京都大学 / 0048 / 新制・課程博士 / 博士(エネルギー科学) / 甲第22552号 / エネ博第403号 / 新制||エネ||77(附属図書館) / 京都大学大学院エネルギー科学研究科エネルギー変換科学専攻 / (主査)教授 石山 拓二, 教授 川那辺 洋, 教授 今谷 勝次 / 学位規則第4条第1項該当 / Doctor of Energy Science / Kyoto University / DGAM

京都大学 / 0048 / 新制・課程博士 / 博士(エネルギー科学) / 甲第17917号 / エネ博第289号 / 新制||エネ||60(附属図書館) / 30737 / 京都大学大学院エネルギー科学研究科エネルギー変換科学専攻 / (主査)教授 石山 拓二, 教授 星出 敏彦, 准教授 川那辺 洋 / 学位規則第4条第1項該当 / Doctor of Energy Science / Kyoto University / DGAM

The objective of this thesis is to investigate and compare the performance and emissions characteristics of diesel-ignited methane and diesel-ignited propane dual fuel LTC in a single cylinder research engine (SCRE) at a constant engine load of 5.1 bar net indicated mean effective pressure (IMEP) and at a constant engine speed of 1500 RPM. Percentage of energy substitution of propane or methane (0 - 90 percent), diesel injection timing (SOI: 355 CAD – 280 CAD), rail pressure (200 bar – 1300 bar) and boost pressure (1.1 bar – 1.8 bar) were varied to quantify their impact on engine performance and engine-out ISNOx, ISHC, ISCO, and smoke emissions. Advancing SOI to 310 CAD and beyond yielded simultaneous ISNOx and smoke emissions. A rail pressure of 500 bar was the optimal one for both fueling combinations while increasing boost pressure over 1.2 bar had a very little effect on ISNOx and smoke emissions.

Controlled Auto Ignition (CAI) combustion is a new combustion principle in internal combustion engines which has in recent years attracted increased attention. In CAI combustion, which combines features of spark ignition (SI) and compression ignition (CI) principles, air/fuel mixture is premixed, as in SI combustion and auto-ignited by piston compression as in CI combustion. Ignition is provided in multiple points, and thus the charge gives a simultaneous energy release. This results in uniform and simultaneous auto-ignition and chemical reaction throughout the whole charge without flame propagation. CAI combustion is controlled by the chemical kinetics of air/fuel mixture with no influence of turbulence. The CAI engine offers benefits in comparison to spark ignited and compression ignited engines in higher efficiency due to elimination of throttling losses at part and idle loads. There is a possibility to use high compression ratios since it is not knock limited, and in significant lower NOx emission (≈90%) and particle matter emission (≈50%), due to much lower combustion temperature and elimination of fuel rich zones. However, there are several disadvantages of the CAI engine that limits its practical application, such as high level of hydrocarbon and carbon monoxide emissions, high peak pressures, high rates of heat release, reduced power per displacement and difficulties in starting and controlling the engine. Controlling the operation over a wide range of loads and speeds is probably the major difficulty facing CAI engines. Controlling is actually two-components as it consists of auto-ignition phasing and controlling the rates of heat release. As CAI combustion is controlled by chemical kinetics of air/fuel mixture, the auto-ignition timing and heat release rate are determined by the charge properties such as temperature, composition and pressure. Therefore, changes in engine operational parameters or in types of fuel, results in changing of the charge properties. Hence, the auto-ignition timing and the rate of heat release. The Thesis investigates a controlled auto-ignition (CAI) combustion in internal combustion engines suitable for transport applications. The CAI engine environment is simulated by using a single-zone, homogeneous reactor model with a time variable volume according to the slider-crank relationship. The model uses detailed chemical kinetics and distributed heat transfer losses according to Woschini's correlation [1]. The fundamentals of chemical kinetics, and their relationship with combustion related problems are presented. The phenomenology and principles of auto-ignition process itself and its characteristics in CAI combustion are explained. The simulation model for representing CAI engine environment is established and calibrated with respect to the experimental data. The influences of fuel composition on the auto-ignition timing and the rate of heat release in a CAI engine are investigated. The effects of engine parameters on CAI combustion in different engine concepts fuelled with various fuels are analysed. The effects of internal gas recirculation (IEGR) in controlling the auto-ignition timing and the heat release rate in a CAI engine fuelled with different fuels are investigated. The effects of variable valve timings strategy on gas exchange process in CAI engine fuelled with commercial gasoline (95RON) are analysed.