context and compared to array techniques. It is found that it has comparable performance, at a fraction of the cost for an array antenna.</p>

This thesis is concerned with the use of multiple antenna elements in wireless communication over frequency non-selective radio channels. Both measurement results and theoretical analysis are presented. New transmit strategies are derived and compared to existing transmit strategies, such as beamforming and space-time block coding (STBC). It is found that the best transmission algorithm is largely dependent on the channel characteristics, such as the number of transmit and receive antennas and the existence of a line of sight component. Rayleigh fading multiple input multiple output (MIMO) channels are studied using an eigenvalue analysis and exact expressions for the bit error rates and outage capacities for beamforming and STBC is found. In general are MIMO fading channels correlated and there exists a mutual coupling between antenna elements. These findings are supported by indoor MIMO measurements. It is found that the mutual coupling can, in some scenarios, increase the outage capacity. An adaptive antenna testbed is used to obtain measurement results for the single input multiple output (SIMO) channel. The results are analyzed and design guidelines are obtained for how a beamformer implemented in hardware shall be constructed. The effects of nonlinear transmit amplifiers in array antennas are also analyzed, and it is shown that an array reduces the effective intermodulation distortion (IMD) transmitted by the array antenna by a spatial filtering of the IMD. A novel frequency allocation algorithm is proposed that reduces IMD even further. The use of a low cost antenna with switchable directional properties, the switched parasitic antenna, is studied in a MIMO context and compared to array techniques. It is found that it has comparable performance, at a fraction of the cost for an array antenna.