One of the most pressing problems nowadays is climate change and global warming. As it name indicates, it is a problem that concerns the whole earth. There is no doubt that the main cause for this to happen is human, and very related to non-renewable carbon-based energy resources. However, technology has evolved, and some alternatives have appeared in the energy conversion sector. Nevertheless, they are relatively young yet. Since the growth in renewable energies technologies wind power and PV are the ones that have taken the lead. Wind power is a relatively mature technology and even if it still has challenges to overcome the horizon is clear. However, in the PV case the technology is more recent. Even if it is true that PV modules have been used in space applications for more than 60 years, large scale production has not begun until last 10 years. This leaves the uncertainty of how will PV plants and modules age. The author will try to analyse the aging of a specific 63 kWp PV plant located in the roof of a building in Gävle, monitoring production and ambient condition data, to estimate the degradation and the new nominal power of the plant. It has been found out that the degradation of the system is not considerable. PV modules and solar inverters were studied, and even if there are more elements in the system, those are the principal ones. PV modules suffered a degradation of less than 5%, while solar inverters’ efficiency dropped from 95,4% to around 93%.

As fossil fuel sources continue to diminish, oil prices continue to increase, and global warming and CO2 emissions keep impacting the environment, it has been necessary to shift energy consumption and generation to a different path. Solar energy has proven to be one of the most promising sources of renewable energy because it is environmentally friendly, available anywhere in the world, and cost competitive. For photovoltaic (PV) system engineers, designing a PV system is not an easy task. Research demonstrates that different PV technologies behave differently under certain conditions; therefore energy production varies not only with capacity of the system but also with the type of module. For years, researchers have also studied how these different technologies perform for long periods of time, when exposed out in the field. In this study, data collected by the Florida Solar Energy Center for periods of over four years was analyzed using two techniques, widely accepted by researchers and industry, to evaluate the long‐term performance of five systems. The performance ratio analysis normalizes system capacity and enables the comparison of performance between multiple systems. In PVUSA Regression analysis, regression coefficients are calculated which correspond to the effect of irradiance, wind speed, and ambient temperature, and these coefficients are then used to calculate power at a predetermined set of conditions. This study allows manufacturers to address the difficulties found on system lifetime when their modules are installed out on the field. Also allows for the further development and improvement of the different PV technologies already commercially available.