Typescript (photocopy). / Digitized by Kansas Correctional Industries

published_or_final_version / Electrical and Electronic Engineering / Doctoral / Doctor of Philosophy

Lin Pui-Yu. / Thesis (M.Phil.)--Chinese University of Hong Kong, 2001. / Includes bibliographical references (leaves 103-105). / Abstracts in English and Chinese. / Acknowledgement / Chapter Chapter 1 --- Introduction --- p.1 / Chapter Chapter 2 --- Nonlinear Phenomenon of Power Amplifier --- p.5 / Chapter 2.1. --- AM-AM and AM-PM Distortion --- p.5 / Chapter 2.2. --- Intermodulation Distortion --- p.7 / Chapter Chapter 3 --- Linearization Techniques --- p.10 / Chapter 3.1. --- Power Backoff --- p.11 / Chapter 3.2. --- Feedback --- p.12 / Chapter 3.3. --- Predistortion --- p.12 / Chapter 3.4. --- Feedforward --- p.14 / Chapter 3.5. --- Other Linearization Techniques --- p.15 / Chapter Chapter 4 --- Analysis of Feedforward Power Amplifier --- p.17 / Chapter 4.1. --- Feedforward Efficiency --- p.18 / Chapter 4.2. --- Design Criteria of the Auxiliary Amplifier --- p.20 / Chapter 4.3. --- Sensitivity Analysis --- p.21 / Chapter 4.3.1. --- Phase and Amplitude Mismatch --- p.22 / Chapter 4.3.2. --- Delay Mismatch --- p.23 / Chapter 4.3.3. --- Combined Effect --- p.25 / Chapter 4.3.4. --- Practical Consideration --- p.27 / Chapter 4.4. --- Other Design Criteria --- p.28 / Chapter Chapter 5 --- Adaptive Control Networks for FFPA --- p.29 / Chapter 5.1. --- Basic Principles of the Adaptive Control Network --- p.30 / Chapter 5.1.1. --- Lookup Table --- p.30 / Chapter 5.1.2. --- Power Minimization Vs. Correlation --- p.31 / Chapter 5.2. --- Analog Vs Digital Implementation of the Adaptive Control Network --- p.34 / Chapter 5.3. --- Techniques for Improving the Convergence Behaviour at the Distortion Cancellation Loop --- p.35 / Chapter 5.4. --- Important Notes on the Control Networks --- p.38 / Chapter Chapter 6 --- Novel Analysis of Adaptive FFPA --- p.40 / Chapter 6.1. --- Gradient algorithm --- p.40 / Chapter 6.2. --- Dual Loop Adaptive FFPA --- p.41 / Chapter 6.2.1. --- System Modeling --- p.42 / Chapter 6.2.2. --- Adaptation Behavior of the Distortion Extraction Loop --- p.44 / Chapter 6.2.3. --- Adaptation Behavior of the Distortion Cancellation Loop --- p.48 / Chapter 6.2.4. --- Accuracy Requirement of the Control Signals --- p.50 / Chapter 6.2.5. --- Effect of Delay Mismatch on the Convergence Accuracy --- p.51 / Chapter 6.2.6. --- Convergence Behaviors for Two Tone Input Signal --- p.52 / Chapter 6.2.6.1. --- Distortion Extraction Loop --- p.53 / Chapter 6.2.6.2. --- Distortion Cancellation Loop --- p.55 / Chapter 6.2.6.3. --- Simulation Results --- p.57 / Chapter 6.2.7. --- Convergence Behaviors for Digital Modulated Test signal --- p.60 / Chapter 6.2.7.1. --- Distortion Extraction Loop --- p.61 / Chapter 6.2.7.2. --- Distortion Cancellation Loop --- p.66 / Chapter 6.2.7.3. --- Simulation Results --- p.68 / Chapter 6.2.8. --- Comparison for the Adaptation Performance with Two Tone and Digital Modulated Test Signal --- p.70 / Chapter 6.3. --- Triple Loop Adaptive FFPA --- p.71 / Chapter 6.3.1. --- Adaptation Performance of the Additional Loop --- p.73 / Chapter 6.3.2. --- Adaptation Performance of the Distortion Cancellation Loop --- p.75 / Chapter 6.3.3. --- Improvement in Bias Error at the Distortion Cancellation Loop --- p.76 / Chapter 6.3.4. --- Effect of Delay Mismatch --- p.77 / Chapter 6.3.5. --- Simulation Results --- p.79 / Chapter Chapter 7 --- Implementation and Measured Performance of Triple Loop Adaptive FFPA --- p.85 / Chapter 7.1. --- Hardware Design --- p.85 / Chapter 7.1.1. --- Vector Modulator --- p.87 / Chapter 7.1.2 --- Complex Correlator --- p.88 / Chapter 7.2. --- Experimental Setup and Measured Results --- p.90 / Chapter Chapter 8 --- Conclusion --- p.95 / Appendix I Matlab Program for Simulation of Dual Loop Adaptive FFPA --- p.97 / Appendix II Matlab Program for Simulation of Triple Loop Adaptive FFPA --- p.100 / Reference --- p.103 / Author's Publication --- p.106

Typescript (photocopy). / Digitized by Kansas Correctional Industries / Department: Electrical and Computer Engineering.

Thesis (Ph. D.)--University of Hong Kong, 2010. / Includes bibliographical references (leaves 138-149). Also available in print.

The objective of this research is to analyze and improve linearity of envelope elimination and restoration (EER) radio frequency (RF) power amplifiers. Envelope elimination and restoration was compared to other efficiency enhancement techniques and determined to likely be the most suitable solution for implementation of multimode, multiband portable RF transmitters. Distortion, stemming from dynamic power-supply modulation of RF transistors in EER RF power amplifiers was identified as one of the key challenges to the development of commercially viable EER transmitters. This dissertation presents a study of phase distortion in RF power amplifiers (PAs) with emphasis on identification of the origins of phase distortion in EER RF power amplifiers. Circuit-level techniques for distortion mitigation are also presented. Memory effects in conventional power amplifiers are investigated through the accurate measurement and analysis of phase asymmetry of out-of-band distortion components. Novel physically-based power amplifier model is developed for attributing measured memory effects to their physical origin. The amount of linearity correction, obtained through pre-distortion for a particular RF power amplifier, is then correlated to the behavior of the memory effects in the corresponding PA. Heterojunction field-effect transistor and heterojunction bipolar transistor amplifiers are used for investigation of voltage-dependent phase distortion in handset EER RF PAs. The distortion is found to stem from vector addition of signals, generated in nonlinear circuit elements of the PA. Specifically, nonlinear base-collector capacitance and downconversion of distortion components from second harmonic frequency are found to be the dominant sources of phase distortion. Shorting of second harmonic is proposed as a way to reduce the distortion contribution of the downconverted signal. Phase distortion is reduced by 50%, however a slight degradation in the amplitude distortion is observed. Push-pull architecture is proposed for EER RF power amplifiers to cancel distortion components, generated in the nonlinear base-collector capacitance. Push-pull implementation enables a 67% reduction in phase distortion, accompanied by a 1-2 dB reduction in amplitude distortion in EER RF power amplifiers. This work, combined with other studies in the field, will help advance the development of multimode, multiband portable RF transmitters, based on the envelope elimination and restoration architecture.

Thesis (Ph. D.)--University of Texas at Austin, 2007. / Vita. Includes bibliographical references.

Kwok Pui-ho. / Thesis (M.Phil.)--Chinese University of Hong Kong, 2000. / Includes bibliographical references (leaves [79]-85). / Abstracts in English and Chinese. / Chapter CHAPTER 1 --- INTRODUCTION --- p.1 / Chapter CHAPTER 2 --- NONLINEAR BEHAVIOR OF RF POWER AMPLIFIERS --- p.5 / Chapter 2.1 --- Single Tone Excitation --- p.6 / Chapter 2.1.1 --- AM-AM Conversion --- p.7 / Chapter 2.1.2 --- AM-PM Conversion --- p.9 / Chapter 2.2 --- Two-Tone Excitation --- p.11 / Chapter 2.2.1 --- Intermodulation Distortion --- p.12 / Chapter 2.3 --- Digitally Modulated Signal Excitation --- p.13 / Chapter 2.3.1 --- Spectral Regeneration --- p.14 / Chapter 2.3.2 --- Adjacent Channel Power Ratio (ACPR) --- p.16 / Chapter CHAPTER 3 --- LINEARIZATION TECHNIQUES --- p.18 / Chapter 3.1 --- pre-distortion --- p.20 / Chapter 3.2 --- Feed-forward Techniques --- p.23 / Chapter 3.3 --- Harmonics Control Techniques --- p.24 / Chapter CHAPTER 4 --- SPECTRAL REGROWTH ANALYSIS USING VOLTERRA SERIES METHOD --- p.26 / Chapter 4.1 --- Introduction To Volterra Series Analysis --- p.27 / Chapter 4.1.1 --- Linear and Nonlinear Systems --- p.27 / Chapter 4.1.2 --- Evaluation of Volterra transfer function --- p.29 / Chapter 4.1.3 --- Volterra Series Analysis of Spectral Regrowth --- p.31 / Chapter 4.2 --- Nonlinear Model of GaAs MESFET Device --- p.33 / Chapter 4.3 --- Evaluation Of Nonlinear Responses --- p.35 / Chapter 4.3.1 --- First-Order Response --- p.36 / Chapter 4.3.2 --- Second-Order Response --- p.38 / Chapter 4.3.3 --- Third-Order Response --- p.39 / Chapter CHAPTER 5 --- EFFECT OF HARMONIC TUNING ON SPECTRAL REGROWTH --- p.42 / Chapter 5.1 --- Simulation of Digitally Modulated Signal --- p.43 / Chapter 5.2 --- Effect of Source Second Harmonic Termination --- p.44 / Chapter CHAPTER 6 --- EXPERIMENTAL VERIFICATION --- p.48 / Chapter 6.1 --- Circuit Design and Construction --- p.49 / Chapter 6.2 --- Setup and Measurement --- p.55 / Chapter 6.3 --- Experimental Results --- p.56 / Chapter 6.3.1 --- Small Signal Measurement --- p.56 / Chapter 6.3.2 --- Single Tone Characterization --- p.57 / Chapter 6.3.3 --- Two-Tone Characterization --- p.59 / Chapter 6.3.4 --- ACPR Characterization --- p.60 / Chapter 6.4 --- Comparison of Measurement and Simulation --- p.66 / Chapter CHAPTER 7 --- NONLINEAR TRANSCONDUCTANCE COEFFICIENTS EXTRACTION --- p.68 / Chapter 7.1 --- Large Signal Model --- p.69 / Chapter 7.2 --- Extraction of Nonlinear Transconductance --- p.71 / Chapter 7.2.1 --- Extraction of g1 --- p.71 / Chapter 7.2.2 --- Extraction of g2 and g3 --- p.72 / Chapter CHAPTER 8 --- CONCLUSION --- p.76 / FUTURE WORK RECOMMENDATION --- p.78 / REFERENCE

The research investigates several critical design issues of continuous-time (CT) [Sigma Delta] modulators. The first is to investigate the sensitivity of CT [Sigma Delta] modulators to high-frequency clock spurs. These spurs down-convert the high-frequency quantization noise, degrading the dynamic range of the modulator. The second is to study the robustness of continuous-time loop filters under large RC product variations. Large RC variations in the CMOS process strongly degrade the performance of continuous-time [Sigma Delta] modulators, and reduce the production yield. The third is to model the harmonic distortion of one-bit continuous-time [Sigma Delta] modulators due to the interaction between the first integrator and the feedback digital-to-analog converter (DAC). A closed-form expression of the 3'rd-order harmonic distortion is derived and verified. Conventional CT [Sigma Delta] modulators employ all active integrators: each integrator needs an active amplifier. The research proposes a 5th-order continuous-time [Sigma Delta] modulator with a hybrid active-passive loop filter consisting of only three amplifiers. The passive integrators save power, and introduce no distortion. The active integrators provide gain and minimize internal noise contributions. A single-bit switched-capacitor DAC is employed as the main feedback DAC for high clock jitter immunity. An additional current steering DAC stabilizes the loop with the advantage of simplicity. To verify the proposed techniques, a prototype continuous-time [Sigma Delta] modulator with 2-MHz signal bandwidth is designed in a 0.25-¹m CMOS technology targeting for GPS or WCDMA applications. The experimental results show that the prototype modulator achieves 68-dB dynamic range over 2-MHz bandwidth with a 150-MHz clock, consuming 1.8 mA from a 1.5-V supply.